리콜보통차체KR
실내 후방 거울(리어뮤 미러)의 장착 브라켓에 접착제가 충분히 도포되지 않아 실내 후방 거울이 앞유리에서 부분적으로 또는 완전히 분리될 수 있으며, 이로 인해 실내 후방 거울이 분리될 경우 주행 중 후방 시야 확보에 영향을 줄 수 있으며, 사고 발생 시 탑승자 부상 위험이 증가할 수 있음이 확인됨에 따른 리콜
<대상차량별 생산일자> MINI Aceman E: 2026.04.08~2026.04.11 MINI Aceman SE: 2026.03.25~2026.04.11
MINI Cooper SE: 2026.03.24~2026.04.09 MINI John Cooper Works Aceman E: 2026.04.11
리콜보통차체UK
For affected vehicles the interior mirror mounting plate may not have been bonded to the windscreen sufficiently. The rear view mirror could become partially or even completely detached from the windshield.
리콜보통엔진EU
L'arbre creux du servomoteur a été mal soudé. la soudure peut ne pas être en mesure de résister à l'accumulation de pression de freinage élevée et peut se casser. dans ce cas, les performances de freinage réduites nécessitent une plus grande force et la distance de freinage peut augmenter. en outre, les systèmes de commande de frein abs et dsc ne sont pas assistés. cela augmente le risque d'accident.
리콜보통차체KR
실내 후방 거울(리어뷰 미러)의 장착 브라켓에 접착제가 충분히 도포되지 않아 실내 후방 거울이 앞유리에서 부분적으로 또는 완전히 분리될 수 있으며, 실내 후방 거울이 분리될 경우 주행 중 후방 시야 확보에 영향을 줄 수 있고 사고 발생 시 탑승자의 부상 위험이 증가할 수 있음이 확인됨에 따른 리콜
<대상차량별 생산일자> MINI Aceman E: 2026.04.08~2026.04.11 MINI Aceman SE: 2026.03.25~2026.04.11 MINI Cooper SE: 2026.03.24~2026.04.09 MINI John Cooper Works Aceman E: 2026.04.11 MINI John Cooper Works E: 2026.03.26
리콜보통차체UK
The Safety Recall relates to the interior rear-view mirror. The interior mirror mounting plate may not have been bonded to the windscreen sufficiently. Due to an insufficient adhesive surface on the mounting plate (bracket) the rearview mirror could become partially or even completely detached from the windshield. If the rearview mirror becomes partially or even completely detached this could impair the visibility while driving. In the event of an accident this could increase the risk of injury.
리콜보통전장UK
On affected vehicles specific cells of the HV battery may not have been produced according to specification. This could result in a short circuit and could increase the risk of a thermal event even when the vehicle is parked.
리콜보통전장UK
On affected vehicles specific cells of the High Voltage battery may have been pre-damaged during production handling.
리콜보통전장UK
On affected vehicles specific cells of the High Voltage battery may not have been produced according to specification. This could lead to the risk of a thermal event even when the vehicle is not in operation.
리콜보통브레이크EU
The hollow shaft of the servomotor has been welded incorrectly. The weld may not be able to withstand high braking pressure build-up and may break. In this case, the reduced braking performance requires greater force and the braking distance may increase. In addition, the ABS and DSC brake control systems are not assisted. This increases the risk of an accident.
리콜보통전장UK
On affected vehicles specific cell modules of the High Voltage (HV) battery may not have been produced according to specification.
리콜보통브레이크UK
On affected vehicles the brake servomotor was improperly welded. The weld seam might not withstand the stresses caused under high brake pressure leading to a requirement for a higher brake effort increasing the braking distance.
리콜보통브레이크UK
On certain vehicles the Integrated Brake (IB) system may be impaired due to contamination between electrical contacts.
출처: NHTSA(미국, 퍼블릭 도메인), 캐나다 교통부(Open Government Licence – Canada), DVSA(영국, Open Government Licence v3.0), RappelConso 및 EU Safety Gate(프랑스, Licence Ouverte 2.0), 일본 국토교통성(공공데이터 이용약관 1.0), 한국 국토교통부(자동차리콜센터 car.go.kr).