Free to read · free account to contributeSuccessor to Anticars (2000)

Ram ProMaster

1981– · 3 generations · 8 documented defects · 3 markets
Generations

Service bulletins (TSBs) are repair instructions manufacturers send to their dealers about known problems. They are not safety recalls, but they often confirm a defect.

Model year
MarketAllNA
ProMaster III · 2006–
BulletinModerateElectricalNA

Bulletin

Start Stop Charging Warning Lamp Illuminated On, Intelligent Battery Sensor (IBS) State of Charge (SOC) Inaccurate, Battery Charging Message, Presence of IBS related Diagnostic Trouble Codes (DTCs), or Battery Warning Lamp On

NHTSA · manufacturer bulletin10234420Model years 2015–2016View details →
ProMaster III · 2006–
BulletinModerateElectricalNA

Bulletin

No Start, Cannot Complete Module Replace, Proxi Or Module Proxi Configuration

NHTSA · manufacturer bulletin10230183Model years 2015–2016View details →
ProMaster III · 2006–
BulletinModerateElectricalNA

Bulletin

Updated Fuel Filler Cap This bulletin involves updating the fuel filler cap with improved version. Customers may experience a Malfunction Indicator Lamp (MIL) illumination. Upon further investigation the technician may find that one or more of the following Diagnostic Trouble Codes (DTCs) have been set: P0455 - EVAP System Large Leak. P0456 - EVAP System Small Leak. P04EC - EVAP System Large Leak Detected - Fuel Tank Side. P04EE - EVAP System Very Small Leak Detected - Fuel Tank Side.

NHTSA · manufacturer bulletin10229561Model years 2021View details →
ProMaster III · 2006–
BulletinModerateElectricalNA

Bulletin

Telematic box module 2 For customer concern of Uconnect box error popup on the screen every time the vehicle is turned on. A missing security certificate or after a new TBM installed, or any active DTC set by TBM will trigger this popup. Please refer to STAR Online S2108000015 for more information. If you continually see this popup message, also see an active B22A9-93 DTC, please use wiTECH tool to check TBM2 module and record the failure information as shown on STAR Online S228A000003. Before replacing the TBM module, please check connections behind the TBM, the antenna and harness for improper connection and damage. Please call FCA Redacted Content

NHTSA · manufacturer bulletin10225298Model years 2022View details →
ProMaster III · 2006–
BulletinModerateElectricalNA

Bulletin

Updated Fuel Filler Cap This bulletin involves updating the fuel filler cap with improved version. Customers may experience a Malfunction Indicator Lamp (MIL) illumination. Upon further investigation the technician may find that one or more of the following Diagnostic Trouble Codes (DTCs) have been set: P0455 - EVAP System Large Leak. P0456 - EVAP System Small Leak. P04EC - EVAP System Large Leak Detected - Fuel Tank Side. P04EE - EVAP System Very Small Leak Detected - Fuel Tank Side.

NHTSA · manufacturer bulletin10225413Model years 2021View details →
ProMaster III · 2006–
BulletinModerateElectricalNA

Bulletin

Updated Fuel Filler Cap This bulletin involves updating the fuel filler cap with improved version. Customers may experience a Malfunction Indicator Lamp (MIL) illumination. Upon further investigation the technician may find that one or more of the following Diagnostic Trouble Codes (DTCs) have been set: P0455 - EVAP System Large Leak. P0456 - EVAP System Small Leak. P04EC - EVAP System Large Leak Detected - Fuel Tank Side. P04EE - EVAP System Very Small Leak Detected - Fuel Tank Side.

NHTSA · manufacturer bulletin10225276Model years 2021View details →
ProMaster III · 2006–
BulletinModerateElectricalNA

Bulletin

Telematic box module 2 For customer concern of Uconnect box error popup on the screen every time the vehicle is turned on. A missing security certificate or after a new TBM installed, or any active DTC set by TBM will trigger this popup. Please refer to STAR Online S2108000015 for more information. If you continually see this popup message, also see an active B22A9-93 DTC, please use wiTECH tool to check TBM2 module and record the failure information as shown on STAR Online S228A000003. Before replacing the TBM module, please check connections behind the TBM, the antenna and harness for improper connection and damage. Please call FCA Redacted Content

NHTSA · manufacturer bulletin10225161Model years 2022View details →
ProMaster III · 2006–
BulletinModerateElectricalNA

Bulletin

No Start, Cannot Complete Module Replace, Proxi Or Module Proxi Configuration

NHTSA · manufacturer bulletin10221597Model years 2015–2016View details →
ProMaster III · 2006–
BulletinModerateElectricalNA

Bulletin

Install Intake Air Temperature Sensor Jumper Harness.

