Lettura libera · account gratuito per contribuireErede di Anticars (2000)

Audi RS7

2013– · 1 generazioni · 2 difetti documentati · 2 mercati
Generazioni
Tutte le generazioniRS72013–245729

I bollettini tecnici (TSB) sono istruzioni di riparazione che i costruttori inviano ai concessionari su problemi noti. Non sono richiami di sicurezza, ma spesso confermano un difetto.

Anno modello
MercatoTuttiNA
BollettinoModeratoMotoreNA

Bollettino

This bulletin provides informaiton when there is a leak on the oil hole between the planetary and the transfer box.

NHTSA · bollettino del costruttore11034705Anni modello 2016Mostrato in inglese originale · traduzione in attesaVedi dettagli →
BollettinoModeratoMotoreNA

Bollettino

This TSB provides information when thee is an oil leak from, or near the oil filter housing.

NHTSA · bollettino del costruttore11021471Anni modello 2021Mostrato in inglese originale · traduzione in attesaVedi dettagli →
BollettinoModeratoMotoreNA

Bollettino

A small amount of dry or crusted coolant is seen on the coolant pump housing (Figure 1, Figure 2, and Figure 3). The coolant level warning is not on. A minor coolant leak is possible during the break-in phase of the coolant seal on the coolant pump. The dry coolant marks are normal.

NHTSA · bollettino del costruttore10216674Anni modello 2014Mostrato in inglese originale · traduzione in attesaVedi dettagli →
BollettinoModeratoMotoreNA

Bollettino

This bulletin contains repair instructions for when there is an oil leak from the rear of the vehicle and the sealing caps are missing from the pressure limiting valves.

NHTSA · bollettino del costruttore10210738Anni modello 2021Mostrato in inglese originale · traduzione in attesaVedi dettagli →
BollettinoModeratoMotoreNA

Bollettino

This bulletin describes the repair procedure to address an internal defect in the EVAP leak detection pump causing false leak detection.

NHTSA · bollettino del costruttore10210233Anni modello 2021Mostrato in inglese originale · traduzione in attesaVedi dettagli →
BollettinoModeratoMotoreNA

Bollettino

This bulletin describes the repair procedure to address an internal defect in the EVAP leak detection pump causing false leak detection.

NHTSA · bollettino del costruttore10206879Anni modello 2021Mostrato in inglese originale · traduzione in attesaVedi dettagli →
BollettinoModeratoMotoreNA

Bollettino

There is an internal defect in the EVAP leak detection pump causing false leak detection.

NHTSA · bollettino del costruttore10205901Anni modello 2021Mostrato in inglese originale · traduzione in attesaVedi dettagli →
BollettinoModeratoMotoreNA

Bollettino

This bulletin contains repair instructions for when there is an oil leak from the rear of the vehicle and the sealing caps are missing from the pressure limiting valves.

NHTSA · bollettino del costruttore10200702Anni modello 2020–2021Mostrato in inglese originale · traduzione in attesaVedi dettagli →
BollettinoModeratoMotoreNA

Bollettino

This bulletin contains instructions for using the UV additive to find engine oil leaks.

NHTSA · bollettino del costruttore10186945Anni modello 2020Mostrato in inglese originale · traduzione in attesaVedi dettagli →
BollettinoModeratoMotoreNA

Bollettino

A small amount of dry or crusted coolant is seen on the coolant pump housing. The coolant level warning is not on. A minor coolant leak is possible during the break-in phase of the coolant seal on the coolant pump. The dry coolant marks are normal.

NHTSA · bollettino del costruttore10124868Anni modello 2014Mostrato in inglese originale · traduzione in attesaVedi dettagli →
BollettinoModeratoMotoreNA

Bollettino

Supersedes Technical Service Bulletin Group 10 number 10-02 dated September 14, 2010. Prior to engine replacement, any debris lodged in transferred assemblies must be removed. If the vehicle's engine experienced a serious mechanical problem, it is possible that small pieces of metal debris resulting from the mechanical problem may have become deposited in the intake manifold, air intake hoses, exhaust manifolds, exhaust down-pipes, turbocharger, supercharger, and/or intercooler. If these pieces are not removed prior to the installation and operation of the replacement engine, the pieces may be drawn into the combustion chamber, which can cause a knocking noise and subsequent serious engine damage.

NHTSA · bollettino del costruttore10121324Anni modello 2014Mostrato in inglese originale · traduzione in attesaVedi dettagli →
BollettinoLieveMotoreNA

Bollettino

This bulleti provides information when the fuel pressure is outside of tolerance, MIL is on, DTC P310B00.

