무료 열람 · 무료 계정으로 기여Anticars(2000)의 후속

Nissan 패스파인더

1985– · 7 세대 · 결함 67건 · 6개 시장
세대
연식
패스파인더 III · 2004–2014
리콜심각엔진NA

Fuel System

On certain vehicles, the molded fuel tanks are slightly thinner than specification in the area under the fuel sender unit. This may allow the tank floor to deform causing the fuel sender float to interfere with other features inside the tank. This could cause the instrument panel fuel gauge to show a fuel level of approximately one quarter tank when the fuel tank is empty. An inaccurate fuel gauge can lead to engine stalling while driving, which may increase the risk of a crash causing property damage, personal injury or death. Correction: Letters will be sent to owners in two stages. The first letter will advise owners of fuel gauge inaccuracy and recommend maintaining a fuel level above the one half position. The second letter will follow, requesting owners bring their vehicles to a dealer for replacement of the fuel sender unit.

캐나다 교통부2010년 3월 3일2010061연식 2006–2008원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
패스파인더 Infiniti QX4 · 1996–2002
리콜심각엔진NA

Fuel system, gasoline:Storage:Tank assembly:Filler pipe and cap

On certain vehicles originally sold in or currently registered in the states of connecticut, delaware, iowa, illinois, indiana, kentucky, massachusetts, maine, maryland, michigan, minnesota, new hampshire, new jersey, new york, ohio, pennsylvania, rhode island, tennessee, vermont, virginia, west virginia , wisconsin and the district of columbia, during the coating process of the fuel filler tube assembly, an insufficient amount of coating may have been applied at the lower mounting bracket. This could result in an opening in the coating which can allow water to enter and make contact with the bare metal of the tube.

NHTSA · 미국2007년 9월 18일07V435000연식 1997–2001원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
패스파인더 Infiniti QX4 · 1996–2002
리콜심각엔진NA

Fuel System

On certain vehicles, inadequate coating of the fuel filler tube assembly could allow water to penetrate past the coating and cause surface rust. In areas which use heavy concentrations of road salt in the winter, corrosion may occur to a degree which results in perforation of the tube. In this case, fuel leakage may occur when filling the tank or shortly thereafter. Fuel leakage, in the presence of an ignition source, could result in a fire. Correction: Dealers will replace the fuel filler tube assembly.

캐나다 교통부2007년 9월 13일2007300연식 1997–2001원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
패스파인더 III · 2004–2014패스파인더 IV · 2012–2020
리콜보통엔진NA

Engine and engine cooling

Nissan is recalling certain model year 2011 infiniti fx, model year 2012 infiniti m, model year 2011-2012 nissan frontier, model year 2011-2012 nissan xterra, model year 2011-2012 nissan pathfinder, and model year 2012 nissan nv vehicles. Some of the bolts that connect the engine oil cooler and the engine oil filter to the engine in these vehicles may have been manufactured to below specification strength. As a result, the bolt may break at the oil filter attachment point and can cause an engine oil leak.

NHTSA · 미국2011년 12월 19일11V592000연식 2011–2012원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
패스파인더 II · 1995–2004패스파인더 III · 2004–2014
리콜보통엔진UK

Engine may stall & fail to restart

It has been identified that it is possible that the contacts in engine control module (ECM) and ignition relay situationed in the Intelligent Power Distribution Module (IPDM) may become contaminated with silicon oxide due to the evaporating of the silicon from within the units. In extreme cases this could result in the stalling of the engine and the failure to restart the engine.

DVSA · 영국2010년 11월 29일R/2010/185연식 2004–2006원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
패스파인더 III · 2004–2014
리콜보통엔진NA

Fuel system, gasoline:Storage:Auxillary tank

Nissan is recalling certain model year 2006 and model year 2008 frontier, xterra and pathfinder vehicles. The molded fuel tank shells can deform, causing the fuel sender float arm to contact an embossment molded into the tank shell causing the instrument panel fuel gauge to show that the vehicle has approximately one quarter tank when the fuel tank is empty.

NHTSA · 미국2010년 3월 3일10V075000연식 2006–2008원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
패스파인더 III · 2004–2014
리콜경미엔진NA

Engine

On certain vehicles, the engine oil cooler stud (onto which the oil filter is mounted) could fail. This could cause an engine oil leak, which could illuminate the instrument panel's engine oil warning lamp. Abnormal noise and rough engine performance may also be noticed and, in the worst case, the engine could fail and stop suddenly while the vehicle is in motion. Engine failure would result in lost vehicle propulsion which, in conjunction with traffic and road conditions, and the driver's reactions, could increase the risk of a crash causing property damage and/or personal injury. Correction: Dealers will replace the engine oil cooler connector stud.

캐나다 교통부2011년 12월 20일2011436연식 2011원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
패스파인더 II · 1995–2004패스파인더 III · 2004–2014
리콜경미엔진NA

Engine

On certain vehicles the Intelligent Power Distribution Module (IPDM) assembly contains an Engine Control Module (ECM) relay that has a diode for electrical current noise reduction. The ECM relay may allow silicon vapor to form and over time the silicon evaporates from the diode molding which causes silicon oxide to develop on the ECM relay contact due to arcing. In certain instances, this oxidation could cause engine performance issues (hesitation, rough engine idle, slow start/no-start condition), and engine stalling at low engine speeds which may result in a crash. Correction: Dealers will replace the Engine Control Module (ECM) relay.

캐나다 교통부2010년 10월 28일2010373연식 2004–2006원문(영어)으로 표시 중 · 번역 대기자세히 보기 →
패스파인더 III · 2004–2014
리콜경미엔진NA

Engine and engine cooling

Nissan is recalling certain model year 2004-2006 armada, titan, infiniti qx56 and model year 2005-2006 frontier, pathfinder and xterra vehicles. The intelligent power distribution module (ipdm) assembly contains an engine control module (ecm) relay that has a diode for electrical current noise reduction. The ecm relay may allow silicon vapor to form and, over time, the silicon evaporates from the diode molding which causes silicon oxide to develop on the ecm relay contact due to arcing.

NHTSA · 미국2010년 10월 28일10V517000연식 2005–2006원문(영어)으로 표시 중 · 번역 대기자세히 보기 →

출처: NHTSA(미국, 퍼블릭 도메인), 캐나다 교통부(Open Government Licence – Canada), DVSA(영국, Open Government Licence v3.0), RappelConso 및 EU Safety Gate(프랑스, Licence Ouverte 2.0), 일본 국토교통성(공공데이터 이용약관 1.0), 한국 국토교통부(자동차리콜센터 car.go.kr).