NHTSA · manufacturer bulletin10218022Model years 2015View details →
ProMaster III · 2006–
BulletinModerateElectricalNA

Bulletin

Install Intake Air Temperature Sensor Jumper Harness.

NHTSA · manufacturer bulletin10215056Model years 2015View details →
ProMaster III · 2006–
BulletinModerateElectricalNA

Bulletin

MIL Lamp On, No Start

NHTSA · manufacturer bulletin10176523Model years 2019–2020View details →
ProMaster III · 2006–
BulletinModerateElectricalNA

Bulletin

Intelligent Battery Sensor-IBS Installation, Battery Charging Message, Start Stop Charging Warning Lamp Illuminated On Stop Start Equipped Vehicles

NHTSA · manufacturer bulletin10173323Model years 2020View details →
ProMaster III · 2006–
BulletinModerateElectricalNA

Bulletin

Radio If this radio is installed in a vehicle equipped with the Radio Prep Package (sales code RA9), the vehicle harness connector will require relocation of the of A4, F20(BL/LG) and A7, A933 (RD/YL) circuits for radio operation. These two terminals must be swapped in the the connector. Failure to do so will result in the radio prompting the user to enter the security code every time the key is cycled.

NHTSA · manufacturer bulletin10229872Model years 2014View details →
ProMaster III · 2006–
BulletinModerateElectricalNA

Bulletin

Radio If this radio is installed in a vehicle equipped with the Radio Prep Package (sales code RA9), the vehicle harness connector will require relocation of the of A4, F20(BL/LG) and A7, A933 (RD/YL) circuits for radio operation. These two terminals must be swapped in the the connector. Failure to do so will result in the radio prompting the user to enter the security code every time the key is cycled.

NHTSA · manufacturer bulletin10218784Model years 2014View details →
ProMaster III · 2006–
BulletinModerateElectricalNA

Bulletin

Radio If this radio is installed in a vehicle equipped with the Radio Prep Package (sales code RA9), the vehicle harness connector will require relocation of the of A4, F20(BL/LG) and A7, A933 (RD/YL) circuits for radio operation. These two terminals must be swapped in the the connector. Failure to do so will result in the radio prompting the user to enter the security code every time the key is cycled.

NHTSA · manufacturer bulletin10217943Model years 2014View details →
ProMaster III · 2006–
BulletinModerateElectricalNA

Bulletin

Battery Prior to replacing the battery, please check the component to determine if there is any acid leaking from the unit. If the answer is yes, please contact Bruce Davis at Cell (248) 613-5637 for further instructions. If the answer is no, please proceed with the battery replacement.~

NHTSA · manufacturer bulletin10181466Model years 2015View details →
ProMaster III · 2006–
BulletinModerateElectricalNA

Bulletin

Install Intake Air Temperature Sensor Jumper Harness The wiring at the connector of the Intake Air Temperature (IAT) sensor may be compromised due to wire strain. This bulletin involves adding a jumper harness on the IAT sensor to reduce this strain. The customer may not experience any symptom or condition for this service action. Upon further inspection, the technician may find P0113 Intake Air Temperature Sensor 1 Circuit High. Installing the jumper harness will help prevent any IAT issues from occurring.

NHTSA · manufacturer bulletin10160020Model years 2015View details →
ProMaster III · 2006–
BulletinModerateElectricalNA

Bulletin

Intermittent Coolant Loss This bulletin involves inspecting and if necessary, replacing the radiator and thermostat. A small number of customers may experience a slight loss of coolant. There may not be any sign of a leak found under the vehicle.

