نشرة
Rough idle, rolling idle, stall, high idle, or back fire mainly after a cold start. Also hesitation or surge at steady cruise, or malfunction indicator lamp (mil) illuminated condition. *tt *jb
🔔 أنشئ حسابًا مجانيًا لتلقي تنبيهات البريد عن Ford فوكوس (كل الأجيال)
النشرات الفنية (TSB) تعليمات إصلاح يرسلها المصنعون إلى وكلائهم بشأن مشكلات معروفة. ليست استدعاءات سلامة، لكنها كثيرًا ما تؤكد وجود عطل.
Rough idle, rolling idle, stall, high idle, or back fire mainly after a cold start. Also hesitation or surge at steady cruise, or malfunction indicator lamp (mil) illuminated condition. *tt *jb
Some 2016-2017 Ford/Lincoln vehicles SYNC 3 may exhibit an intermittent blank screen. Check for SYNC software update under the OASIS Tab SYNC selection. If update is available refer to WSM, Section 415-00 and update APIM software. During the update process the SYNC status bar shows Updating System Software for approximately 30 minutes. After Installation Complete pop-up appears, remove USB flash drive and install into IDS tool to update Ford database. Perform a complete ignition cycle by turning the key off for 5 minutes which is critical for a successful installation. If no updates are available or blank screen is present after an update refer to WSM, Section 415-00 for diagnosis or SYNC 3 intermittent blank screen GSB for tips. For claiming, use causal part 14G371 and applicable labor operations in section 10 of the SLTS manual.
Some 2016 focus vehicles may not successfully complete reprogramming or programmable module installation (pmi) of the bcm. Make certain the integrated diagnostic system (ids) is at release 103.03 or higher before attempting bcm programming.
Ford: See document search button for owner letter. During testing, active grille shutter (ags) wire harness electrical terminals was damaged, and causes engine temperature to rise, if louvers are closed and open circuit occurs, whereby warning light illuminates, chime will sound and high engine temperature, stop safely message is displayed. Model 2012 focus. *pe
Some vehicles may exhibit instrument cluster warning lamps that are inoperative. *tt
Some models may exhibit instrument cluster warning lamps that are inoperative. *tt
قد تعاني بعض مركبات Focus لعام 2018 وFiesta لعام 2019 وTransit لعامي 2019-2020 وTransit Connect لعامي 2019-2020 من مشكلة يبحث فيها الراديو بشكل عشوائي عبر محطات FM عند توصيل جهاز بلوتوث وبث الصوت منه. يعمل فريق الهندسة حاليًا على إيجاد حل لهذه المشكلة. أبلغ العميل بأن شركة Ford تطور تحديثًا برمجيًا من المتوقع صدوره في مايو 2021. وفي الوقت نفسه، أخبره بأن الراديو سيظل يعمل دون بلوتوث، وحدد موعدًا للمتابعة معه في أواخر فبراير. وبمجرد توفر التحديث، اتصل بالعميل وأكد أن موعد الخدمة سيتم كما هو مقرر. راقب نظام OASIS للاطلاع على أي معلومات إضافية، وحدد مواعيد الخدمة للعملاء بمجرد توفر الإصلاح.
## ملخص قد تُظهر بعض مركبات Ford و Lincoln للموديلات 2018-2020 المزودة بوحدة التحكم في الإرسال (TCU) ونقطة اتصال Wi-Fi، رسالة "ميزة نقطة اتصال المركبة غير مفعّلة على هذه المركبة" عند محاولة الدخول إلى قائمة نقطة الاتصال. وعند استخدام تطبيق FordPass/Lincoln Way، قد يتلقى العميل رسالة تفيد بأن Wi-Fi معطّل في هذه المركبة. تحقق من مواصفات المركبة أو معلومات بناء المركبة للحصول على رمز mfal في موقع PTS (Detailed Vehicle Specifications). إذا كان mfal = WAFAC أو WAFAB، فلا تستبدل وحدة TCU، إذ إن الهندسة تحقق حاليًا في هذه الحالة. أبلغ العملاء بأن Ford تعمل على تطوير تحديث برمجي من المتوقع إصداره في أوائل مارس. وفي الوقت الحالي، أخبر العميل بأنه يمكنه مواصلة قيادة المركبة، وحدد معه موعد متابعة في أوائل مارس. راقب OASIS للاطلاع على التحديثات.
