The integrated brake unit has a manufacturing control problem, so some units have foreign matter adhering to the circuit board of the motor sensor. In addition, the design study of the contact pin length was insufficient, so noise occurs due to contact pressure against the motor sensor circuit board. As a result, an electrical contact failure occurs, which turns on the brake warning light and displays a Check Control message. If driving continues as is, the system enters fallback mode, requiring stronger pedal force than normal when operating the brakes, and the engine may fail to start the next time.
Remedy: 全車両、統合ブレーキシステムのモニタリング機能の有無を確認し、無い場合はプログラムを更新する。なお、本不具合によるフォールバックモードに繋がるリスクが検知された時は、統合ブレーキユニットを良品に交換する。また、全車両、モニタリング機能に関する説明を取扱説明書に追加する。