Not applicable to vehicles built for US market. Corner Radar Dynamic Alignment Calibration Issue IMPORTANT! **The DTC listed below may set when the Radar Dynamic Alignment procedure is SYMPTOM: unsuccessful. The procedure should only be started when a radar is replaced or when bumpers are removed/reinstalled. Before performing the procedure, make sure the reported problem actually concerns the radars. If any Diagnostic Trouble Codes (DTCs) or conditions/symptoms different from those described below are detected, record them in the repair order and carry out the necessary actions before continuing with the additional instructions in this bulletin.** **Technicians must experience a malfunction of ADAS systems and the vehicle must exhibit/set the following DTC on one or more corner radars:** B2EF9-78 - Alignment Of The Corner Radar Completed With Failure : Alignment Not Carried Out. Technicians will also experience the following: Unable to successfully perform the corner radar dynamic alignment procedure. This bulletin involves reprogramming the corner radars with the latest software then performing the Sensor/ Proximity Radar Calibration procedure
NANHTSA · Herstellerbulletin11038748
Technische Bulletins
Im Original (Englisch) angezeigt · Übersetzung ausstehend
Betrifft: Jeep Compass II (Modelljahre 2026)
Quellen: NHTSA (USA, gemeinfrei), Transport Canada (Open Government Licence – Canada), DVSA (Vereinigtes Königreich, Open Government Licence v3.0), RappelConso und EU-Safety-Gate (Frankreich, Licence Ouverte 2.0), MLIT (Japan, Public Data License 1.0) und MOLIT (Südkorea, car.go.kr).