Bollettino
An oil filter that is too short is installed. The oil filter must be 155 (+/-1) mm long. If the oil filter is too short, the drain flap in the oil filter housing will not be completely closed and oil pressure will be lost.
🔔 Crea un account gratuito per ricevere avvisi via e-mail su Audi S5 (tutte le generazioni)
I bollettini tecnici (TSB) sono istruzioni di riparazione che i costruttori inviano ai concessionari su problemi noti. Non sono richiami di sicurezza, ma spesso confermano un difetto.
An oil filter that is too short is installed. The oil filter must be 155 (+/-1) mm long. If the oil filter is too short, the drain flap in the oil filter housing will not be completely closed and oil pressure will be lost.
An oil filter that is too short is installed. The oil filter must be 155 mm.
An oil filter that is too short is installed. The oil filter must be 155 (+/-1) mm long. If the oil filter is too short, the drain flap in the oil filter housing will not be completely closed and oil pressure will be lost.
An oil filter that is too short is installed. The oil filter must be 155 mm.
An oil filter that is too short is installed. The oil filter must be 155 (+/-1) mm long. If the oil filter is too short, the drain flap in the oil filter housing will not be completely closed and oil pressure will be lost.
An oil filter that is too short is installed. The oil filter must be 155 mm.
Nel tempo e con la percorrenza, e in determinate condizioni, i catalizzatori installati in fabbrica potrebbero non funzionare come richiesto dalle normative federali. Se l'efficacia di un catalizzatore si riduce, ciò può comportare un aumento delle emissioni allo scarico e il veicolo potrebbe non superare la revisione delle emissioni. ? Aggiunta la disponibilità di riparazione per A8 (criterio 4E) e A6 (criterio 4F). ? Aggiornate le istruzioni per la richiesta di rimborso. ? Aggiunta una nota alle istruzioni di riparazione relativa ai danni consequenziali.
Over time and mileage and under certain conditions, the factory-installed catalysts may not perform as required by Federal regulations. If the effectiveness of a catalyst is reduced, this may result in an increase in tailpipe emissions and the vehicle could fail to pass an emissions inspection.
Supersedes Technical Service Bulletin Group 10 number 10-02 dated September 14, 2010. Prior to engine replacement, any debris lodged in transferred assemblies must be removed. If the vehicle's engine experienced a serious mechanical problem, it is possible that small pieces of metal debris resulting from the mechanical problem may have become deposited in the intake manifold, air intake hoses, exhaust manifolds, exhaust down-pipes, turbocharger, supercharger, and/or intercooler. If these pieces are not removed prior to the installation and operation of the replacement engine, the pieces may be drawn into the combustion chamber, which can cause a knocking noise and subsequent serious engine damage.
Audi: The oil filter, for some vehicles, are too short, (should be 155 (=/-1) mm long) for installation and drain flap, in oil filter housing, can not completely close causing lost of oil pressure. Model 2013 a6, a7, s4, s5, s5 cab, q7, q5. *pe
Audi: The coolant pump is leaking or the engine is overheating without a leak. *rm
Audi: Mil on (dtc p2146-p2157 for fuel injector supply voltage). Engine runs rough but does not stall. *pe
This bulletin provides information regarding an oil change when replacing the engine control unit.
This bulletin provides informatoinw hen the fuel tank level is implausible; DTC B105A1A B103E29.
This bulletin provides informatoinw hen the fuel tank level is implausible; DTC B105A1A B103E29.
This bulletin provides information regarding the oil change necessary when replacing an engine control unit.
This bulletin provides information for when there is an Engine Start system warning, or Power Unit start system warning, B200047.
This bulletin provides information to address the message "Switch off the engine and check coolant" with the DTC P000000
This bulletin advises to replace the fuel tank in instances where the fuel filler neck has a ridge or obstruction preventing filling the tank.
A highly sporadic startup timing issue can cause a message "CNG inspection Due! CNG Mode not available. Please contact workshop". This is a normal condition which can be resolved by recycling the ignition and repairs are not needed.
A highly sporadic startup timing issue can cause a message "CNG inspection Due! CNG Mode not available. Please contact workshop". This is a normal condition which can be resolved by recycling the ignition and repairs are not needed.
Upcoming Emissions Recall 50D3 ? Vehicle Emissions Control Information Label Certain 2018 MY Audi S4/S5. Certain model year 2018 vehicles have been incorrectly labeled with model year 2017 Vehicle Emissions Control Information labels instead of the correct model year 2018 label. This issue will not cause an emissions impact over the standard.
OIL CHART SECTION: CHANGED - Castrol Oil to 'Audi approved XXXX-Refer to the Parts Catalog' for all models.
OIL CHART SECTION: CHANGED - Castrol Oil to 'Audi approved XXXX-Refer to the Parts Catalog' for all models.
This informational bulletin contains details on conditions for replacing the water pump and/or thermostat housing. 2015-2019 A3 Cabriolet, 2017-2018 S3 Cabriolet, 2018-2019 A5 Sportback, S5 Sportback, 2013--2019 TTR
Fonti: NHTSA (Stati Uniti, pubblico dominio), Transport Canada (Open Government Licence – Canada), DVSA (Regno Unito, Open Government Licence v3.0), RappelConso e Safety Gate UE (Francia, Licence Ouverte 2.0), MLIT (Giappone, Public Data License 1.0) e MOLIT (Corea del Sud, car.go.kr).