Some 2018 Focus, 2019 Fiesta, 2019-2020 Transit, 2019-2020 Transit Connect, and 2020 EcoSport vehicles may exhibit a concern where the radio randomly seeks through FM stations when a Bluetooth device is connected and streaming audio. Engineering is currently working on a solution for this condition. Inform customers that Ford is developing a software fix that is expected in February 2021. In the interim, let the customer know that the radio will still function without Bluetooth and schedule a follow-up appointment with the customer for late February. Once the update becomes available, contact the customer and confirm the service appointment is going forward. Monitor OASIS for additional information and schedule service appointments for customers once the repair becomes available.
Some 2018-2020 Ford and Lincoln vehicles equipped with TCU and WiFi Hotspot, May display Vehicle Hotspot feature not enabled on this vehicle when attempting to enter the Hotspot menu. When using the FordPass/Lincoln Way application, the customer may receive a message saying Wi-Fi has been disabled from this vehicle. Check the vehicle specifications or vehicle build information for the mfal code. If mfal = WAFAC or WAFAB do not replace the TCU, engineering is currently investigating this condition. Inform customers Ford is developing a software fix that is expected in early January. In the interim, let the customer know they can continue to drive the vehicle and schedule a follow-up appointment with the customer for early January. Once the update becomes available, contact the customer and confirm the service appointment is going forward. Monitor OASIS for updates.
In some of the affected vehicles, the front control/display interface module (FCDIM) may have been unintentionally programmed for the European market instead of the North American market
Some 2013-2016 Escape and 2016 Focus, Transit and Transit Connect vehicles equipped with a front control display interface module (FCDIM) may exhibit the inability to store AM/FM presets, select AM/FM presets and/or erratic preset button operation. Reprogram the front control display interface module (FCDIM) using Integrated Diagnostic System (IDS) or Ford J2534 Diagnostic Software (FJDS) release 109.02 or higher. Make sure you are connected to the internet when entering module programming to obtain the latest updates. Calibration files may also be obtained at www.motorcraftservice.com. For claiming, use causal part 18C869 and applicable labor operations in Section 10 of the Service Labor Time Standards(SLTS) manual.
Some 2017 Escape and Focus vehicles may experience a message during key programing that states "Back End Server Failed". To correct this condition, reprogram the Remote Frequency Actuator (RFA) module to the latest level using Integrated Diagnostic System (IDS) or Ford J2534 Diagnostic Software (FJDS) release 108.06 or higher. For claiming, use causal part 19G481 and applicable labor operations in section 10 of the SLTS manual.
Some 2016 Escape and Focus vehicles equipped with a front control display interface module (FCDIM) may exhibit the inability to store AM/FM presets and/or preset buttons work erratically. Engineering is currently investigating this concern. Until a new service procedure and/or parts are available use the pre-set buttons in the following manner. To store/program a new station for a pre-set location, press and hold desired button for 3 seconds. To select a previously programmed pre-set location, perform a quick press and release of the button. Refer to Workshop Manual (WSM) Section, 415-00 for normal diagnostics. Continue to monitor OASIS for updates.
Some 2016 c-max energi/focus electric and 2016-2017 fusion energi vehicles built on or before 10-jul-2016, may exhibit a 12-volt and/or high voltage battery with a low state of charge and/or an intermittent battery draw. Reprogram the telematics control unit (tcu) to the latest level using ids release 104.01 or higher. Make sure you are connected to the internet when entering module programming to obtain the latest updates. Calibration files may also be obtained at www.Motorcraftservice.Com. For claiming, use causal part 14g229 and applicable labor operations in section 10 of the service labor time standards (slts) manual.
