قراءة مجانية · حساب مجاني للمساهمةخليفة Anticars (2000)
تسجيل الدخولإنشاء حساب
NANHTSA · نشرة المصنع10093695

النشرات الفنية

معروض باللغة الأصلية (الإنجليزية) · الترجمة قيد الانتظار

"tt: Tms has discovered the current engine active test control the injection mode is not operating as desired when controlling the direct injectors manually on 2gr-fks or 8ar-fts engines. When direct injection is started and then stopped using the active test, current ecu logic does not turn off the direct injectors and can cause dtcs p017200, p017500 and p0160300. In order to avoid this condition, technicians should raise engine rpm when changing from direct injection active test to port injection active test. Use the recommended procedure below to avoid this concern while testing injection mode of 2gr-fks or 8ar-fts equipped vehicles. Note: If the active test is used multiple times without using this procedure to raise engine rpm, it may be necessary to reset learning values for fuel trim and air to fuel ratio before returning vehicle to customer."

يشمل: Lexus IS III (سنوات الطراز 2016) · Lexus RC (سنوات الطراز 2016) · Lexus RX IV (سنوات الطراز 2016) · Lexus GS (L10) (سنوات الطراز 2016)

الإشعار الرسمي ↗

المصادر: NHTSA (الولايات المتحدة، ملك عام)، وزارة النقل الكندية (رخصة الحكومة المفتوحة – كندا)، DVSA (المملكة المتحدة، رخصة الحكومة المفتوحة 3.0)، RappelConso وSafety Gate الأوروبي (فرنسا، الرخصة المفتوحة 2.0)، ووزارة MLIT اليابانية (رخصة البيانات العامة 1.0)، ووزارة MOLIT الكورية (car.go.kr).