무료 열람 · 무료 계정으로 기여Anticars(2000)의 후속

LexusLexus RX IV

2015–2022 · 결함 9건 · 4개 시장

기술 서비스 공지(TSB)는 제조사가 알려진 문제에 대해 딜러에게 보내는 수리 지침입니다. 안전 리콜은 아니지만 결함을 확인해 주는 경우가 많습니다.

심각도전체경미
연식
시장전체NA
공지경미엔진NA

공지

Fuel Injection Active Test Remedy - 2GR-FKS and 8AR-fts

NHTSA · 제조사 공지10205388연식 2016원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
공지경미엔진NA

공지

TT: The current engine active test Control the Injection Mode? is not operating as desired when controlling the direct injectors manually on 2GR-FKS engines. When direct injection is started and then stopped using the active test, current ECU logic does not turn off the direct injectors and can cause DTCs P017200, P017500 and P0160300. To avoid this condition, technicians should raise engine RPM when changing back and forth between the Direct Injection and Port Injection active tests. Use the recommended procedure below to avoid this concern while testing injection mode of FKS equipped vehicles. NOTE: If the active test is used multiple times without using this procedure to raise engine RPM, it may be necessary to reset learning values for fuel trim and Air to Fuel ratio before returning vehicle to customer.

NHTSA · 제조사 공지10153281연식 2020원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
공지경미엔진NA

공지

TT: TMS has discovered the current engine active test ?Control the Injection Mode? is not operating as desired when controlling the direct injectors manually on 2GR-FKS or 8AR-FTS engines. When direct injection is started and then stopped using the active test, current ECU logic does not turn off the direct injectors and can cause DTCs P017200, P017500 and P0160300. In order to avoid this condition, technicians should raise engine RPM when changing from Direct Injection active test to Port Injection active test. Use the recommended procedure below to avoid this concern while testing injection mode of 2GR-FKS or 8AR-FTS equipped vehicles. NOTE: If the active test is used multiple times without using this procedure to raise engine RPM, it may be necessary to reset learning values for fuel trim and Air to Fuel ratio before returning vehicle to customer.

NHTSA · 제조사 공지10152276연식 2016원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
공지경미엔진NA

공지

TSB: Some 2013 ? 2016 model year FR-S vehicles may exhibit a high pitch chirp or squeak noise from the high pressure Fuel Pump Assembly when the engine is fully warmed-up and idling. Follow the procedure in this bulletin to address this condition.

NHTSA · 제조사 공지10132906연식 2016원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
공지경미엔진NA

공지

"tt: Tms has discovered the current engine active test control the injection mode is not operating as desired when controlling the direct injectors manually on 2gr-fks or 8ar-fts engines. When direct injection is started and then stopped using the active test, current ecu logic does not turn off the direct injectors and can cause dtcs p017200, p017500 and p0160300. In order to avoid this condition, technicians should raise engine rpm when changing from direct injection active test to port injection active test. Use the recommended procedure below to avoid this concern while testing injection mode of 2gr-fks or 8ar-fts equipped vehicles. Note: If the active test is used multiple times without using this procedure to raise engine rpm, it may be necessary to reset learning values for fuel trim and air to fuel ratio before returning vehicle to customer."

NHTSA · 제조사 공지10093695연식 2016원문(영어)으로 표시 중 · 번역 대기자세히 보기 →

출처: NHTSA(미국, 퍼블릭 도메인), 캐나다 교통부(Open Government Licence – Canada), DVSA(영국, Open Government Licence v3.0), RappelConso 및 EU Safety Gate(프랑스, Licence Ouverte 2.0), 일본 국토교통성(공공데이터 이용약관 1.0), 한국 국토교통부(자동차리콜센터 car.go.kr).