무료 열람 · 무료 계정으로 기여Anticars(2000)의 후속
로그인계정 만들기
NANHTSA · 제조사 공지11038748

기술 서비스 공지

원문(영어)으로 표시 중 · 번역 대기

Not applicable to vehicles built for US market. Corner Radar Dynamic Alignment Calibration Issue IMPORTANT! **The DTC listed below may set when the Radar Dynamic Alignment procedure is SYMPTOM: unsuccessful. The procedure should only be started when a radar is replaced or when bumpers are removed/reinstalled. Before performing the procedure, make sure the reported problem actually concerns the radars. If any Diagnostic Trouble Codes (DTCs) or conditions/symptoms different from those described below are detected, record them in the repair order and carry out the necessary actions before continuing with the additional instructions in this bulletin.** **Technicians must experience a malfunction of ADAS systems and the vehicle must exhibit/set the following DTC on one or more corner radars:** B2EF9-78 - Alignment Of The Corner Radar Completed With Failure : Alignment Not Carried Out. Technicians will also experience the following: Unable to successfully perform the corner radar dynamic alignment procedure. This bulletin involves reprogramming the corner radars with the latest software then performing the Sensor/ Proximity Radar Calibration procedure

해당: Jeep Compass II (연식 2026)

공식 공지 ↗

출처: NHTSA(미국, 퍼블릭 도메인), 캐나다 교통부(Open Government Licence – Canada), DVSA(영국, Open Government Licence v3.0), RappelConso 및 EU Safety Gate(프랑스, Licence Ouverte 2.0), 일본 국토교통성(공공데이터 이용약관 1.0), 한국 국토교통부(자동차리콜센터 car.go.kr).