Some 2016 focus battery electric vehicle (bev) and c-max energi plug-in hybrid vehicles (phev) equipped with sync3 may be unable to change the settings for the charge port light ring under vehicle settings function. This may be due to the gateway module (gwm) configuration, defaulting to always on. Reprogram the gwm to the latest level using ids release 103.05a or higher. Make sure you are connected to the internet when entering module programming to obtain the latest updates. For claiming, use causal part 14g229 and applicable labor operations in section 10 of the service labor time standards (slts) manual.
Some 2016 focus, c-max, fiesta, expedition, and navigator vehicles equipped with sync 3 may exhibit a condition in which the sirius satellite channel guide category buttons may not respond when selected and a loading message is displayed continuously. To correct this condition reprogram the audio control module (acm) with latest calibration using ids release 101.05 or higher. Make sure you are connected to the internet when entering module programming to obtain the latest updates. Calibration files may also be obtained at www.Motorcraftservice.Com. Use causal part 19c107 and refer to section 10 of the slts manual for applicable labor operations. The sync version can be determined via oasis.
Some 2016 escape/mkc/fiesta/f150/expedition/navigator/mustang /transit/focus/c-max/mkx/taurus/mks/flex/mkt/edge and 2017 escape/explorer/mkc/fusion and mkz vehicles equipped with sync 3 might exhibit a blank screen or other various sync symptoms only when the vehicle is in transport mode. Engineering is aware of this possibility and it is considered normal due to the power saving features enabled while in transportation mode. It is beneficial to extended battery life to keep the vehicle in transport mode until the vehicle is prepped for sale. If the vehicle should exhibit a blank screen or other sync symptoms after it has been taken out of transport mode, refer to workshop manual, section 415-00 for normal diagnosis. The sync version can be confirmed via oasis.
Sync 3 accessory protocol interface module (apim) dtcs u3000 or b108e or u1a00
Ford/lincoln: Global positioning satellite module (gpsm) needs reprogramming to latest calibration due to voice prompt failing to locating vehicle, screen message indicator fault of navigation, instead of current location indicates previous location. Model 2014 ford, lincoln. *pe
Ford: Clock fails to be set unless front control display interface module fcdim) has date set first and then time. Model 2013-2015 c-max, 2014-2015 escape, 2014 focus. *pe
Ford: In battery junction box, is a damaged or an improperly seated connector, causing check engine light to illuminate, with diagnostic trouble codes (dtcs) p2122, p2127 and/or 02138. Model 2012-2013 focus, 2013 escape. *pe
Ford: Some vehicles may experience instrument panel cluster (ipc) message center outside air temperature (oat) display defaulting to c and additionally, the ability to switch display back to f is disabled. Model 2013 focus s. *pe
Ford: On some vehicles, when diagnosing dtcs p26db, p26dd, p26de, check workshop manual regarding testing intake air distribution and filtering, for engine sound symposer valve wiring. Models 2013 focus st. *pe
Ford/lincoln: See document search button for owner letter. Information regarding improve overall software system functionality upgrade on voice recognition, response to touch, simplify screens for easy use, and screen refresh rates. *pe updated 4/5/13. *pe
المصادر: NHTSA (الولايات المتحدة، ملك عام)، وزارة النقل الكندية (رخصة الحكومة المفتوحة – كندا)، DVSA (المملكة المتحدة، رخصة الحكومة المفتوحة 3.0)، RappelConso وSafety Gate الأوروبي (فرنسا، الرخصة المفتوحة 2.0)، ووزارة MLIT اليابانية (رخصة البيانات العامة 1.0)، ووزارة MOLIT الكورية (car.go.kr).