Frei lesbar · kostenloses Konto zum MitmachenNachfolger von Anticars (2000)

Ford Contour

1994–2000 · 1 generationen · 13 dokumentierte Mängel · 2 Märkte
Generationen
Alle GenerationenContour1994–20001335222
Modelljahr
MarktAlleNA
RückrufKritischInnenraumNA

Seats And Restraints

The passenger side supplemental restraint system (air bag) may have a cracked inflator body. If the vehicle is involved in a deployment level crash, the passenger side air bag may not inflate properly which could result in reduced occupant protection. In addition, the igniter plug could separate from the inflator, which could result in the release of hot gases and could ignite flammable material or potentially cause personal injury. Correction: Vehicles will be inspected and a new passenger side air bag module will be installed if necessary.

Transport Canada21. Feb. 19951995032Modelljahre 1995Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
RückrufMittelInnenraumNA

Seat belts

Vehicle description: Passenger vehicles, light duty trucks, sport utility vehicles, and mini vans equipped with trw seat belt buckle assemblies. The buckle base of these seat belt assemblies were not properly heat treated and therefore do not pass the load bearing requirement of federal motor vehicle safety standard no. 209, "seat belt assemblies."

NHTSA · USA18. Aug. 200000V228001Modelljahre 2000Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
RückrufMittelInnenraumNA

Air bags:Frontal:Sensor/control module-inactive

Vehicle description: Passenger vehicles. The air bag sensor wiring pigtail insulation can become brittle and crack over time due to accumulation of water in the pigtail protective convolute in combination with high underhood temperatures related to the routing of the wiring pigtail near the radiator. This can result in environmental stress cracking of the insulation.

NHTSA · USA8. Sept. 199999V243000Modelljahre 1998Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
RückrufMittelInnenraumNA

Seats And Restraints

These vehicles may not comply with the requirements of c.M.V.S.S 210 - seat belt assembly anchorages. The hardware that attaches the outboard ends of the front safety belts to the front seat frames may be cracked or fractured. If so. The load that the safety belt could sustain would be below that specified by the standard. Correction: Reinforcement plates will be installed to the attachment hardware of both outboard front safety belts. If the attachment hardware is fractured, a new safety belt will be installed.

Transport Canada9. Jan. 19961996003Modelljahre 1995Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
RückrufMittelInnenraumNA

Seat belts:Front:Anchorage

Cracks have been found in the front safety belt outboard anchor tabs due to a combination of hydrogen embrittlement of the tab and stress introduced during attachment of the anchor tab to the seat frame. This does not conform with the requirements of fmvss no. 210, "seat belt assembly anchorages."

NHTSA · USA4. Dez. 199595V228000Modelljahre 1995Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →

Quellen: NHTSA (USA, gemeinfrei), Transport Canada (Open Government Licence – Canada), DVSA (Vereinigtes Königreich, Open Government Licence v3.0), RappelConso und EU-Safety-Gate (Frankreich, Licence Ouverte 2.0), MLIT (Japan, Public Data License 1.0) und MOLIT (Südkorea, car.go.kr).