Vehicle description: Passenger vehicles equipped with 1.9l engines, built at the hermosillo assembly plant and originally sold or currently registered in arizona. Cracks can develop in the fuel tank near the heat shield attachment resulting in fuel leakage if the cracks go through the fuel tank wall.
NHTSA · United StatesSep 3, 199797V145000Model years 1995View details →
Vehicle description: Passenger vehicles equipped with 1.9l engines, built at the hermosillo or wayne assembly plants and originally sold or currently registered in nevada, florida, hawaii, texas, california, louisiana, georgia, south carolina, mississippi, oklahoma, alabama and arkansas. Cracks can develop in the fuel tank near the heat shield attachment resulting in fuel leakage if the cracks go through the fuel tank wall.
NHTSA · United StatesSep 3, 199797V144000Model years 1995View details →
Fatigue cracks may develop in the solder joint between the fuel return tube and the fuel pump sending unit located on the top of the fuel tank. This would allow fuel vapours to escape from the tank and when the tank is 7/8 or more full, a small amount of liquid fuel may leak from the crack presenting a potential fire hazard. Note: For escort models only gt and lxe lines involved. Correction: Vehicles will be inspected and fuel pump sending unit assembly will be replaced with one of improved strength.
Transport CanadaSep 29, 19921992121Model years 1991–1992View details →
On 1984 models, external cracks may develop in the engine cylinder heads, which may result in an oil leak onto the exhaust manifold. On 1985 models, the engine rocker cover gasket may split, which could allow oil to leak onto the exhaust manifold. Both these conditions create the possibility of the oil igniting causing an underhood fire. Correction: On 1984 models, the cylinder heads will be inspected and replaced if found to contain external cracks. On 1985 models, the rocker cover gaskets will be inspected and replaced unless they are of a later design.
Transport CanadaJul 13, 19891989098Model years 1984–1985View details →
External cracks above the number 3 cylinder (1984 models) or rocker arm cover gaskets splitting (1985 models) could allow oil to leak onto the exhaust manifold.
NHTSA · United StatesJun 12, 198989V095000Model years 1984–1985View details →
On vehicles with efi or cfi, the spring-lock fuel line coupling used to connect the fuel supply and return lines to the efi fuel rails or to the cfi throttle bodies as well as other fuel line connections near the dash panels on some vehicles, could disengage during vehicle use. Should this occur, loss of fuel will result, providing the potential for a vehicle fire. Correction: Coupling retainer clips will be installed on affected vehicles. Note: Escort vehicles are equipped with efi and cfi. Lynx vehicles are equipped with cfi only. Efi - electronic fuel injection cfi - central fuel injection
Transport CanadaSep 9, 19871987098Model years 1986–1988View details →
During a crash barrier test, the rubber hose connecting the fuel tank and the metal filler pipe vent tube was cut, resulting in fuel leakage. The involved vehicles fail to comply with federal motor vehicle safety standard no. 301, "fuel system integrity".
NHTSA · United StatesSep 16, 198282V088000Model years 1983View details →
Metal fasteners used to secure the carpeting to the floor pan may have been milocated and may have penetrated the top of the fuel tank. This condition may allow fuel leakage.
Transport CanadaNov 4, 19801980144Model years 1981View details →
On certain vehicles, metal fasteners that were used to secure the carpeting to the floor pan may have accidentally penetrated the top of the fuel tank. This would result in a slight fuel leak.
NHTSA · United StatesNov 4, 198080V142000Model years 1981View details →
Note: Vehicles equipped with 1.9 litre engines. These vehicles may release carbon monoxide exhaust emissions which exceed the requirements of c.M.V.S.S 1103 - exhaust emissions. Correction: Exhaust system catalyst assembly will be replaced on affected vehicles.
Transport CanadaDec 6, 19931993165Model years 1988View details →
A bolt that secures a fuel line shield to the lower portion of the dash panel protrudes through the panel and may interfere with the accelerator pedal when the pedal is fully depressed. Under certain circumstances, this could result in the pedal sticking at the wide open throttle position. This could cause possible loss of control and a vehicle crash. Correction: Bolt will be cut off flush with the top of the weld nut through which it protrudes.
Transport CanadaApr 20, 19901990062Model years 1991View details →
These vehicles may not comply with c.M.V.S.S. 1103 - exhaust emissions. The central fuel injector (cfi) may operate rich during certain operating conditions. Correction: Improved cfi fuel injectors will be installed and idle speed will be adjusted.
Transport CanadaJul 13, 19891989099Model years 1987View details →
The throttle lever may not return to idle position due to misalignment of the air conditioner shut off switch to the throttle lever pin. Consequence of defect: A jammed throttle could result in a loss of accelerator control, without prior warning, and an accident.
NHTSA · United StatesMay 1, 198585V054000Model years 1985View details →
Vehicles with 1.9l engine and air conditioning. A pin located on the throttle lever which actuates the air-conditioner shut-off switch may be subject to misalignment such that the switch could jam behind the actuating arm of the switch. If this were to occur, the throttle lever would be prevented from returning to the idle position and vehicle control could be adversely affected.
Transport CanadaApr 29, 19851985050Model years 1985View details →
SOME OF THE VEHICLES (EQUIPPED WITH 1.6 LITRE ENGINES, CALIBRATION 3-03B-R10) MAY HAVE BEEN BUILT AND SHIPPED WITH EXHAUST AIR SUPPLY AIR CONTROL VALVE HOSES REVERSED. EMISSION LEVELS ARE EXPECTED TO INCREASE, POSSIBLY EXCEEDING THE STANDARDS. bRIVEABILITY SHOULD NOT BE AFFECTED.
Transport CanadaOct 18, 19831983087Model years 1983View details →
On the involved vehicles, a thermal limiter in the blower motor resistor circuit of the air conditioner/heater assembly may not function as intended. If the blower motor becomes jammed when the system is operating in the medium-low blower speed, the resistor coils can overheat causing melting and possible ignition.
NHTSA · United StatesMay 11, 198282V045000Model years 1982View details →
Vehicles with optional air conditioning. The air conditioner blower motor thermal limiter may not operate as intended when there is a motor blockage or malfunction. Thus, if the blower motor becomes jammed when the system is operating in the medium-low blower speed mode, the resistor coils may overheat causing melting and possible ignition of the polyproplene evaporator housing with associated vehicle damage.
Transport CanadaMay 10, 19821982045Model years 1982View details →
Some of the involved vehicles have an electrically ungrounded fuel inlet. These vehicles are subject to static charge accumulation at the fuel filler pipe opening, which can occur if these vehicles are refueled from an electrically ungrounded dispensing nozzle.
NHTSA · United StatesJul 22, 198181V092000Model years 1981View details →
Vehicles with automatic speed control. Fuel may migrate through the speed control vacuum lines into the speed control servo assembly this could cause the vacuum o-ring to shrink allowing a vacuum leak. This leak may result in unintended activation of the speed control and could cause gradual acceleration of the vehicle.
Transport CanadaApr 10, 19811981048Model years 1981View details →
Sources: NHTSA (United States, public domain), Transport Canada (Open Government Licence – Canada), DVSA (United Kingdom, Open Government Licence v3.0), RappelConso and EU Safety Gate (France, Licence Ouverte 2.0), Japan's MLIT (Public Data License 1.0) and South Korea's MOLIT (car.go.kr).