공지
Bmw: Convenience charging electronics (kle) had high voltage (hv) connectors installed improperly, causing a no charge or failure of intermittent charging. *pe
🔔 무료 계정을 만들고 BMW i3 (모든 세대) 이메일 알림 받기
기술 서비스 공지(TSB)는 제조사가 알려진 문제에 대해 딜러에게 보내는 수리 지침입니다. 안전 리콜은 아니지만 결함을 확인해 주는 경우가 많습니다.
Bmw: Convenience charging electronics (kle) had high voltage (hv) connectors installed improperly, causing a no charge or failure of intermittent charging. *pe
텔레매틱스 모듈(TCB2)이 절전 모드에 들어가면, BMW 데이터 서비스의 원격 서비스 트리거(원격 엔진 시동, 잠금/잠금 해제/기후 조절)는 TCB2를 재활성화할 수 없습니다. 이 문제로 인해 주차 및 잠금된 상태에서는 원격 서비스가 작동하지 않습니다.
The electrical system of BMW vehicles has been subject to an ongoing development process over the last few years. This has led to increased demands being placed on the battery. This document covers important information for the dealer on how to handle discharged battery complaints.
DELIVERY STOP: CHARGING CABLE (NON-TURBOCORD VERSION): BMW AG has issued a Delivery Stop (effective May 3, 2021) on a small number of Model Year 2021 BMW i3 vehicles that were produced between March 1, 2021 and April 26, 2021. The vehicle cannot be charged on Level 1 because the Occasional Use Charging Cable (Standard OUC/Level 1/Mode 2), may have not been included.
The vehicle may exhibit any of the following at very low State of Charge (SOC) ? less than 8%: - Power loss or high voltage system shutdown while running range extender (REx). - Inconsistent performance of the REx. - High voltage system shutdown in vehicles without REx. - Excessively high range displayed in instrument cluster.
Shipping specific non-deployed vehicle safety devices to lighting resources, llc. This service Information bulletin provides information on shipping "specific" noin-deployed vehicle safety devices that are classified as Dangerous Goods (DG) to Lighting resources, LLC
Covered under the terms of the BMW New Vehicle Limited Warranty for Passenger Cars and Light Trucks for
Shipping specific non-deployed vehicle safety devices to lighting resources, LLC
Displayed Range is Lower after Programming. After the vehicle is programmed with ISTA/P 3.53.3 (i-level I001-14-07-503), the displayed vehicle range in the instrument cluster is lower than prior to the software update. The actual range that the vehicle is capable of achieving on a full charge has not changed. The difference between the displayed range and actual range is always conservative, yet this difference varies based on driving profile. When driving primarily at highway speeds, the differnece between displayed and actual range is within a few percent of each other. When driving primarily with a low speed/city profile, the gap may widen to as much as 20% or more. In addition, the customer may notice that the vehicles range has decreased as outside temperatures have gotten colder. This is most noticeable in extreme cold climates, and when preconditioning is not used. This situation does not indicate a problem and is independent of the range display algorithm. CAUSE The algorithm that determines the displayed range, was changed with the 14-07-503 software level. The result of the changed algorithm is that the display is too conservative.
After programming the displayed range appears to be lower prior to software update *cn
Positive or negative terminal on cable connection can be moved which causes 12volt battery adapters to appear loose *cn
Bmw: Some vehicles experience high voltage charging cable not able to disconnect and/or unlock, charging socket lights up white and fails to change colors and not able to charge via high voltage charging procedure. Model 2014 i3. *pe
Bmw model i01( i3 and i3rex): Bulletin information replacing faulty convenience charging electronics (kle) could cause increased vehicle charging times. *lj
Bmw i01(i3 and i3 rex) : Information regarding cause of high-voltage battery stop charging, in some cases the battery will not charge above 34% even out of transport mode. *lj
Bmw i01(i3 and i3 rex: Information regarding customer concerns of intermittent charging failures or no charging at all. *lj
Bmw model i01(i3 and i3 rex) : Information regarding the left side motor mount or motor mount support has failed. The electric drivetrain moves excessively in the chassis. *lj
Bmw: Vehicle programmed; actual range vehicle capable of achieving to full charge not changed due to instrument cluster showing range lower than prior update of software. *pe
Bmw: Level 2 charge will cause vehicle to increase charging time due to convenience charging electronics (kle), with faulty fitted capacitor. *pe
Bmw: High voltage battery fails to charge above certain state when performing vehicle pdi and causes led ring around charge port to blink red. *pe
Bmw: From rear of vehicle, banging noise is hear during load reversals, due to motor mount support or left side motor mount has failed causing electric drivetrain, within chassis, to move excessively. *pe
Bmw: With drivetrain malfunction message displayed and service engine soon, engine can go into reduced power mode, due to engine position management (epm) unfavorable parameters in dme software. *pe
Bmw: There is no drivability issues, or functionality, or emissions-related problems of check engine lamp (cel), due to an intermittent cel being illuminated. Model i01 (i3). *pe updated 9/4/14. *pe
Bmw: A message, red or yellow check control, is displayed in instrument panel, after switching the ignition off. Model i01. *pe
Bmw: On some vehicles, there may be a fault code (21f046) stored in the high voltage battery management electronics. Model i3 and i3 rex. Produced to 6/30/14. *js
출처: NHTSA(미국, 퍼블릭 도메인), 캐나다 교통부(Open Government Licence – Canada), DVSA(영국, Open Government Licence v3.0), RappelConso 및 EU Safety Gate(프랑스, Licence Ouverte 2.0), 일본 국토교통성(공공데이터 이용약관 1.0), 한국 국토교통부(자동차리콜센터 car.go.kr).