공지
This bulletin provides informaiton when there is a leak on the oil hole between the planetary and the transfer box.
🔔 무료 계정을 만들고 Audi RS7 이메일 알림 받기
기술 서비스 공지(TSB)는 제조사가 알려진 문제에 대해 딜러에게 보내는 수리 지침입니다. 안전 리콜은 아니지만 결함을 확인해 주는 경우가 많습니다.
This bulletin provides informaiton when there is a leak on the oil hole between the planetary and the transfer box.
This TSB provides information when thee is an oil leak from, or near the oil filter housing.
A small amount of dry or crusted coolant is seen on the coolant pump housing (Figure 1, Figure 2, and Figure 3). The coolant level warning is not on. A minor coolant leak is possible during the break-in phase of the coolant seal on the coolant pump. The dry coolant marks are normal.
This bulletin contains repair instructions for when there is an oil leak from the rear of the vehicle and the sealing caps are missing from the pressure limiting valves.
This bulletin describes the repair procedure to address an internal defect in the EVAP leak detection pump causing false leak detection.
This bulletin describes the repair procedure to address an internal defect in the EVAP leak detection pump causing false leak detection.
There is an internal defect in the EVAP leak detection pump causing false leak detection.
This bulletin contains repair instructions for when there is an oil leak from the rear of the vehicle and the sealing caps are missing from the pressure limiting valves.
This bulletin contains instructions for using the UV additive to find engine oil leaks.
A small amount of dry or crusted coolant is seen on the coolant pump housing. The coolant level warning is not on. A minor coolant leak is possible during the break-in phase of the coolant seal on the coolant pump. The dry coolant marks are normal.
Supersedes Technical Service Bulletin Group 10 number 10-02 dated September 14, 2010. Prior to engine replacement, any debris lodged in transferred assemblies must be removed. If the vehicle's engine experienced a serious mechanical problem, it is possible that small pieces of metal debris resulting from the mechanical problem may have become deposited in the intake manifold, air intake hoses, exhaust manifolds, exhaust down-pipes, turbocharger, supercharger, and/or intercooler. If these pieces are not removed prior to the installation and operation of the replacement engine, the pieces may be drawn into the combustion chamber, which can cause a knocking noise and subsequent serious engine damage.
This bulleti provides information when the fuel pressure is outside of tolerance, MIL is on, DTC P310B00.
Although the correct amount of oil was added to the engine during an oil change service, a check of the oil level shows that the oil level is not okay.
Although the correct amount of oil was added to the engine during an oil change service, a check of the oil level shows that the oil level is not okay.
This bulletin advises to replace the EVAP LD Pump if DTC P044200 or DTC P045600 are present under specific circumstances.
Although the correct amount of oil was added to the engine during an oil change service, a check of the oil level shows that the oil level is not okay.
A check with the engine oil service dipstick T40178 is necessary, but the adjustment values for the dipstick are not available in the Elsa repair manual. Because of a system change, the adjustment values for the service dipstick T40178 were removed from the repair manual.
Engine oils that meet Audi Oil Quality Standards.
The crankcase breather is only connected to the bank 2 turbocharger inlet. Blow-by gases from the crankcase breather discolor the pipe (Figure 1). This is a normal condition.
A highly sporadic startup timing issue can cause a message "CNG inspection Due! CNG Mode not available. Please contact workshop". This is a normal condition which can be resolved by recycling the ignition and repairs are not needed.
This bulletin advises how to identify and repair instances where a vehicle may stops due to a lack of fuel while the fuel gauge shows 1/4 tank or more of fuel.
Engine Intake & Exhaust Valve Springs
Engine Intake & Exhaust Valve Springs
A highly sporadic startup timing issue can cause a message "CNG inspection Due! CNG Mode not available. Please contact workshop". This is a normal condition which can be resolved by recycling the ignition and repairs are not needed.
This bulletin contains repair instructions from the exhaust system at idle speed DTCs P047600, P048C00, P04A000, or P301B00 are stored in the ECM.
출처: NHTSA(미국, 퍼블릭 도메인), 캐나다 교통부(Open Government Licence – Canada), DVSA(영국, Open Government Licence v3.0), RappelConso 및 EU Safety Gate(프랑스, Licence Ouverte 2.0), 일본 국토교통성(공공데이터 이용약관 1.0), 한국 국토교통부(자동차리콜센터 car.go.kr).