Fiat Professional 2025 Doblo and Scudo. Fuel injection common rail. Fuel leak
On affected vehicles a non-conformity issue with the fuel injection common rail may lead to a loosening of the nut and a potential fuel leak.
🔔 Create a free account to get email alerts about Fiat Scudo (all generations)
On affected vehicles a non-conformity issue with the fuel injection common rail may lead to a loosening of the nut and a potential fuel leak.
Les véhicules équipés d'un moteur dv5r peuvent présenter une fuite de carburant. la non-conformité de la forme ronde sur le cône du rail commun peut provoquer le desserrage de l'écrou, entraînant la possibilité d'une fuite de carburant entre l'écrou et le filetage, entraînant des vapeurs de carburant et un flux de carburant dans le système d'échappement chaud. cela peut provoquer un incendie sous le capot.
null Fuel can leak out from the cover of the heated diesel filter, and can reach hot parts of the vehicle or drip onto the road. There is a risk of fire even once the engine has been switched off.
Een elektrische verbinding van de brandstofverwarming in het brandstoffilterdeksel kan oververhit raken. Hierdoor kan het deksel vervormen.
The fuel return pipe connector at the injectors may overtime wear and leak. The leaking fuel is a fire risk and also could be hazardous to other road users.
De dieselretourleiding op de verstuiver(s) kunnen versneld verouderen en als gevolg daarvan gaan lekken.
The fuel return pipe may contact the engine sound insulation cover. This may cause a deterioration of the pipe and if not rectified a leak of fuel.
Vehicles may have a defect in the diesel exhaust fluid (urea) consumption monitoring system. Because of this issue, the diagnostic test designed to detect problems such as low urea consumption or a clogged injector may not run often enough. This increases the risk that the emissions system is not properly monitored, which could cause the vehicle to fail to meet required emissions standards.
The DV5R engine may experience a loss of power due to slippage of the water pump pulley. This slippage can cause the timing belt to misalign, potentially leading to engine stall. The water pump pulley gear may detach from the shaft, which can result in parts falling onto the road and increase the risk of accidents and injuries.
Due to oil carbonization and high contact pressure, the strength of the 7 mm camshaft chain may be reduced. This may cause the camshaft chain to break, resulting in engine failure. This may lead to a loss of vehicle control and increase the risk of accidents and injuries.
The calibration for urea pump diagnostics in the ECU (Engine Control Unit) is not fulfilling the regulation requirement.
The engine can stall spontaneously while driving due to a fault in the communication between the electric control unit and the air conditioning compressor.
Some vehicles may have been equipped with an incorrectly positioned fuel pipe.
Some vehicles may have been equipped with an incorrectly positioned fuel pipe.
The support bracket for the ballast weight under the floor plate can break.
After repeated activation of the fuel heater cover in cold conditions an electric connector the fuel heater cover may overheat. This may allow air ingress which could cause difficulty starting the engine or engine stalling. In extreme cases fuel may leak onto the road surface.
De massa van de ruitenwissermotor via de reguliere bedrading is onvoldoende. Hierdoor kan de ruitenwissermotor uitvallen.
The fuel return pipe on 2.0 16v JTD engine variants may interfere with the engine mounting and/or fuel filter.
The lower engine stabiliser rod may crack or break. This could result in detachment of the off side drive shaft on full lock.
Brake vacuum pump drive coupling dog may fail as a result of breakage. This could result in a loss of power assistance at the brake pedal.
Sources: NHTSA (United States, public domain), Transport Canada (Open Government Licence – Canada), DVSA (United Kingdom, Open Government Licence v3.0), RappelConso and EU Safety Gate (France, Licence Ouverte 2.0), Japan's MLIT (Public Data License 1.0) and South Korea's MOLIT (car.go.kr).