Due to insufficient durability, the Exhaust Gas Recirculation (EGR) cooler may develop an internal coolant leak which could create smouldering deposits inside the EGR cooler and the intake manifold.This may result in localised thermal damage in the intake system, which might lead to engine power reduction and to increased risk of fire.
Safety Gate · الاتحاد الأوروبي30 مارس 2021A12/00444/21سنوات الطراز 2015–2018معروض باللغة الأصلية (الإنجليزية) · الترجمة قيد الانتظارعرض التفاصيل →
بسبب احتراق الزيت والضغط العالي للاتصال، قد تنخفض قوة سلسلة عمود الكامات بمقدار 7 ملم. قد يؤدي ذلك إلى انقطاع سلسلة عمود الكامات، مما يؤدي إلى فشل المحرك. وهذا قد يؤدي إلى فقدان التحكم في المركبة وزيادة خطر الحوادث والإصابات.
Safety Gate · الاتحاد الأوروبي · RappelConso · فرنسا10 أغسطس 2026sr/02656/25سنوات الطراز 2018–2019ترجمة آلية · اللغة الأصلية: الفرنسيةعرض التفاصيل →
Under certain conditions condense water in the intake air can corrode the needle bearing housing. Due to corrosion of the bearing housing the sealing between intake air and the electrical actuator circuit of the throttle body might not be water tight anymore. In the condition that water enters in the throttle body actuator circuit the water might cause a throttle body position misreading or short circuit inside the throttle body electrical actuation mechanism. This might trigger the engine to stall while driving.
DVSA · المملكة المتحدة7 مارس 2016R/2016/013سنوات الطراز 2014–2015معروض باللغة الأصلية (الإنجليزية) · الترجمة قيد الانتظارعرض التفاصيل →
The resin moulding around the fuel filter water sensor is inadequate. In low temperature environments this can affect the O ring and allow fuel to seep into the sensor. Consequently fuel can then leak out of the sensor through it's breather hole. Additionally maintenance schedules are incomplete.
DVSA · المملكة المتحدة8 سبتمبر 2014R/2014/070سنوات الطراز 2014معروض باللغة الأصلية (الإنجليزية) · الترجمة قيد الانتظارعرض التفاصيل →
It has been identified that on affected vehicles condensation resulting from cold-weather use of the heater or other causes may form on the worn surface of a component within the throttle pedal assembly known as the friction device. If this occurs there is a possibility that in the worst case the accelerator pedal may return slowly or does not return to the engine idle position.
DVSA · المملكة المتحدة6 فبراير 2010R/2010/010سنوات الطراز 2009–2010معروض باللغة الأصلية (الإنجليزية) · الترجمة قيد الانتظارعرض التفاصيل →
المصادر: NHTSA (الولايات المتحدة، ملك عام)، وزارة النقل الكندية (رخصة الحكومة المفتوحة – كندا)، DVSA (المملكة المتحدة، رخصة الحكومة المفتوحة 3.0)، RappelConso وSafety Gate الأوروبي (فرنسا، الرخصة المفتوحة 2.0)، ووزارة MLIT اليابانية (رخصة البيانات العامة 1.0)، ووزارة MOLIT الكورية (car.go.kr).