NHTSA · manufacturer bulletin10148907Model years 2014View details →
ProMaster III · 2006–
BulletinModerateElectricalNA

Bulletin

Battery Prior to replacing the battery, please check the component to determine if there is any acid leaking from the unit. If the answer is yes, please contact Bruce Davis at Cell (248) 613-5637 for further instructions. If the answer is no, please proceed with the battery replacement.~

NHTSA · manufacturer bulletin10141266Model years 2015View details →
ProMaster III · 2006–
BulletinModerateElectricalNA

Bulletin

Radio If this radio is installed in a vehicle equipped with the Radio Prep Package (sales code RA9), the vehicle harness connector will require relocation of the of A4, F20(BL/LG) and A7, A933 (RD/YL) circuits for radio operation. These two terminals must be swapped in the the connector. Failure to do so will result in the radio prompting the user to enter the security code every time the key is cycled.

NHTSA · manufacturer bulletin10139618Model years 2014View details →
ProMaster III · 2006–
BulletinModerateElectricalNA

Bulletin

Install Intake Air Temperature Sensor Jumper Harness The wiring at the connector of the Intake Air Temperature (IAT) sensor may be compromised due to wire strain. This bulletin involves adding a jumper harness on the IAT sensor to reduce this strain. The customer may not experience any symptom or condition for this service action. Upon further inspection, the technician may find P0113 Intake Air Temperature Sensor 1 Circuit High. Installing the jumper harness will help prevent any IAT issues from occurring.

NHTSA · manufacturer bulletin10120527Model years 2015View details →
ProMaster III · 2006–
BulletinMinorElectricalNA

Bulletin

Radio Over The Air Update to U43.17 R1H Software Version (FOTA) - Navigation Stability - Android Auto & Carplay stability & connectivity - Distorted/glitchy display prior to startup animation - Text appearance display - Widget incorrect display - Turn signal blind spot response timing - Audio cut out - Drive Modes selection - Park assist Guidelines selction Customers may experience one or more of the following:

NHTSA · manufacturer bulletin11037358Model years 2026View details →
ProMaster III · 2006–
BulletinMinorElectricalNA

Bulletin

Flash: Electronic Vehicle Control Unit (EVCU) Updates Customers may experience a Malfunction Indicator Lamp (MIL) illumination and the vehicle may exhibit/set one or more of the following Diagnostic Trouble Codes (DTCs): P061B-00 - Internal Conttrol Module Torque Calculation Performance. P1444-00 - Power Inverter Module - Incorrect Control Mode. P1E18-00 - Internal Control Module Electronic Park Performance. Customers may experience the following: At start up, the vehicle will shut down. At start up, the vehicle will not start This bulletin involves reprogramming the EVCU with the latest available software.

NHTSA · manufacturer bulletin11032829Model years 2024View details →
ProMaster III · 2006–
BulletinMinorElectricalNA

Bulletin

Flash: Electronic Vehicle Control Unit (EVCU) Updates Customers may experience a Malfunction Indicator Lamp (MIL) illumination and the vehicle may exhibit/set one or more of the following Diagnostic Trouble Codes (DTCs): P061B-00 - Internal Control Module Torque Calculation Performance. P1444-00 - Power Inverter Module - Incorrect Control Mode. P1E18-00 - Internal Control Module Electronic Park Performance. Customers may experience the following: At start up, the vehicle will shut down. At start up, the vehicle will not start. This bulletin involves reprogramming the EVCU with the latest available software.

NHTSA · manufacturer bulletin11032830Model years 2025View details →
ProMaster III · 2006–
BulletinMinorElectricalNA

Bulletin

Flash: Electronic Vehicle Control Unit (EVCU) Updates Customers may experience a Malfunction Indicator Lamp (MIL) illumination and the vehicle may exhibit/set one or more of the following Diagnostic Trouble Codes (DTCs): P061B-00 - Internal Control Module Torque Calculation Performance. P1444-00 - Power Inverter Module - Incorrect Control Mode. P1E18-00 - Internal Control Module Electronic Park Performance. Customers may experience the following: At start up, the vehicle will shut down. At start up, the vehicle will not start. This bulletin involves reprogramming the EVCU with the latest available software.

NHTSA · manufacturer bulletin11032653Model years 2025View details →
Older →

Sources: NHTSA (United States, public domain), Transport Canada (Open Government Licence – Canada), DVSA (United Kingdom, Open Government Licence v3.0), RappelConso and EU Safety Gate (France, Licence Ouverte 2.0), Japan's MLIT (Public Data License 1.0) and South Korea's MOLIT (car.go.kr).