Bollettino
Some customers may experience the master warning light and/or the "In-Vehicle Network Malfunction" warning message in the instrument cluster on with DTC B119F:01 (TCU - Tel antenna No. 1 malfunction) stored.
🔔 Crea un account gratuito per ricevere avvisi via e-mail su Mazda MX-30 (tutte le generazioni)
I bollettini tecnici (TSB) sono istruzioni di riparazione che i costruttori inviano ai concessionari su problemi noti. Non sono richiami di sicurezza, ma spesso confermano un difetto.
Some customers may experience the master warning light and/or the "In-Vehicle Network Malfunction" warning message in the instrument cluster on with DTC B119F:01 (TCU - Tel antenna No. 1 malfunction) stored.
Some vehicle may experience the i-ACTIVSENSE/ALH warning lights on and a system error messages may be found in the center display as well. DTC U3000:04 (FSC) is stored in memory DTC U3000:04 (FSC) - Forward sensing camera (FSC) internal malfunction This may be caused by a hardware failure in an internal device of the FSC that results in the malfunction detection. To eliminate this concern, the production process of the FSC has been modified.
DESCRIPTION Some vehicles may continue to display the recall notification "IMPORTANT NOTICE. VIEW VEHICLE STATUS MONITOR FOR DETAILS" on the center display even after the recall has been completed. NOTE: Once the warranty claim for the recall campaign is approved by Mazda Japan, the recall notification will be automatically removed via Connected Services on the following day or later. This condition may occur if the Connected Services subscription was canceled while the recall notification was still active. ACTION TO BE TAKEN If you encounter the situation above, use MDARS to manually remove the center display recall notification. Note: MDARS can only remove the recall notification when MCVV shows no CV contract.
This SA supersedes the previously issued SA(s) listed below. The changes are noted below in Red. SA-029/25 10/16/25 and 06/02/25 DESCRIPTION This service information provides testing and charging procedures in order to promote proper battery maintenance, to deliver new vehicles with fully charged batteries, and to reduce unnecessary battery replacement cost. For new vehicles in stock at the dealer, inspect and maintain the batteries periodically according to the repair procedure. REPAIR PROCEDURE HIGH VOLTAGE BATTERY MAINTENANCE Verify the State-of-charge (SOC) in the instrument cluster. MX-30 EV: If the SOC is lower than 26%, charge it to 50% (either by normal charging or quick charging). CX-90/CX-70 PHEV: If the SOC is lower than 1%, charge it to 10% (either by normal charging, quick charging or engine running).
This service information provides testing and charging procedures in order to promote proper battery maintenance, to deliver new vehicles with fully charged batteries, and to reduce unnecessary battery replacement cost. For new vehicles in stock at the dealer, inspect and maintain the batteries periodically according to the repair procedure.
Some vehicles may have recall notifications remain on the center display even after a recall is performed. NOTE: When the warranty claim for the recall campaign is accepted at Mazda Japan, the recall notification will be automatically deleted via the Connected Service on the next day or later. This situation occurs if the Connected Service subscription has been cancelled while the recall notifications remain.
Some customers may complain that the ambient temperature on the instrument cluster is displayed more than 50 F (10 C) lower than the actual temperature, resulting in insufficient performance of the air conditioning. This is caused by inappropriate soldering in the ambient temperature sensor. To eliminate this concern, the soldering process has been enhanced at the supplier.
Some vehicles may exhibit the initial setup of the Electric Parking Lock (EPL) does not complete and is indicated as 'incomplete' when performing the initial setup of the EPL. This is caused by the initial learning program of the EPL not setting properly. To eliminate this concern, the control software of the EPL has been modified.
Some customers may notice an abnormal noise (i.e. whine, groan, rattle or squeak) coming from the front combination lights when turning them on, or a few minutes after turning them off. The noise may be due to contamination by foreign matter during the manufacturing process. The fan motor bearing may become worn out during use. To eliminate the noise, the production process at the supplier and the material has been modified. NOTE: It is normal for some noise to occur within the first few seconds after starting the engine, when the front combination lights perform a self check (sweep).
Some customers may complain that the electric motor sound (also known as EV sound) is not heard. NOTE: The EV sound is provided for the driver to inform the vehicles behavior, such as level and changes of motor torque, by an electronically generated sound through the audio system, instead of an engine sound.
Some vehicles may experience the symptoms mentioned below, which can be fixed with the latest software update (Version 7000C0A-NA10_10004). NOTE: iPod, iPhone, and Apple CarPlayTM are registered trademarks of Apple Inc. Android and Android AutoTM are registered trademarks of Google LLC. The Bluetooth word mark and logos are registered trademarks owned by Bluetooth SIG, Inc. (Ver. 7000C0A-NA10_10004) fixes these software errors (bugs): The screen does not show proper picture when receiving SiriusXM data.
