قراءة مجانية · حساب مجاني للمساهمةخليفة Anticars (2000)
تسجيل الدخولإنشاء حساب
NANHTSA · نشرة المصنع11038748

النشرات الفنية

معروض باللغة الأصلية (الإنجليزية) · الترجمة قيد الانتظار

Not applicable to vehicles built for US market. Corner Radar Dynamic Alignment Calibration Issue IMPORTANT! **The DTC listed below may set when the Radar Dynamic Alignment procedure is SYMPTOM: unsuccessful. The procedure should only be started when a radar is replaced or when bumpers are removed/reinstalled. Before performing the procedure, make sure the reported problem actually concerns the radars. If any Diagnostic Trouble Codes (DTCs) or conditions/symptoms different from those described below are detected, record them in the repair order and carry out the necessary actions before continuing with the additional instructions in this bulletin.** **Technicians must experience a malfunction of ADAS systems and the vehicle must exhibit/set the following DTC on one or more corner radars:** B2EF9-78 - Alignment Of The Corner Radar Completed With Failure : Alignment Not Carried Out. Technicians will also experience the following: Unable to successfully perform the corner radar dynamic alignment procedure. This bulletin involves reprogramming the corner radars with the latest software then performing the Sensor/ Proximity Radar Calibration procedure

يشمل: Jeep Compass II (سنوات الطراز 2026)

الإشعار الرسمي ↗

المصادر: NHTSA (الولايات المتحدة، ملك عام)، وزارة النقل الكندية (رخصة الحكومة المفتوحة – كندا)، DVSA (المملكة المتحدة، رخصة الحكومة المفتوحة 3.0)، RappelConso وSafety Gate الأوروبي (فرنسا، الرخصة المفتوحة 2.0)، ووزارة MLIT اليابانية (رخصة البيانات العامة 1.0)، ووزارة MOLIT الكورية (car.go.kr).