Ford Motor Company (Ford) is recalling certain 2016-2017 Ford Edge and Lincoln MKX vehicles and 2017 Lincoln Continental vehicles. In the event of a crash, the driver's frontal air bag may not fully inflate or the air bag cushion may detach from the air bag module. As such, these vehicles fail to comply with the requirements of Federal Motor Vehicle Safety Standard (FMVSS) number 208, "Occupant Crash Protection."
On vehicles equipped with a driver side supplemental air bag, the centre post threads of the air bag module may have been damaged during assembly. In a deployment level collision, the centre post housing may separate from the air bag adapter causing the air bag not to inflate properly. In addition, hot combustion gases would flow directly through the air bag rather than through the normal filtering and cooling devices, presenting the possibility of burn injury to vehicle occupants. Correction: Air bag modules will be inspected and replaced if necessary.
Transport Canada21. Nov. 19901990182Modelljahre 1990Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
Bei bestimmten Personenkraftwagen könnte sich der Fahrer- und/oder Beifahrer-Airbag auslösen, wenn es zu Unterbodenaufprallen in der Nähe der Sensoren kommt, etwa durch Steinchen oder Schmutz, die während des Fahrens mit mittlerer bis hoher Geschwindigkeit oder beim Beschleunigen von den Rädern aufgeschleudert werden.
Fahrzeugbeschreibung: Personenkraftwagen. Der Gurtaufroller des Sicherheitsgurts kann einen fehlerhaft ausgeformten Bolzen im umschaltbaren ELR/ALR-Mechanismus aufweisen. Unter bestimmten Umständen könnte der Umschaltmechanismus funktionsunfähig werden, wodurch sich das Gurtband nicht aus dem Aufroller herausziehen lässt. Ebenso ist möglich, dass eine Fehlfunktion des Mechanismus verhindert, dass der Gurt in den ALR-Modus geschaltet werden kann. Der ELR-Mechanismus ist von diesem Zustand nicht betroffen.
The front outboard seating position seat belt buckles on these vehicles may not latch or unlatch. These conditions could reduce belt usage. In the event of sudden stop or vehicle crash, the risk of injury to an unrestrained occupant would be increased. Correction: Front outboard seat belt buckle assemblies will be replaced.
Transport Canada10. Nov. 19971997192Modelljahre 1989–1990Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
The left side rear seat belt retractor assembly may be improperly secured. In the event of a sudden stop or vehicle crash, the passenger using this seat may not be adequately restrained. Correction: Retractor mounting will be inspected and retractor attachment bolt will be reinstalled if necessary.
Transport Canada28. März 19891989039Modelljahre 1989Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
The driver and front seat passenger inboard seat belts may not be properly anchored to the inboard seat tracks. There is a possibility that one of the nuts was not tightened to specification or the seat belt anchor was not attached to a stud. If a nut is loose, it could break off, allowing the belt anchor to disengage the stud. An unattached belt assembly would not withstand an impact load. Correction: Vehicles will be inspected and inboard seat belt anchorages will be corrected if necessary.
Transport Canada9. März 19881988029Modelljahre 1988Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
The bolts that attach the d-shaped ring for the shoulder belt are inadequately supported by the material in which they are mounted. The attachment does not comply with the requirements of federal motor vehicle safety standard no. 210, "seat belt assembly anchorages".
The upper torso restraint d-ring which attaches the shoulder belt to the b pillar, under certain test conditions, separated from its anchorage, and may not comply with cmvss 210 - belt anchorage.
Transport Canada17. Dez. 19831983114Modelljahre 1984Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
Rückruf aufgrund der Bestätigung, dass ein Softwarefehler im Infotainment-Display dazu führen kann, dass bestimmte Infotainment-Einstellungen zurückgesetzt werden, der Bildschirm beim Rückwärtsfahren gelegentlich schwarz bleibt oder die Rückfahrkamera-Anzeige auch nach Beendigung des Rückwärtsfahrens weiterhin angezeigt wird. In solchen Fällen kann die Konzentration des Fahrers beeinträchtigt werden, was die sichere Fahrweise beeinflussen kann.
<Produktionsdatum der betroffenen Fahrzeuge>
2019 MKZ: 07.11.2018 bis 12.03.2020
2020–2022 Corsair: 23.07.2020 bis 22.04.2022
2019–2020 Continental: 18.09.2018 bis 25.10.2019
2019–2020 Nautilus: 29.03.2019 bis 30.10.2020
2019–2022 Mustang: 02.08.2018 bis 15.08.2022
2021 Expedition: 19.01.2021 bis 16.02.2021
2021 Navigator: 22.02.2021 bis 23.11.2021
2020–2023 Aviator: 09.09.2019 bis 09.08.2023
2020–2023 Explorer: 22.08.2019 bis 30.08.2023
Quellen: NHTSA (USA, gemeinfrei), Transport Canada (Open Government Licence – Canada), DVSA (Vereinigtes Königreich, Open Government Licence v3.0), RappelConso und EU-Safety-Gate (Frankreich, Licence Ouverte 2.0), MLIT (Japan, Public Data License 1.0) und MOLIT (Südkorea, car.go.kr).