공지
This bulletin provides informaiton when there is a leak on the oil hole between the planetary and the transfer box.
🔔 무료 계정을 만들고 Audi S8 (모든 세대) 이메일 알림 받기
기술 서비스 공지(TSB)는 제조사가 알려진 문제에 대해 딜러에게 보내는 수리 지침입니다. 안전 리콜은 아니지만 결함을 확인해 주는 경우가 많습니다.
This bulletin provides informaiton when there is a leak on the oil hole between the planetary and the transfer box.
The oil filter bypass valve on certain 2013 model year Audi 4.0L vehicles may not be present or may have been incorrectly installed during production.
This document contains the notice about an upcoming Service action on the oil filter bypass valve. The oil filter bypass valve may not be present or may have been incorrectly installed during production.
A small amount of dry or crusted coolant is seen on the coolant pump housing. The coolant level warning is not on. A minor coolant leak is possible during the break-in phase of the coolant seal on the coolant pump. The dry coolant marks are normal.
Audi service campaign: See document search button for owner letter. Under certain conditions the coolant pump may leak. *rm
This bulletin provides information when the fuel gauge does not show after filling up tank.
There may be slow coolant loss from the connections of the coolant feed pipe and coolant return pipe. High temperatures cause the coolant to become encrusted on the connection flange of the turbocharger (Figure 1).
A highly sporadic startup timing issue can cause a message "CNG inspection Due! CNG Mode not available. Please contact workshop". This is a normal condition which can be resolved by recycling the ignition and repairs are not needed.
A highly sporadic startup timing issue can cause a message "CNG inspection Due! CNG Mode not available. Please contact workshop". This is a normal condition which can be resolved by recycling the ignition and repairs are not needed.
Added Saga Part number for 0W40 oil: SAGA Part: G E55040S0
This bulletin contains instructions for an "oil minimum" message and low oil on the dipstick.
This bulletin contains instructions for diagnosing a damaged turbocharger and calling TAC.
This bulletin contains repair instructions for when the engine cannot be started or it is difficult, there is unusual noises when accelerating and/or there is reduced engine performance. 2016 S8+ 2016-2017 A8, S7, S8, RS7, and RS7+
Oil Capacity Table: Changed Oil Specs for all models
Oil Capacity Table: Changed Oil Specs for all models
Added Oil Capacity Chart at the end of the document.
Oil Capacity Table: For A3 B-Cycle 2.0 TFSI engine: Changed oil spec from 508/509** Castrol EDGE Professional 5W40 to 508/509** Castrol EDGE Professional 0W20 Long Life IV
This document contains the Audi maintenance schedule. The intervals shown in this table are based on vehicles operating under normal conditions. In case of severe conditions, such as extremely low temperatures, excessive dust, etc., it is necessary for certain operations to be carried out in between the given intervals. This applies particularly to engine oil changes and the cleaning or replacing of the air cleaner filter element.
The MIL is on. Customer may report that the engine runs irregularly. DTCs are stored in the ECM. On the camshaft adjustment valve, the filter element can loosen. There is no consequential damage from loosened particles in the oil circuit. They are gathered by the oil filter.
This informational bulletin explains why engine oil can be discolored.
This document contains the Audi maintenance schedule. First standard maintenance service at 5,000 miles or 1 year after delivery, whichever occurs first. Standard maintenance services thereafter occur at intervals of 10,000 miles or 1 year after the last standard maintenance service, whichever occurs first. First major maintenance service at 15,000 miles or 2 years after delivery, whichever occurs first. Major maintenance services thereafter occur at intervals of 20,000 miles or 2 years after the last major maintenance service, whichever occurs first. The intervals shown in this table are based on vehicles operating under normal conditions. In case of severe conditions, such as extremely low temperatures, excessive dust, etc., it is necessary for certain operations to be carried out in between the given intervals. This applies particularly to engine oil changes and the cleaning or replacing of the air cleaner filter element.
This document contains the Audi maintenance schedule. First standard maintenance service at 5,000 miles or 1 year after delivery, whichever occurs first. Standard maintenance services thereafter occur at intervals of 10,000 miles or 1 year after the last standard maintenance service, whichever occurs first. First major maintenance service at 15,000 miles or 2 years after delivery, whichever occurs first. Major maintenance services thereafter occur at intervals of 20,000 miles or 2 years after the last major maintenance service, whichever occurs first. The intervals shown in this table are based on vehicles operating under normal conditions. In case of severe conditions, such as extremely low temperatures, excessive dust, etc., it is necessary for certain operations to be carried out in between the given intervals. This applies particularly to engine oil changes and the cleaning or replacing of the air cleaner filter element.
The Audi 2.0L Third Generation TDI Engine
출처: NHTSA(미국, 퍼블릭 도메인), 캐나다 교통부(Open Government Licence – Canada), DVSA(영국, Open Government Licence v3.0), RappelConso 및 EU Safety Gate(프랑스, Licence Ouverte 2.0), 일본 국토교통성(공공데이터 이용약관 1.0), 한국 국토교통부(자동차리콜센터 car.go.kr).