Lettura libera · account gratuito per contribuireErede di Anticars (2000)

Mazda CX-50

2022– · 7 difetti documentati · 1 mercati

I bollettini tecnici (TSB) sono istruzioni di riparazione che i costruttori inviano ai concessionari su problemi noti. Non sono richiami di sicurezza, ma spesso confermano un difetto.

Anno modello
MercatoTuttiNA
BollettinoModeratoMotoreNA

Bollettino

Some customers may experience a hybrid system failure message appearing on the meter and the engine does not start, along with other numerous DTCs.

NHTSA · bollettino del costruttore11019993Anni modello 2025Mostrato in inglese originale · traduzione in attesaVedi dettagli →
BollettinoModeratoMotoreNA

Bollettino

Some customers may experience the audio sound pausing when the engine restarts after i-stop operation under the following situations. The symptoms are caused by an improper part installation in the audio amplifier. A voltage drop error detection of the power source may be too sensitive.

NHTSA · bollettino del costruttore11011135Anni modello 2023Mostrato in inglese originale · traduzione in attesaVedi dettagli →
BollettinoModeratoMotoreNA

Bollettino

Some customer's might state that they notice fluid or oil leaking/dripping on the ground when the vehicle is parked. For this concern, inspect the vehicle for any trace of a fluid or oil leak and use the following examples as a guide to determine if it is severe enough to require a repair, or just to clean the area and monitor it at the next service.

NHTSA · bollettino del costruttore11007010Anni modello 2025Mostrato in inglese originale · traduzione in attesaVedi dettagli →
BollettinoModeratoMotoreNA

Bollettino

Customers may report excess wind noise from the vehicle and that noise may be coming from the crossbars. As noted in the crossbar instructions, the crossbars should be removed when not in use to reduce fuel consumption from the increased drag and to reduce wind noise. Let the customer know that the instructions show how to install, remove, and adjust the crossbars.

NHTSA · bollettino del costruttore10213143Anni modello 2023Mostrato in inglese originale · traduzione in attesaVedi dettagli →
BollettinoLieveMotoreNA

Bollettino

Some customers may complain about a rattle noise coming from the engine compartment when accelerating or idling. This may be caused by play at the turbocharger wastegate pivot arm creating a rattle-type noise. To eliminate this concern, a wave washer has been added.

NHTSA · bollettino del costruttore11012338Anni modello 2024Mostrato in inglese originale · traduzione in attesaVedi dettagli →
BollettinoLieveMotoreNA

Bollettino

A tapping/rattling noise may be noticed from the valve train area. This operating condition can occur on new vehicles which have been delivered to Mazda dealers (due to loading and unloading from transport trucks or customers moving their vehicles in and out of their garages to wash the vehicle, etc.). This condition may also occur if the engine is not allowed to warm up after multiple cold starts.

NHTSA · bollettino del costruttore10235702Anni modello 2023Mostrato in inglese originale · traduzione in attesaVedi dettagli →
BollettinoLieveMotoreNA

Bollettino

When servicing SKYACTIV engine vehicles requiring to replace the Oil Galley Plug and Crush Washer, order the required part numbers below. These parts are not listed in GEPC and were previously listed as "non-serviceable" in the cylinder block diagram.

NHTSA · bollettino del costruttore10230865Anni modello 2023Mostrato in inglese originale · traduzione in attesaVedi dettagli →
BollettinoLieveMotoreNA

Bollettino

Some customers may complain of signs of oil on the struts or shock absorbers. In most cases the oil that is present is normal, and a result of the oil that remains on the shaft during the normal sweeping process of the shaft seal. Follow the inspection guidelines below to determine if the condition is a result of the normal sweeping process or a failure of the shaft seal.

NHTSA · bollettino del costruttore10226814Anni modello 2023Mostrato in inglese originale · traduzione in attesaVedi dettagli →
BollettinoLieveMotoreNA

Bollettino

Some customers may complain of signs of oil on the struts or shock absorbers. In most cases the oil that is present is normal, and a result of the oil that remains on the shaft during the normal sweeping process of the shaft seal. Follow the inspection guidelines below to determine if the condition is a result of the normal sweeping process or a failure of the shaft seal.

NHTSA · bollettino del costruttore10213185Anni modello 2023Mostrato in inglese originale · traduzione in attesaVedi dettagli →
BollettinoLieveMotoreNA

Bollettino

A tapping/rattling noise may be noticed from the valve train area. This operating condition can occur on new vehicles which have been delivered to Mazda dealers (due to loading and unloading from transport trucks or customers moving their vehicles in and out of their garages to wash the vehicle, etc.). This condition may also occur if the engine is not allowed to warm up after multiple cold starts.

NHTSA · bollettino del costruttore10210884Anni modello 2023Mostrato in inglese originale · traduzione in attesaVedi dettagli →

Fonti: NHTSA (Stati Uniti, pubblico dominio), Transport Canada (Open Government Licence – Canada), DVSA (Regno Unito, Open Government Licence v3.0), RappelConso e Safety Gate UE (Francia, Licence Ouverte 2.0), MLIT (Giappone, Public Data License 1.0) e MOLIT (Corea del Sud, car.go.kr).