The forward outboard pedestal of the seat track of the driver's seat may be susceptible to fatigue fracture. Fracture of this pedestal would permit a limited degree of rocking motion of the driver's seat assembly upon acceleration or deceleration. Breakage of the bracket could, potentially, affect the driver's control of the vehicle and result in an accident. Correction: A reinforcement will be installed on the seat track or the seat track will be replaced if fractured.
캐나다 교통부1989년 11월 6일1989155연식 1985–1987원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
The forward screw which provides part of the attachment between the driver`s seat back assembly and the seat cushion frame could fracture and permit the driver's seat back to pivot rearward. Such a condition could adversely affect the driver's ability to control the vehicle and could result in a vehicle crash. Correction: New driver's seat cushion attachment screws will be installed on affected vehicles.
캐나다 교통부1988년 5월 17일1988066연식 1983–1984원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
The rear seat belt retractors may allow twisted webbing to enter the retractor housing. Twisted webbing may wedge between the retractor spool and housing producing a jammed retractor condition which interfered with webbing retraction and withdrawal.
캐나다 교통부1985년 6월 14일1985074연식 1982–1983원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
Rear seat belt retractors may allow twisted webbing to enter the retractor housing and jam the retractor. Consequence of defect: A jammed retractor would interfere with webbing retraction and withdrawal. This will discourage seat belt usage.
NHTSA · 미국1985년 5월 21일85V067000연식 1982–1983원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
On vehicles with optional front seat recliners, the upper shoulder screw that attaches the driver's seat back frame to the recliner mechanism may be susceptible to fatigue fracture. If fatigue fracture of the recliner upper attachment screw were to occur on the driver's seat, the seat back could rotate rearward to a near horizontal position without warning potentially affecting the driver's control of the vehicle.
캐나다 교통부1984년 7월 19일1984087연식 1981원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
When severely loaded by a frontal impact, the seat belt webbing may contact the leading edge of the front seat-back stell reinforcement plates. This may cause the seat belt webbing to be abraded, cut or completely severed, thereby significantly increasing the risk of serious personal injuries.
캐나다 교통부1984년 6월 19일1984078연식 1981–1983원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
The bolts that attach the d-shaped ring for the shoulder belt are inadequately supported by the material in which they are mounted. The attachment does not comply with the requirements of federal motor vehicle safety standard no. 210, "seat belt assembly anchorages".
NHTSA · 미국1983년 12월 20일83V134000연식 1984원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
The upper torso restraint d-ring which attaches the shoulder belt to the b pillar, under certain test conditions, separated from its anchorage, and may not comply with cmvss 210 - belt anchorage.
캐나다 교통부1983년 12월 17일1983114연식 1984원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
The portion of the roof above frame (rail) to which the shoulder belt is anchored may have a slot that can compromise the strength of the shoulder belt anchor under certain severe loads. (the suspect area is not visible.) consequently, some vehicles included in this recall may not meet the 3000 pound anchorage strength requirements of federal motor vehicle safety standard 210, "seat belt assembly anchorages".
NHTSA · 미국1983년 2월 17일83V013000연식 1981–1982원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
출처: NHTSA(미국, 퍼블릭 도메인), 캐나다 교통부(Open Government Licence – Canada), DVSA(영국, Open Government Licence v3.0), RappelConso 및 EU Safety Gate(프랑스, Licence Ouverte 2.0), 일본 국토교통성(공공데이터 이용약관 1.0), 한국 국토교통부(자동차리콜센터 car.go.kr).