In the engine starting system, the current flowing through the contacts of the ignition switch is large, so a strong arc discharge occurs at the moment the main power is turned on. Repeated starting operations cause excessive wear of the contacts and reduce contact pressure. As a result, vibration during driving may move the contacts, causing them to ride over carbon deposits and leading to poor conduction. In the worst case, the engine may stop suddenly. Note that restarting is possible, since the sliding of the contacts during the starting operation removes the carbon deposits.
In the engine, some units have an insufficient bearing surface area for the crankshaft timing belt guide plate because the mounting seat was machined improperly. If the vehicle continues to be used in this condition, the pulley mounting bolts may loosen and abnormal noise may occur. In the worst case, the crankshaft pulley may spin freely, or the auxiliary drive belt may come off the crankshaft pulley, causing the charge warning light to illuminate and the steering effort to increase.
Sources: NHTSA (United States, public domain), Transport Canada (Open Government Licence – Canada), DVSA (United Kingdom, Open Government Licence v3.0), RappelConso and EU Safety Gate (France, Licence Ouverte 2.0), Japan's MLIT (Public Data License 1.0) and South Korea's MOLIT (car.go.kr).