Free to read · free account to contributeSuccessor to Anticars (2000)
Sign inCreate account
NANHTSA · United States03V527000Dec 11, 2003

Steering:Rack and pinion

Certain passenger vehicles have lower pinion bearings in the power rack and pinion assembly in which the retainer tabs were not crimped properly. These retainers could fail and permit the ball bearings to escape.

Risk: If this occurs, the pinion shaft can be forced upward during left turns and back down as the steering wheel is moved back and to the right. If the pinion shaft moves further, the driver will need to exert more effort to turn the steering wheel, similar to a vehicle without power assisted steering. If the pinion shaft moves even further, the driver will require much higher effort to turn left and may not be able to turn the wheel as much as intended. With the maximum pinion shaft movement, which requires internal gear component damage, the driver can encounter high resistance to turning left, followed by unintended power assist to the right. In any of these conditions, a crash could occur.

Remedy: Dealers will install a new lower pinion bearing unless inspect of the existing bearing indicates that replacement of the gear assembly is necessary. Owner notification began on february 5, 2004. Owners should contact buick at 1-866-608-8080; chevrolet at 1-800-630-2438; oldsmobile at 1-800-630-6537; or pontiac at 1-800-620-7668.

Concerns: Buick Regal IV (Model years 1996–1998) · Chevrolet Lumina II (Model years 1997–1998) · Chevrolet Malibu V (Model years 1997–1998) · Chevrolet Monte Carlo V (Model years 1997–1998) · Oldsmobile Cutlass Supreme V (Model years 1996–1997) · Oldsmobile Intrigue (Model years 1998) · Pontiac Grand Prix VII (Model years 1996)

Official notice ↗

Sources: NHTSA (United States, public domain), Transport Canada (Open Government Licence – Canada), DVSA (United Kingdom, Open Government Licence v3.0), RappelConso and EU Safety Gate (France, Licence Ouverte 2.0).