قراءة مجانية · حساب مجاني للمساهمةخليفة Anticars (2000)
تسجيل الدخولإنشاء حساب
NANHTSA · الولايات المتحدة03V52700011 ديسمبر 2003

Steering:Rack and pinion

معروض باللغة الأصلية (الإنجليزية) · الترجمة قيد الانتظار

Certain passenger vehicles have lower pinion bearings in the power rack and pinion assembly in which the retainer tabs were not crimped properly. These retainers could fail and permit the ball bearings to escape.

الخطر: If this occurs, the pinion shaft can be forced upward during left turns and back down as the steering wheel is moved back and to the right. If the pinion shaft moves further, the driver will need to exert more effort to turn the steering wheel, similar to a vehicle without power assisted steering. If the pinion shaft moves even further, the driver will require much higher effort to turn left and may not be able to turn the wheel as much as intended. With the maximum pinion shaft movement, which requires internal gear component damage, the driver can encounter high resistance to turning left, followed by unintended power assist to the right. In any of these conditions, a crash could occur.

الحل: Dealers will install a new lower pinion bearing unless inspect of the existing bearing indicates that replacement of the gear assembly is necessary. Owner notification began on february 5, 2004. Owners should contact buick at 1-866-608-8080; chevrolet at 1-800-630-2438; oldsmobile at 1-800-630-6537; or pontiac at 1-800-620-7668.

يشمل: Buick Regal IV (سنوات الطراز 1996–1998) · Chevrolet Lumina II (سنوات الطراز 1997–1998) · Chevrolet Malibu V (سنوات الطراز 1997–1998) · Chevrolet Monte Carlo V (سنوات الطراز 1997–1998) · Oldsmobile Cutlass Supreme V (سنوات الطراز 1996–1997) · Oldsmobile Intrigue (سنوات الطراز 1998) · Pontiac Grand Prix VII (سنوات الطراز 1996)

الإشعار الرسمي ↗

المصادر: NHTSA (الولايات المتحدة، ملك عام)، وزارة النقل الكندية (رخصة الحكومة المفتوحة – كندا)، DVSA (المملكة المتحدة، رخصة الحكومة المفتوحة 3.0)، RappelConso وSafety Gate الأوروبي (فرنسا، الرخصة المفتوحة 2.0).