Technische Bulletins (TSB) sind Reparaturanweisungen, die Hersteller ihren Händlern zu bekannten Problemen schicken. Sie sind keine Sicherheitsrückrufe, bestätigen aber oft einen Mangel.
Due to an implementation error in various OBD diagnostics in the vehicle's control units, in very rare cases itmay happen that stored fault memory codes (DTCs) and the MIL (warning light) are not automaticallydeleted even though the underlying malfunction has already been rectified. This does not comply with the statutory OBD specifications.
When navigation is selected, only the start animation with the text Starting navigation system... isdisplayed. The Navigation application does not start. This only applies to vehicles where Navigation hasbeen enabled and has been verified to work previously.
There is a jerking or shuddering during either or both of the following: Cornering or accelerating from low speeds Driving with low to medium loads There are no warning lights or Check Control messages.
Due to an installation error, the crankshaft sensor connector may not have been properly locked. In very rare cases, the plug connection may become disconnected. If no signal is sent by the crankshaftsensor, the engine will switch to emergency operation and a Check Control message will occur.
There is a jerking or shuddering during either or both of the following: Cornering or accelerating from low speeds Driving with low to medium loads There are no warning lights or Check Control messages.
Please have the starter motor checked and, if necessary, replaced in the vehicles concerned (according tothe vehicle identification number selection) if possible before vehicle delivery. If vehicles have already been delivered, please have the measure carried out the next time the vehiclesenter the workshop. A bolting fault on the long bolt screws can cause the magnets in the starter motor to twist. As a result, thepower of the starter motor decreases. As a result, the engine does not start.
There is a jerking or shuddering during either or both of the following: Cornering or accelerating from low speeds Driving with low to medium loads There are no warning lights or Check Control messages.
There is a jerking or shuddering during either or both of the following: Cornering or accelerating from low speeds Driving with low to medium loads There are no warning lights or Check Control messages.
BMW Remote Software Upgrade (RSU) is not possible. The Remote Software Upgrade menu shows thefollowing text: A remote software upgrade and the activation of functions are not possible. Please contact your servicepartner to restore functionality. Additionally, certain purchased BMW ConnectedDrive Upgrades that require RSU for installation cannot be activated. After the purchase, the status of the upgrade displayed the CID remains In Activation.
Low Washer Fluid Warning Light is illuminated when the Washer Fluid Tank is Full : The low washer fluid warning is illuminated even though the washer fluid reservoir is full. There are no faults stored in the system for the washer fluid level switch. A non-approved washer fluid was used that is silicone-based. Silicone-based fluids are not compatible with the contactless capacitive level sensor. Fluids that contain a silicone additive are normally colored other than blue.
HU-H3 MGU HEAD UNIT DOES NOT START CID REMAINS BLACK: If the ignition is briefly switched off and without the vehicle entering sleep mode the MGU (Media Graphics Unit) head unit does not start The CID display remains black.
ERRONEOUS FAULT 1F2505 IS STORED IN THE DME This Service Information bulletin replaces SI B12 30 18 dated November 2018. This fault does not cause any drivability complaints or engine warning lamps.
SERVICE ACTION: N63M ENGINES - CHECK AND REPLACE THE FRESH AIR INTAKE DUCT. The incorrect crankcase ventilation non return valves may have been installed in the vehicle. The engine malfunction indicator may be illuminated with FC 160509 pressure sensor crankcase signal: pressure implausible stored in the DME.
The Low Washer Fluid Warning Light is illuminated when the Washer Fluid Tank is Full This Service Information bulletin supersedes SI B61 23 15 dated April 2016.
SERVICE ACTION: N63M ENGINES - CHECK AND REPLACE THE FRESH AIR INTAKE DUCT. The incorrect crankcase ventilation non return valves may have been installed in the vehicle. The engine malfunction indicator may be illuminated with FC 160509 pressure sensor crankcase signal: pressure implausible stored in the DME.
The Low Washer Fluid Warning Light is illuminated when the Washer Fluid Tank is Full This Service Information bulletin supersedes SI B61 23 15 dated April 2016.
In the event of an accident, the two-battery Dual Storage System (DSS) is disconnected from the electricalsystem via an internal relay. In some cases, the relay is stuck closed, and a fault is set. In these circumstances: A crash shutdown of the DSS does not occur The power distribution box is supplied with power until the DSS is fully discharged
Nach der Programmierung des Fahrzeugs über ISTA/RSUto I-Level 26-03-5xx kann der Kunde berichten, dass einige der Innenumgebungsbeleuchtungsstreifen (Pfeile) nach einem tiefen Schlafzyklus sporadisch ausfallen. Dieses Problem ist vorübergehend und die Innenumgebungsbeleuchtung wird nach dem Verriegeln/Entriegeln des Fahrzeugs oder einer Änderung der Farbauswahl von selbst wiederhergestellt.
Potential customer complaints with no fault codes stored / No MIL displayed. 1. Rough idle after idling for a longer period of time 2. Vehicle feels like it is misfiring at idle The automatic Start/Stop function is deactivated. The vehicle is stopped and the engine runs at idle speed. After prolonged idle operation (approximately 30 to 50 seconds), a slight jolt or slight change in idlespeed may be noticeable. There are no relevant errors in the DME fault code memory. No mixture control error, no misfiring, no error relating to a relevant component of the drive system. Motor vehicles affected: 1. Only MHEVs (mild hybrid electric vehicle) with crankshaft-driven starter generator. 2. Only vehicles with optional equipment 01CE = recuperation system 3. Affected I-levels: I-level 24-07-500 or higher
After programming the vehicle via ISTA/RSUto I-level 26-03-5xx, some of the interiorambient lighting strips (arrows) may begin tofail sporadically after a deep sleep cycle.
Sobald das Telematikmodul (TCB2) in den Ruhemodus versetzt, kann ein BMW Data Services-Trigger für Remote Services (Fernstart des Motors, Sperren/Entriegeln/Klimaaufbereitung) den TCB2 nicht mehr reaktivieren. Aufgrund dieses Problems funktionieren Remote Services im Fahrzeug nicht mehr, wenn sie geparkt und verriegelt sind.
Quellen: NHTSA (USA, gemeinfrei), Transport Canada (Open Government Licence – Canada), DVSA (Vereinigtes Königreich, Open Government Licence v3.0), RappelConso und EU-Safety-Gate (Frankreich, Licence Ouverte 2.0), MLIT (Japan, Public Data License 1.0) und MOLIT (Südkorea, car.go.kr).