공지
Start Stop Charging Warning Lamp Illuminated On, Intelligent Battery Sensor (IBS) State of Charge (SOC) Inaccurate, Battery Charging Message, Presence of IBS related Diagnostic Trouble Codes (DTCs), or Battery Warning Lamp On
🔔 무료 계정을 만들고 Ram ProMaster (모든 세대) 이메일 알림 받기
기술 서비스 공지(TSB)는 제조사가 알려진 문제에 대해 딜러에게 보내는 수리 지침입니다. 안전 리콜은 아니지만 결함을 확인해 주는 경우가 많습니다.
Start Stop Charging Warning Lamp Illuminated On, Intelligent Battery Sensor (IBS) State of Charge (SOC) Inaccurate, Battery Charging Message, Presence of IBS related Diagnostic Trouble Codes (DTCs), or Battery Warning Lamp On
No Start, Cannot Complete Module Replace, Proxi Or Module Proxi Configuration
Updated Fuel Filler Cap This bulletin involves updating the fuel filler cap with improved version. Customers may experience a Malfunction Indicator Lamp (MIL) illumination. Upon further investigation the technician may find that one or more of the following Diagnostic Trouble Codes (DTCs) have been set: P0455 - EVAP System Large Leak. P0456 - EVAP System Small Leak. P04EC - EVAP System Large Leak Detected - Fuel Tank Side. P04EE - EVAP System Very Small Leak Detected - Fuel Tank Side.
Telematic box module 2 For customer concern of Uconnect box error popup on the screen every time the vehicle is turned on. A missing security certificate or after a new TBM installed, or any active DTC set by TBM will trigger this popup. Please refer to STAR Online S2108000015 for more information. If you continually see this popup message, also see an active B22A9-93 DTC, please use wiTECH tool to check TBM2 module and record the failure information as shown on STAR Online S228A000003. Before replacing the TBM module, please check connections behind the TBM, the antenna and harness for improper connection and damage. Please call FCA Redacted Content
Updated Fuel Filler Cap This bulletin involves updating the fuel filler cap with improved version. Customers may experience a Malfunction Indicator Lamp (MIL) illumination. Upon further investigation the technician may find that one or more of the following Diagnostic Trouble Codes (DTCs) have been set: P0455 - EVAP System Large Leak. P0456 - EVAP System Small Leak. P04EC - EVAP System Large Leak Detected - Fuel Tank Side. P04EE - EVAP System Very Small Leak Detected - Fuel Tank Side.
Updated Fuel Filler Cap This bulletin involves updating the fuel filler cap with improved version. Customers may experience a Malfunction Indicator Lamp (MIL) illumination. Upon further investigation the technician may find that one or more of the following Diagnostic Trouble Codes (DTCs) have been set: P0455 - EVAP System Large Leak. P0456 - EVAP System Small Leak. P04EC - EVAP System Large Leak Detected - Fuel Tank Side. P04EE - EVAP System Very Small Leak Detected - Fuel Tank Side.
Telematic box module 2 For customer concern of Uconnect box error popup on the screen every time the vehicle is turned on. A missing security certificate or after a new TBM installed, or any active DTC set by TBM will trigger this popup. Please refer to STAR Online S2108000015 for more information. If you continually see this popup message, also see an active B22A9-93 DTC, please use wiTECH tool to check TBM2 module and record the failure information as shown on STAR Online S228A000003. Before replacing the TBM module, please check connections behind the TBM, the antenna and harness for improper connection and damage. Please call FCA Redacted Content
No Start, Cannot Complete Module Replace, Proxi Or Module Proxi Configuration
Install Intake Air Temperature Sensor Jumper Harness.
Install Intake Air Temperature Sensor Jumper Harness.
MIL Lamp On, No Start
Intelligent Battery Sensor-IBS Installation, Battery Charging Message, Start Stop Charging Warning Lamp Illuminated On Stop Start Equipped Vehicles
Radio If this radio is installed in a vehicle equipped with the Radio Prep Package (sales code RA9), the vehicle harness connector will require relocation of the of A4, F20(BL/LG) and A7, A933 (RD/YL) circuits for radio operation. These two terminals must be swapped in the the connector. Failure to do so will result in the radio prompting the user to enter the security code every time the key is cycled.
Radio If this radio is installed in a vehicle equipped with the Radio Prep Package (sales code RA9), the vehicle harness connector will require relocation of the of A4, F20(BL/LG) and A7, A933 (RD/YL) circuits for radio operation. These two terminals must be swapped in the the connector. Failure to do so will result in the radio prompting the user to enter the security code every time the key is cycled.
