Frei lesbar · kostenloses Konto zum MitmachenNachfolger von Anticars (2000)

Audi RS7

2013– · 1 generationen · 2 dokumentierte Mängel · 2 Märkte
Generationen
Alle GenerationenRS72013–245729

Technische Bulletins (TSB) sind Reparaturanweisungen, die Hersteller ihren Händlern zu bekannten Problemen schicken. Sie sind keine Sicherheitsrückrufe, bestätigen aber oft einen Mangel.

SchweregradAlleMittelGering
Modelljahr
MarktAlleNA
BulletinMittelMotorNA

Bulletin

This bulletin provides informaiton when there is a leak on the oil hole between the planetary and the transfer box.

NHTSA · Herstellerbulletin11034705Modelljahre 2016Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
BulletinMittelMotorNA

Bulletin

This TSB provides information when thee is an oil leak from, or near the oil filter housing.

NHTSA · Herstellerbulletin11021471Modelljahre 2021Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
BulletinMittelMotorNA

Bulletin

A small amount of dry or crusted coolant is seen on the coolant pump housing (Figure 1, Figure 2, and Figure 3). The coolant level warning is not on. A minor coolant leak is possible during the break-in phase of the coolant seal on the coolant pump. The dry coolant marks are normal.

NHTSA · Herstellerbulletin10216674Modelljahre 2014Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
BulletinMittelMotorNA

Bulletin

This bulletin contains repair instructions for when there is an oil leak from the rear of the vehicle and the sealing caps are missing from the pressure limiting valves.

NHTSA · Herstellerbulletin10210738Modelljahre 2021Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
BulletinMittelMotorNA

Bulletin

This bulletin describes the repair procedure to address an internal defect in the EVAP leak detection pump causing false leak detection.

NHTSA · Herstellerbulletin10210233Modelljahre 2021Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
BulletinMittelMotorNA

Bulletin

This bulletin describes the repair procedure to address an internal defect in the EVAP leak detection pump causing false leak detection.

NHTSA · Herstellerbulletin10206879Modelljahre 2021Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
BulletinMittelMotorNA

Bulletin

There is an internal defect in the EVAP leak detection pump causing false leak detection.

NHTSA · Herstellerbulletin10205901Modelljahre 2021Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
BulletinMittelMotorNA

Bulletin

This bulletin contains repair instructions for when there is an oil leak from the rear of the vehicle and the sealing caps are missing from the pressure limiting valves.

NHTSA · Herstellerbulletin10200702Modelljahre 2020–2021Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
BulletinMittelMotorNA

Bulletin

This bulletin contains instructions for using the UV additive to find engine oil leaks.

NHTSA · Herstellerbulletin10186945Modelljahre 2020Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
BulletinMittelMotorNA

Bulletin

A small amount of dry or crusted coolant is seen on the coolant pump housing. The coolant level warning is not on. A minor coolant leak is possible during the break-in phase of the coolant seal on the coolant pump. The dry coolant marks are normal.

NHTSA · Herstellerbulletin10124868Modelljahre 2014Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
BulletinMittelMotorNA

Bulletin

Supersedes Technical Service Bulletin Group 10 number 10-02 dated September 14, 2010. Prior to engine replacement, any debris lodged in transferred assemblies must be removed. If the vehicle's engine experienced a serious mechanical problem, it is possible that small pieces of metal debris resulting from the mechanical problem may have become deposited in the intake manifold, air intake hoses, exhaust manifolds, exhaust down-pipes, turbocharger, supercharger, and/or intercooler. If these pieces are not removed prior to the installation and operation of the replacement engine, the pieces may be drawn into the combustion chamber, which can cause a knocking noise and subsequent serious engine damage.

NHTSA · Herstellerbulletin10121324Modelljahre 2014Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
BulletinGeringMotorNA

Bulletin

This bulleti provides information when the fuel pressure is outside of tolerance, MIL is on, DTC P310B00.

NHTSA · Herstellerbulletin11026291Modelljahre 2014Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
BulletinGeringMotorNA

Bulletin

Although the correct amount of oil was added to the engine during an oil change service, a check of the oil level shows that the oil level is not okay.

NHTSA · Herstellerbulletin10228289Modelljahre 2014Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
BulletinGeringMotorNA

Bulletin

Although the correct amount of oil was added to the engine during an oil change service, a check of the oil level shows that the oil level is not okay.

NHTSA · Herstellerbulletin10224968Modelljahre 2014Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
BulletinGeringMotorNA

Bulletin

This bulletin advises to replace the EVAP LD Pump if DTC P044200 or DTC P045600 are present under specific circumstances.

NHTSA · Herstellerbulletin10220368Modelljahre 2021Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
BulletinGeringMotorNA

Bulletin

Although the correct amount of oil was added to the engine during an oil change service, a check of the oil level shows that the oil level is not okay.

NHTSA · Herstellerbulletin10221941Modelljahre 2014Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
BulletinGeringMotorNA

Bulletin

A check with the engine oil service dipstick T40178 is necessary, but the adjustment values for the dipstick are not available in the Elsa repair manual. Because of a system change, the adjustment values for the service dipstick T40178 were removed from the repair manual.

NHTSA · Herstellerbulletin10216652Modelljahre 2014Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
BulletinGeringMotorNA

Bulletin

Engine oils that meet Audi Oil Quality Standards.

NHTSA · Herstellerbulletin10216682Modelljahre 2014Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
BulletinGeringMotorNA

Bulletin

The crankcase breather is only connected to the bank 2 turbocharger inlet. Blow-by gases from the crankcase breather discolor the pipe (Figure 1). This is a normal condition.

NHTSA · Herstellerbulletin10216704Modelljahre 2013Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
BulletinGeringMotorNA

Bulletin

A highly sporadic startup timing issue can cause a message "CNG inspection Due! CNG Mode not available. Please contact workshop". This is a normal condition which can be resolved by recycling the ignition and repairs are not needed.

NHTSA · Herstellerbulletin10214760Modelljahre 2022Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
BulletinGeringMotorNA

Bulletin

This bulletin advises how to identify and repair instances where a vehicle may stops due to a lack of fuel while the fuel gauge shows 1/4 tank or more of fuel.

NHTSA · Herstellerbulletin10214456Modelljahre 2021Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
BulletinGeringMotorNA

Bulletin

Engine Intake & Exhaust Valve Springs

NHTSA · Herstellerbulletin10211918Modelljahre 2022Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
BulletinGeringMotorNA

Bulletin

Engine Intake & Exhaust Valve Springs

NHTSA · Herstellerbulletin10211917Modelljahre 2022Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
BulletinGeringMotorNA

Bulletin

A highly sporadic startup timing issue can cause a message "CNG inspection Due! CNG Mode not available. Please contact workshop". This is a normal condition which can be resolved by recycling the ignition and repairs are not needed.

NHTSA · Herstellerbulletin10212939Modelljahre 2022Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
BulletinGeringMotorNA

Bulletin

This bulletin contains repair instructions from the exhaust system at idle speed DTCs P047600, P048C00, P04A000, or P301B00 are stored in the ECM.

NHTSA · Herstellerbulletin10209104Modelljahre 2021Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
Ältere →

Quellen: NHTSA (USA, gemeinfrei), Transport Canada (Open Government Licence – Canada), DVSA (Vereinigtes Königreich, Open Government Licence v3.0), RappelConso und EU-Safety-Gate (Frankreich, Licence Ouverte 2.0), MLIT (Japan, Public Data License 1.0) und MOLIT (Südkorea, car.go.kr).