Frei lesbar · kostenloses Konto zum MitmachenNachfolger von Anticars (2000)

BMW M8

2019–2025 · 0 dokumentierte Mängel · 3 Märkte

Technische Bulletins (TSB) sind Reparaturanweisungen, die Hersteller ihren Händlern zu bekannten Problemen schicken. Sie sind keine Sicherheitsrückrufe, bestätigen aber oft einen Mangel.

SchweregradAlleMittelGering
Modelljahr
BulletinMittelInnenraumNA

Bulletin

FAULT 930C1E IS FOUND IN THE ACSM: Vehicle comes into the workshop with the following illuminated: Check Engine Light DSC warning lamp Air bag warning lamps During diagnosis the following fault code is found stored in the ASCM (Advanced Crash Safety Module): 930C1E internal ECU error If the fault is cleared it returns immediately. The root cause is under investigation.

NHTSA · Herstellerbulletin10174029Modelljahre 2019–2020Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
BulletinMittelInnenraumNA

Bulletin

FAULT 930C1E IS FOUND IN THE ACSM: Vehicle comes into the workshop with the following illuminated: Check Engine Light DSC warning lamp Air bag warning lamps During diagnosis the following fault code is found stored in the ASCM (Advanced Crash Safety Module): 930C1E internal ECU error If the fault is cleared it returns immediately. The root cause is under investigation.

NHTSA · Herstellerbulletin10171496Modelljahre 2019–2020Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
BulletinGeringInnenraumNA

Bulletin

CLICKING NOISE FROM REAR FOOTWELL AREA WHEN MOVING SEAT(S): A clicking noise is heard from the rear footwell area when moving the seat. The clicking noise can occur under either the driver's seat and/or the passenger seat.

NHTSA · Herstellerbulletin10190854Modelljahre 2020Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
BulletinGeringInnenraumNA

Bulletin

SEAT HEATING NOT ACTIVATED WHEN ENGINE IS STARTED USING REMOTE STARTING SYSTEM: When preheating/precooling the vehicle via the remote starting system (Remote Engine Start), the seat heating on the driver's side is not activated.

NHTSA · Herstellerbulletin10182915Modelljahre 2019–2020Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
BulletinGeringInnenraumNA

Bulletin

CC MESSAGE "FAILURE OF HEAD RESTRAINT ADJUSTMENT ON PASSENGER'S SIDE": Customer states he/she has received a sporadic Check Control message (CCM) "Failure of head restraint adjustment on passenger's side". This is CCM ID-2184. This message appears when the customer folds down the front passenger seat and drives off. The front passenger seat is unoccupied. The CCM (ID-2184)- Appears after 60 seconds States that the head restraint is faulty and that the customer could injure themselves Recommends visiting a workshop Software in the seat module.

NHTSA · Herstellerbulletin10182916Modelljahre 2019–2020Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
BulletinGeringInnenraumNA

Bulletin

SEAT HEATING NOT ACTIVATED WHEN ENGINE IS STARTED USING REMOTE STARTING SYSTEM: When preheating/precooling the vehicle via the remote starting system (Remote Engine Start), the seat heating on the driver's side is not activated.

NHTSA · Herstellerbulletin10182616Modelljahre 2019–2020Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
BulletinGeringInnenraumNA

Bulletin

CC MESSAGE "FAILURE OF HEAD RESTRAINT ADJUSTMENT ON PASSENGER'S SIDE": Customer states he/she has received a sporadic Check Control message (CCM) "Failure of head restraint adjustment on passenger's side". This is CCM ID-2184. This message appears when the customer folds down the front passenger seat and drives off. The front passenger seat is unoccupied. The CCM (ID-2184)- Appears after 60 seconds States that the head restraint is faulty and that the customer could injure themselves Recommends visiting a workshop Software in the seat module.

NHTSA · Herstellerbulletin10182617Modelljahre 2019–2020Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
BulletinGeringInnenraumNA

Bulletin

NEW ECU VALIDATION NEEDED AFTER REPLACING CERTAIN CONTROL MODULES: With introduction of the new Headunit HU-H3 (MGU Media Graphics Unit), there is a new protection mechanism against tampering. If one or more of the following components needs to be replaced, the secure connection between them must be re-established: MGU TCB Telematic Communication Box (ATM-02) RSE Rear Seat Entertainment and/or KOMBISP18 instrument cluster Prior to re-establishing this connection, an electronic certificate must be created in the BMW backend for importing into the Vehicle. After the replacement of one of the mentioned Modules, the Control Module needs a valid certificate for it to communicate with the other Modules.

NHTSA · Herstellerbulletin10179748Modelljahre 2019–2020Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
BulletinGeringInnenraumNA

Bulletin

JINGLING NOISE HEARD FROM PASSENGER B-PILLAR WHEN DRIVING ON ROUGH ROADS. A "jingling" noise can be heard coming from the area of the passenger B-pillar when driving on rough roads. On uneven road surfaces the passenger safety belt (aka "seat belt") inertia reel can be vibrated in its natural frequency range causing the jingling noise.

NHTSA · Herstellerbulletin10172509Modelljahre 2019–2020Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →

Quellen: NHTSA (USA, gemeinfrei), Transport Canada (Open Government Licence – Canada), DVSA (Vereinigtes Königreich, Open Government Licence v3.0), RappelConso und EU-Safety-Gate (Frankreich, Licence Ouverte 2.0), MLIT (Japan, Public Data License 1.0) und MOLIT (Südkorea, car.go.kr).