Free to read · free account to contributeSuccessor to Anticars (2000)

BuickBuick Regal

1978– · 5 generations · 59 documented defects · 1 markets
Generations
Model year
MarketAllNA
Regal VI · 2017–
RecallCriticalInteriorNA

Seat belts:Rear/other

General Motors LLC (GM) is recalling certain 2018 Buick Regal vehicles. During the manufacturing process, the rear seat belts may have been improperly routed around the bolster bracket on the rear outboard seats, which can cause inadequate restraint of the passengers.

NHTSA · United StatesApr 12, 201818V230000Model years 2018View details →
Regal V · 2008–2017
RecallCriticalInteriorNA

Seats:Front assembly:Power adjust

General Motors LLC (GM) is recalling certain model year 2011 Buick Regal vehicles manufactured November 3, 2009, to March 25, 2011, equipped with 8-way power adjustable front seats. The power seat wiring harness may contact the seat frame, causing the wires to chafe.

NHTSA · United StatesJul 7, 201616V517000Model years 2011View details →
Regal IV · 1996–2004
RecallCriticalInteriorNA

Seat belts

Vehicle description: Certain passenger vehicles, equipped with sunvisor located air bag labels, fail to conform to federal motor vehicles safety standard no. 208, "occupant crash protection." these vehicles have a message area less than 30 cm which does not meet the requirements of the standard.

NHTSA · United StatesApr 6, 200101V109000Model years 2000–2001View details →
Regal IV · 1996–2004
RecallCriticalInteriorNA

Air bags:Side/window

Vehicle description: Passenger vehicles. Some of these vehicles exhibit a condition in which the driver side impact air bag inflator separates from the air bag module during deployment.

NHTSA · United StatesNov 13, 200000V371000Model years 2000–2001View details →
Regal III · 1987–1996
RecallCriticalInteriorNA

Air bags:Frontal

Vehicle description: Passenger vehicles. Corrosion of the air bag inflator's internal wiring, which can occur over time, could cause the inadvertent deployment of the driver's air bag. This deployment could occur during vehicle start-up, while the vehicle is parked or idling, or while in operation.

NHTSA · United StatesJul 3, 200000V171000Model years 1995View details →
Regal II · 1978–1987
RecallCriticalInteriorNA

Seat belts:Front:Anchorage

Left handed driver's side shoulder belt anchor plate may be upside down in lock pillar so that the unthreaded slot of the plate aligned with the hole in the lock pillar. This resulted in the anchor bolt being driven into the slot instead of the threaded hole of the anchor plate. Consequence of defect: In a vehicle crash, belt anchor bolt may pull loose from anchor plate, thus failing to comply with fmvss 210, seat belt assembly anchorages, and increases likelihood of injury to occupant.

NHTSA · United StatesJul 14, 198686V093000Model years 1986View details →
Regal V · 2008–2017
RecallModerateInteriorNA

Seats:Front assembly:Power adjust

General Motors LLC (GM) is recalling certain model year 2011-2012 Buick LaCrosse, Regal and Chevrolet Camaro, as well as certain 2010-2012 Cadillac SRX, Chevrolet Equinox and GMC Terrain vehicles, equipped with power height adjustable driver and passenger seats. In the affected vehicles, the bolt that secures the driver's and passenger's power front seat height adjuster may fall out causing the seat to drop suddenly to the lowest vertical position.

NHTSA · United StatesJul 23, 201414V447000Model years 2011–2012View details →
Regal IV · 1996–2004
RecallModerateInteriorNA

Seat belts

Vehicle description: Passenger vehicles, light duty trucks, sport utility vehicles, and mini vans equipped with trw seat belt buckle assemblies. The buckle base of these seat belt assemblies were not properly heat treated and therefore do not pass the load bearing requirement of federal motor vehicle safety standard no. 209, "seat belt assemblies."

NHTSA · United StatesAug 7, 200000V228003Model years 2000–2001View details →
Regal III · 1987–1996
Regal III · 1987–1996
RecallModerateInteriorNA

Seats And Restraints

Certain vehicles may have a centre rear seatbelt anchor plate which exhibits stress cracks. In the event of a vehicle crash, the seatbelt system may fracture and injury to the seat occupant could occur. Correction: Centre rear seat belt system will be replaced.

Transport CanadaApr 23, 19971997090Model years 1995View details →
Regal III · 1987–1996
Regal III · 1987–1996
RecallModerateInteriorNA

Seats

The driver and passenger front seat manual reclining mechanisms do not comply with the requirements of fmvss 207, "seating systems." the seat back mechanisms will not latch under certain conditions.

