Bulletin
Hemi-Wasserpumpe: Prüfung auf Kühlmittelaustritt
🔔 Kostenloses Konto anlegen und Benachrichtigungen zu Dodge Challenger (alle generationen) erhalten
Technische Bulletins (TSB) sind Reparaturanweisungen, die Hersteller ihren Händlern zu bekannten Problemen schicken. Sie sind keine Sicherheitsrückrufe, bestätigen aber oft einen Mangel.
Hemi-Wasserpumpe: Prüfung auf Kühlmittelaustritt
MIL/CEL is on with Excessive Vibration / Lack or Loss of Power / Engine Misfire.
Part Description: 5.7L Long Block Issue Description: This 5.7L Long Block Assembly is compatible with both EGR and Non-EGR applications. An EGR Block-Off Plate (53032739AA) must be ordered when installing this Long Block Assembly in a Non-EGR application. Unless, the EGR Block-Off Plate is being transferred from the old engine.
Kundenzufriedenheitsmitteilung T12 VECI-Etikett Das Fahrzeugemissions-Kontrollinformations-Etikett (VECI-Etikett) bei etwa 120.000 der oben genannten Fahrzeuge enthält möglicherweise keine Emissionskontrollinformationen. Das VECI-Etikett wird häufig bei der Prüfung und Wartung im Betrieb (Inspection and Maintenance, I/M) verwendet, um die ordnungsgemäße Funktion emissionsrelevanter Bauteile zu überprüfen. Falsche Angaben auf dem VECI-Etikett könnten im Bundesstaat Kalifornien zur Verweigerung der Fahrzeugzulassung führen. Ein neues VECI-Etikett muss installiert werden.
Service - Four Piece Oil Pan Gasket All Cummins Equipped Vehicles ONLY - The replacement oil pan gasket can be a four piece gasket rather than a single piece gasket. This applies to Cummins 5.9L and 6.7L engines only. Installation: 1. Clean the oil pan T-joints.~ 2. Fill the T-joint between the pan rail/gear housing and pan rail/rear seal retainer with sealant. Use Mopar Silicone Rubber Adhesive Sealant or equivalent. 3. Apply a 2-mm [0.063-in] bead of Mopar Engine Sealant RTV Silicone Rubber Adhesive, to the oil pan flange.~ 4. The four piece gasket will need to be assembled to make a complete oil pan gasket. 5. Lay the oil pan gasket(s) onto the oil pan flange.~ 6. Ensure the oil pan gasket segment joints are properly aligned. 7. Apply a 2-mm [0.063-in] bead of Mopar Engine Sealant RTV Silicone Rubber Adhesive, to the top of the oil pan gasket.~ 8. Install the oil pan. Starting from the center and working outward, tighten the oil pan bolts to 28 Nm [21 ft. lbs.].
Replace Vehicle Emission Certification Information Label This bulletin involves replacing the Vehicle Emission Certification Information (VECI) Label.Owner may be turned away from Inspection and Maintenance (IM) station or fail IM testing because of missing emission components on VECI label. The customer may notice that some info is missing on their VECI labels.is missing. If information is shown in this area, do not replace the label.All vehicles were built with the correct emission components installed and there is no impact on emission performance or drivability.
Part Description: 5.7L Long Block Issue Description: This 5.7L Long Block Assembly is compatible with both EGR and Non-EGR applications. An EGR Block-Off Plate (53032739AA) must be ordered when installing this Long Block Assembly in a Non-EGR application. Unless, the EGR Block-Off Plate is being transferred from the old engine.
SEAL, Crankshaft Oil, Front Front crankshaft oil seal leak: For concern of front crankshaft seal leak please send an email to brenton.swank@fcagroup.com with VIN, Mileage, Photos and indicate where the leak is identified using dye such as: 1. Leak between the outer diameter of the seal to front cover? 2. Leak between the seal and damper 3. Leak through the damper bolt This will help in determining root cause and corrective action. For additional questions, please contact: Brenton Swank: Cell (248) 804-9386 or brenton.swank@fcagroup.com If no response in 15 minutes, proceed with repair.
Right Side Engine Cover Missing With Shaker Package This bulletin involves installing the right side engine cover if missing. The customer may notice the right side engine cover is missing. Only the right side engine cover was missed during vehicle assembly, the left side of the engine does not get an engine cover and is not part of this service action.
