Lettura libera · account gratuito per contribuireErede di Anticars (2000)

Toyota Verso

2009–2018 · 1 generazioni · 10 difetti documentati · 3 mercati
Generazioni
Tutte le generazioniVerso2009–20181018
Anno modello
MercatoTuttiEUUK
RichiamoCriticoMotoreEU

Due to insufficient durability, the Exhaust Gas Recirculation (EGR) cooler may develop an internal coolant…

Due to insufficient durability, the Exhaust Gas Recirculation (EGR) cooler may develop an internal coolant leak which could create smouldering deposits inside the EGR cooler and the intake manifold.This may result in localised thermal damage in the intake system, which might lead to engine power reduction and to increased risk of fire.

Safety Gate · UE30 mar 2021A12/00444/21Anni modello 2015–2018Mostrato in inglese originale · traduzione in attesaVedi dettagli →
RichiamoModeratoMotoreEU

En raison de la carbonisation de l'huile et de la pression de contact élevée, la résistance de la chaîne…

En raison de la carbonisation de l'huile et de la pression de contact élevée, la résistance de la chaîne de l'arbre à cames de 7 mm peut être réduite. cela peut provoquer la rupture de la chaîne de l'arbre à cames, entraînant une panne moteur. cela peut entraîner une perte de contrôle du véhicule et augmenter le risque d'accidents et de blessures.

Safety Gate · UE · RappelConso · Francia10 ago 2026sr/02656/25Anni modello 2018–2019Mostrato in francese originale · traduzione in attesaVedi dettagli →
RichiamoModeratoMotoreUK

Engine may stall

Under certain conditions condense water in the intake air can corrode the needle bearing housing. Due to corrosion of the bearing housing the sealing between intake air and the electrical actuator circuit of the throttle body might not be water tight anymore. In the condition that water enters in the throttle body actuator circuit the water might cause a throttle body position misreading or short circuit inside the throttle body electrical actuation mechanism. This might trigger the engine to stall while driving.

DVSA · Regno Unito7 mar 2016R/2016/013Anni modello 2014–2015Mostrato in inglese originale · traduzione in attesaVedi dettagli →
RichiamoModeratoMotoreUK

Fuel may leak

The resin moulding around the fuel filter water sensor is inadequate. In low temperature environments this can affect the O ring and allow fuel to seep into the sensor. Consequently fuel can then leak out of the sensor through it's breather hole. Additionally maintenance schedules are incomplete.

DVSA · Regno Unito8 set 2014R/2014/070Anni modello 2014Mostrato in inglese originale · traduzione in attesaVedi dettagli →
RichiamoModeratoMotoreUK

Accelerator pedal may fail to return to idle

It has been identified that on affected vehicles condensation resulting from cold-weather use of the heater or other causes may form on the worn surface of a component within the throttle pedal assembly known as the friction device. If this occurs there is a possibility that in the worst case the accelerator pedal may return slowly or does not return to the engine idle position.

DVSA · Regno Unito6 feb 2010R/2010/010Anni modello 2009–2010Mostrato in inglese originale · traduzione in attesaVedi dettagli →

Fonti: NHTSA (Stati Uniti, pubblico dominio), Transport Canada (Open Government Licence – Canada), DVSA (Regno Unito, Open Government Licence v3.0), RappelConso e Safety Gate UE (Francia, Licence Ouverte 2.0), MLIT (Giappone, Public Data License 1.0) e MOLIT (Corea del Sud, car.go.kr).