Some customers may complain about an intermittent Beep sound (popping sound) every 1-2 minutes while driving. This may be cause by a software error in the navigation SD card.
Some vehicles may exhibit the warning messages Safety and Driver Support Systems Temporarily Disabled or Front Radar Obscured. Drive Safely displayed in the instrument cluster despite no dirt on the front radar sensor while driving in specific locations as follows:
SPECIAL SERVICE PROGRAM SSPC8 - 2023 CX-9, 2023 MAZDA3, 2022-2023 MX-30 - REMOTE TUNER CONCERN. Mazda Motor Corporation has decided to conduct a Special Service Program on certain 2023 CX-9, 2023 Mazda3 and 2022-2023 MX-30 vehicles equipped with a Remote Tuner module. There are 16,405 U.S. vehicles in the United States affected by this SSP.Certain Remote Tuner modules were built with outdated software and therefore the power shutdown processing of the module may not be completed. In this condition, if the vehicle is left unused for a certain amount of time, the 12V battery may discharge and run out.
This service information provides testing and charging procedures in order to promote proper battery maintenance, to deliver new vehicles with fully charged batteries, and to reduce unnecessary battery replacement cost. For new vehicles in stock at the dealer, inspect and maintain the batteries periodically according to the repair procedure.
Some customers may complain that the ambient temperature on the instrument cluster is displayed more than 50 F (10C) lower than the actual temperature, resulting in insufficient performance of the air conditioning. This is caused by inappropriate soldering in the ambient temperature sensor. To eliminate this concern, the soldering process has been enhanced since December 2021 at the supplier.
Some customers may notice an abnormal noise (i.e. whine, groan, rattle or squeak) coming from the front combination lights when turning them on, or a few minutes after turning them off. The noise may be due to contamination by foreign matter during the manufacturing process. The fan motor bearing may become worn out during use. To eliminate the noise, the production process at the supplier and the material has been modified.
Some customers may complain about insufficient heater performance under -4 degree F (-20 degree C) or colder environment. This is caused when the air conditioner is set to the defroster mode, cold air bypasses around the PTC heater and the warmed air at the PTC heater is cooled down by the cold air around it. This results in insufficient heater performance. To eliminate this concern, the cold air around the PTC heater has been reduced and the control software of the heat pump control unit has been modified to increase the output temperature of the PTC heater.
Some vehicles may exhibit DTC U3000:04 (Telematics communication unit internal malfunction) stored after the connected service contract has been discontinued (only vehicles in which the customer opted out of CV services are affected - CSP04). This is caused by improper control software of telematics communication unit. To eliminate this concern, the control software of telematics communication unit has been modified.
Some vehicles may exhibit the following symptoms with DTC P05A0:00 (Active air shutter and the opening angle abnormality (sticking)) stored in memory. Symptom 1 [Mazda3 and CX-30]: The active air shutter is working, but DTC P05A0:00 is stored in memory. Cause 1: This is caused by improper control software of the PCM detecting the DTC immediately without performing the failsafe operation. When the active air shutter detects unusual torque, it is designed to repeat the open/close cycles up to three times as a failsafe to try to remove the object(s) which temporarily disturbed the movement. Symptom 2 [Mazda3, CX-30 and MX-30]: The active air shutter is frozen by snow and/or ice under freezing temperatures with DTC P05A0:00 stored in memory. Cause 2 [Mazda3 and CX-30]: When a temporary blocking of the active air shutter is expected to be caused by snow and/or ice and the intake air temperature is above the freezing point, DTC P05A0:00 may be unintentionally detected. [MX-30]: When a temporary blocking of the active air shutter is expected to be caused by snow and/or ice and the heater is turned on, DTC P05A0:00 may be unintentionally detected
Some customers may comlpain about an intermittent Beep sound (popping sound) every 1 ~ 2 minutes while driving. This may be cause by a software error in the navigation SD card.
Some customers may comlpain about an intermittent Beep sound (popping sound) every 1 ~ 2 minutes while driving. This may be cause by a software error in the navigation SD card.
This Service Information provides information on the AUXILIARY CHARGING SYSTEM for lead-acid battery and the POWER SAVING MODE for e-SKYACTIV.
Some vehicles may experience the symptoms mentioned below, which can be fixed with the latest software update (Version 7000C0A-NA02_11036).
This service bulletin provides testing and charging procedures in order to promote proper battery maintenance, to deliver new vehicles with fully charged batteries, and to reduce unnecessary battery replacement cost. For new vehicles in stock at the dealer, inspect and maintain the battery periodically according to the repair procedure.
Fonti: NHTSA (Stati Uniti, pubblico dominio), Transport Canada (Open Government Licence – Canada), DVSA (Regno Unito, Open Government Licence v3.0), RappelConso e Safety Gate UE (Francia, Licence Ouverte 2.0), MLIT (Giappone, Public Data License 1.0) e MOLIT (Corea del Sud, car.go.kr).