Vehicle Emission Certification Information Label ersetzen Dieses Bulletin betrifft den Austausch des Fahrzeug-Emissionszertifizierungs-Informationsschildes (VECI-Label). Der Halter wird unter Umständen bei einer Prüfstelle für Inspektion und Wartung (IM-Prüfstelle) abgewiesen oder fällt bei der IM-Prüfung durch, da Emissionsbauteile auf dem VECI-Label fehlen. Der Kunde bemerkt möglicherweise, dass einige Angaben auf seinen VECI-Labels fehlen. Wenn in diesem Bereich Informationen angezeigt werden, ersetzen Sie das Label nicht. Alle Fahrzeuge wurden mit den korrekt verbauten Emissionsbauteilen gefertigt, und es gibt keine Auswirkungen auf die Emissionsleistung oder das Fahrverhalten.
"pentastar oil filter adapter before replacing this part, please call any one of the following people. Engineering is seeking information regarding this part.~ dye must be used to determine where the leak is coming from before replacing. Also please check the recently updated service bulletin number 09-008-15. ~ first: Nick morand cell (248) 410-5078 - nick.Morand@fcagroup.Com second: Bob jackson cell (248) 944-0466 - bob.Jackson@fcagroup.Com third: Joe lovell cell (734 309-6467 - joe.Lovell@fcagroup.Com if a response is not received within 15 mins, then proceed with the necessary repair."
Various vehicles are experiencing loss of oil, and possibly an oil leakage pooling in engine valley and possibly need replacing oil filter housing. Model 2014. *pe
CUSTOMER SATISFACTION NOTIFICATION NORTH AMERICA Crankshaft Damper C6C The internal crankshaft vibration damper fasteners on about 345 of the above vehicles may become loose, which can result in an engine compartment noise and damage to the front timing chain cover, which if ignored can result in engine failure.
Emissionsrückruf 83A: Abstimmung der Verkaufscodes
DRIER Receiver,COMPRESSOR Air Conditioning Engineering is seeking more information about AC Compressor noise issues. For the vehicle AC Compressor and Receiver Drier noise and/or no AC, call Stellantis Engineering for further instructions. Technician can contact FCA Redacted Content If there is no answer within 15 minutes, please proceed with the repair.
Customer complaints may include abnormal engine noise, rough idle, lack of power, misfire. Upon investigation, it may be found that there is excessive camshaft lobe wear/lifter wear (roller failure) on one or more cam lobes and that camshaft/lifter replacement is necessary.
Coolant Charge Air Cooler Pump Associated To Low Coolant Level or Diagnostic Trouble Codes
Loose Rear Spoiler Scat Pack Badge This bulletin involves inspecting and if necessary, replacing a separating or not adhering chrome Scat Pack badge on the rear spoiler. The customer may describe the following:The chrome letter Scat Pack badge is separating or loose, has gaps or is not adhering to the rear spoiler on the passenger side of the vehicle.
Muffler and tailpipe ? Exhaust
Tube - turbo water feed
Front Engine Cover Oil Weep This bulletin involves inspecting and replacing the right side front engine cover gasket if necessary. The customer may experience an oil weep from the right front engine cover.
Part Description: Exhaust Actuator Issue Description: Please call Jason Maltese at cell (248) 931-4179 or email him at emailjason.maltese@fcagroup.com before replacing this part. Engineering may want to visit dealers in the SE Michigan area to investigate this issue. If no answer and if you do not receive a return call within 15 minutes please continue with the normal repair.
Attention! Release Of New Engine Coolant Organic Additive Technology (OAT) Chrysler Corporation LLC. has released a new engine coolant for the 2013 model year vehicles and beyond, for all engine applications except the ones listed in the note above. This new coolant is an Organic Additive Technology (OAT) (Fig. 1). OAT coolants have a service interval of 10 years or 150,000 miles. For heavy duty truck and extreme duty cycle applications refer to the Service Information or Owner's Manual for proper maintenance schedules.
Part Description: Exhaust Actuator Issue Description: Please call Jason Maltese at cell (248) 931-4179 or email him at emailjason.maltese@fcagroup.com before replacing this part. Engineering may want to visit dealers in the SE Michigan area to investigate this issue. If no answer and if you do not receive a return call within 15 minutes please continue with the normal repair.
Before replacing this part for debris issue faults, please call the following people;~ Engineering is seeking information regarding this part.~ Bob Smith ? Cell (248) 202-9458 - Robert.M.Smith@fcagroup.com~ If a response is not received within 15 mins, then proceed with the necessary repair.~
Quellen: NHTSA (USA, gemeinfrei), Transport Canada (Open Government Licence – Canada), DVSA (Vereinigtes Königreich, Open Government Licence v3.0), RappelConso und EU-Safety-Gate (Frankreich, Licence Ouverte 2.0), MLIT (Japan, Public Data License 1.0) und MOLIT (Südkorea, car.go.kr).