NHTSA · bollettino del costruttore11026291Anni modello 2014Mostrato in inglese originale · traduzione in attesaVedi dettagli →
BollettinoLieveMotoreNA

Bollettino

Although the correct amount of oil was added to the engine during an oil change service, a check of the oil level shows that the oil level is not okay.

NHTSA · bollettino del costruttore10228289Anni modello 2014Mostrato in inglese originale · traduzione in attesaVedi dettagli →
BollettinoLieveMotoreNA

Bollettino

Although the correct amount of oil was added to the engine during an oil change service, a check of the oil level shows that the oil level is not okay.

NHTSA · bollettino del costruttore10224968Anni modello 2014Mostrato in inglese originale · traduzione in attesaVedi dettagli →
BollettinoLieveMotoreNA

Bollettino

This bulletin advises to replace the EVAP LD Pump if DTC P044200 or DTC P045600 are present under specific circumstances.

NHTSA · bollettino del costruttore10220368Anni modello 2021Mostrato in inglese originale · traduzione in attesaVedi dettagli →
BollettinoLieveMotoreNA

Bollettino

Although the correct amount of oil was added to the engine during an oil change service, a check of the oil level shows that the oil level is not okay.

NHTSA · bollettino del costruttore10221941Anni modello 2014Mostrato in inglese originale · traduzione in attesaVedi dettagli →
BollettinoLieveMotoreNA

Bollettino

A check with the engine oil service dipstick T40178 is necessary, but the adjustment values for the dipstick are not available in the Elsa repair manual. Because of a system change, the adjustment values for the service dipstick T40178 were removed from the repair manual.

NHTSA · bollettino del costruttore10216652Anni modello 2014Mostrato in inglese originale · traduzione in attesaVedi dettagli →
BollettinoLieveMotoreNA

Bollettino

Engine oils that meet Audi Oil Quality Standards.

NHTSA · bollettino del costruttore10216682Anni modello 2014Mostrato in inglese originale · traduzione in attesaVedi dettagli →
BollettinoLieveMotoreNA

Bollettino

The crankcase breather is only connected to the bank 2 turbocharger inlet. Blow-by gases from the crankcase breather discolor the pipe (Figure 1). This is a normal condition.

NHTSA · bollettino del costruttore10216704Anni modello 2013Mostrato in inglese originale · traduzione in attesaVedi dettagli →
BollettinoLieveMotoreNA

Bollettino

A highly sporadic startup timing issue can cause a message "CNG inspection Due! CNG Mode not available. Please contact workshop". This is a normal condition which can be resolved by recycling the ignition and repairs are not needed.

NHTSA · bollettino del costruttore10214760Anni modello 2022Mostrato in inglese originale · traduzione in attesaVedi dettagli →
BollettinoLieveMotoreNA

Bollettino

This bulletin advises how to identify and repair instances where a vehicle may stops due to a lack of fuel while the fuel gauge shows 1/4 tank or more of fuel.

NHTSA · bollettino del costruttore10214456Anni modello 2021Mostrato in inglese originale · traduzione in attesaVedi dettagli →
BollettinoLieveMotoreNA

Bollettino

Engine Intake & Exhaust Valve Springs

NHTSA · bollettino del costruttore10211918Anni modello 2022Mostrato in inglese originale · traduzione in attesaVedi dettagli →
BollettinoLieveMotoreNA

Bollettino

Engine Intake & Exhaust Valve Springs

NHTSA · bollettino del costruttore10211917Anni modello 2022Mostrato in inglese originale · traduzione in attesaVedi dettagli →
BollettinoLieveMotoreNA

Bollettino

A highly sporadic startup timing issue can cause a message "CNG inspection Due! CNG Mode not available. Please contact workshop". This is a normal condition which can be resolved by recycling the ignition and repairs are not needed.

NHTSA · bollettino del costruttore10212939Anni modello 2022Mostrato in inglese originale · traduzione in attesaVedi dettagli →
BollettinoLieveMotoreNA

Bollettino

This bulletin contains repair instructions from the exhaust system at idle speed DTCs P047600, P048C00, P04A000, or P301B00 are stored in the ECM.

NHTSA · bollettino del costruttore10209104Anni modello 2021Mostrato in inglese originale · traduzione in attesaVedi dettagli →
Meno recenti →

Fonti: NHTSA (Stati Uniti, pubblico dominio), Transport Canada (Open Government Licence – Canada), DVSA (Regno Unito, Open Government Licence v3.0), RappelConso e Safety Gate UE (Francia, Licence Ouverte 2.0), MLIT (Giappone, Public Data License 1.0) e MOLIT (Corea del Sud, car.go.kr).