NHTSA · United StatesMar 9, 199393V035000Model years 1993View details →
Regal III · 1987–1996
RecallModerateInteriorNA

Seats And Restraints

Certain vehicles may not comply with CMVSS 207 - Anchorage of Seats. Front seat back recliner mechanism may not latch properly. Correction: Driver and passenger front seat back recliner machanisms will be replaced.

Transport CanadaMar 3, 19931993026Model years 1993View details →
Regal III · 1987–1996
RecallModerateInteriorNA

Seat belts

The front door shoulder belt guide loops may be cracked and are not in compliance with fmvss 208.

NHTSA · United StatesJan 10, 199292V003000Model years 1991View details →
Regal III · 1987–1996
RecallModerateInteriorNA

Seats And Restraints

Certain vehicles do not comply with CMVSS 208 - Seatbelt Installations. Front door shoulder belt guide loops may not provide front seat occupants with proper protection in the event of a crash. Correction: Dealers will inspect the front door shoulder belt guide loops for possible cracks. If a cracked guide loop is found, both front door guide loops will have reinforcing plates installed.

Transport CanadaJan 9, 19921992002Model years 1991View details →
Regal III · 1987–1996
RecallModerateInteriorNA

Seat belts

Front shoulder safety belt webbing may separate at front belt upper guide loops on either side of the front seat.

NHTSA · United StatesOct 2, 199191V005000Model years 1990–1991View details →
Regal III · 1987–1996
RecallModerateInteriorNA

Seats And Restraints

On certain vehicles, the front shoulder seat belt webbing may separate at the seat belt upper guide loops (driver and/or passenger side). Separation of the webbing would occur without prior warning and could increase the risk of injury to belted front outboard occupants in the event of a crash. Correction: Dealers will install a controlled rotation bracket on both the driver and passenger side front seat shoulder belt guide loops to prevent this condition from occuring.

Transport CanadaFeb 12, 19911991022Model years 1991View details →
Regal III · 1987–1996
RecallModerateInteriorNA

Seats And Restraints

Certain vehicles do not comply with CMVSS 210 - Seatbelt Assembly Anchorages. Anchor bolt may pull through the upper anchorage plate. Correction: Nut assembly with a larger diameter flanged nut will be installed in place of the existing nut assembly.

Transport CanadaMar 15, 19901990044Model years 1988–1990View details →
Regal III · 1987–1996
RecallModerateInteriorNA

Seat belts

Front shoulder belt guide loop attachment fastener may pull through door mounted anchor plate.

NHTSA · United StatesMar 14, 199090V054000Model years 1988–1990View details →
Regal II · 1978–1987
RecallModerateInteriorNA

Seats And Restraints

Certain vehicles equipped with hatchroof option may not comply with CMVSS 210 - Seatbelt Assembly Anchorages. Drivers side shoulder belt anchor plate may be located upside down which can result in the anchor bolt pulling loose in an accident.

Transport CanadaJul 16, 19861986077Model years 1986View details →
Regal II · 1978–1987
RecallModerateInteriorNA

Seats And Restraints

On certain vehicles, the heads of the rear seatbelt anchor bolts may break off during normal vehicle use and in the event of an accident in which the rear seatbelts are in use, the probability of injury to the wearer will be increased.

Transport CanadaJan 11, 19851985008Model years 1980View details →
Regal II · 1978–1987
RecallModerateInteriorNA

Seat belts:Front:Retractor

The vehicles were assembled with front seat belt retractors which may not perform adequately during a collision.

NHTSA · United StatesNov 27, 198484V154000Model years 1985View details →
Regal II · 1978–1987
RecallModerateInteriorNA

Seats:Front assembly:Recliner

Some vehicles have bucket seat back locks that do not conform to federal motor vehicle safety standard 207, anchorage of seats. In event of a crash, the seat back lock may not function.

NHTSA · United StatesFeb 6, 198484V011000Model years 1984View details →
Regal III · 1987–1996
RecallMinorInteriorNA

Seat belts:Front:Webbing

Owners manuals did not fully explain how front shoulder belt comfort feature works.

NHTSA · United StatesJun 6, 199090V112000Model years 1990View details →

Sources: NHTSA (United States, public domain), Transport Canada (Open Government Licence – Canada), DVSA (United Kingdom, Open Government Licence v3.0), RappelConso and EU Safety Gate (France, Licence Ouverte 2.0), Japan's MLIT (Public Data License 1.0) and South Korea's MOLIT (car.go.kr).