The bulb mounting method for the stop lamps and tail lamps into their sockets is improper in some cases. As a result, vibration during driving causes the bulb terminals and socket terminals to rub against each other, generating wear particles. These particles accumulate on the socket terminal section, creating electrical resistance that generates heat and melts the insulating plate of the socket terminal. This can cause a short circuit between the socket terminal and the crimp spring, blowing the fuse. The stop lamps and auxiliary stop lamps may then fail to illuminate, and the horn may stop sounding.
Remedy: For all vehicles, the entire rear lighting wiring harness (from the connector to the socket) is to be replaced with the corrective-action part, and the stop lamp and tail lamp bulbs are to be replaced with new ones.