Radio If this radio is installed in a vehicle equipped with the Radio Prep Package (sales code RA9), the vehicle harness connector will require relocation of the of A4, F20(BL/LG) and A7, A933 (RD/YL) circuits for radio operation. These two terminals must be swapped in the the connector. Failure to do so will result in the radio prompting the user to enter the security code every time the key is cycled.
Battery Prior to replacing the battery, please check the component to determine if there is any acid leaking from the unit. If the answer is yes, please contact Bruce Davis at Cell (248) 613-5637 for further instructions. If the answer is no, please proceed with the battery replacement.~
Install Intake Air Temperature Sensor Jumper Harness The wiring at the connector of the Intake Air Temperature (IAT) sensor may be compromised due to wire strain. This bulletin involves adding a jumper harness on the IAT sensor to reduce this strain. The customer may not experience any symptom or condition for this service action. Upon further inspection, the technician may find P0113 Intake Air Temperature Sensor 1 Circuit High. Installing the jumper harness will help prevent any IAT issues from occurring.
Intermittent Coolant Loss This bulletin involves inspecting and if necessary, replacing the radiator and thermostat. A small number of customers may experience a slight loss of coolant. There may not be any sign of a leak found under the vehicle.
Battery Prior to replacing the battery, please check the component to determine if there is any acid leaking from the unit. If the answer is yes, please contact Bruce Davis at Cell (248) 613-5637 for further instructions. If the answer is no, please proceed with the battery replacement.~
Radio If this radio is installed in a vehicle equipped with the Radio Prep Package (sales code RA9), the vehicle harness connector will require relocation of the of A4, F20(BL/LG) and A7, A933 (RD/YL) circuits for radio operation. These two terminals must be swapped in the the connector. Failure to do so will result in the radio prompting the user to enter the security code every time the key is cycled.
Install Intake Air Temperature Sensor Jumper Harness The wiring at the connector of the Intake Air Temperature (IAT) sensor may be compromised due to wire strain. This bulletin involves adding a jumper harness on the IAT sensor to reduce this strain. The customer may not experience any symptom or condition for this service action. Upon further inspection, the technician may find P0113 Intake Air Temperature Sensor 1 Circuit High. Installing the jumper harness will help prevent any IAT issues from occurring.
무선 업데이트(FOTA)를 통한 라디오 U43.17 R1H 소프트웨어 버전 업데이트 - 내비게이션 안정성 - Android Auto 및 CarPlay 안정성 및 연결성 - 시동 애니메이션 이전 디스플레이 왜곡/깜빡임 - 텍스트 표시 - 위젯 잘못된 표시 - 방향지시등 사각지대 반응 타이밍 - 오디오 끊김 - 주행 모드 선택 - 주차 보조 가이드라인 선택 고객은 다음 중 하나 이상의 증상을 경험할 수 있습니다:
Flash: Electronic Vehicle Control Unit (EVCU) Updates Customers may experience a Malfunction Indicator Lamp (MIL) illumination and the vehicle may exhibit/set one or more of the following Diagnostic Trouble Codes (DTCs): P061B-00 - Internal Conttrol Module Torque Calculation Performance. P1444-00 - Power Inverter Module - Incorrect Control Mode. P1E18-00 - Internal Control Module Electronic Park Performance. Customers may experience the following: At start up, the vehicle will shut down. At start up, the vehicle will not start This bulletin involves reprogramming the EVCU with the latest available software.
Flash: Electronic Vehicle Control Unit (EVCU) Updates Customers may experience a Malfunction Indicator Lamp (MIL) illumination and the vehicle may exhibit/set one or more of the following Diagnostic Trouble Codes (DTCs): P061B-00 - Internal Control Module Torque Calculation Performance. P1444-00 - Power Inverter Module - Incorrect Control Mode. P1E18-00 - Internal Control Module Electronic Park Performance. Customers may experience the following: At start up, the vehicle will shut down. At start up, the vehicle will not start. This bulletin involves reprogramming the EVCU with the latest available software.
Flash: Electronic Vehicle Control Unit (EVCU) Updates Customers may experience a Malfunction Indicator Lamp (MIL) illumination and the vehicle may exhibit/set one or more of the following Diagnostic Trouble Codes (DTCs): P061B-00 - Internal Control Module Torque Calculation Performance. P1444-00 - Power Inverter Module - Incorrect Control Mode. P1E18-00 - Internal Control Module Electronic Park Performance. Customers may experience the following: At start up, the vehicle will shut down. At start up, the vehicle will not start. This bulletin involves reprogramming the EVCU with the latest available software.
출처: NHTSA(미국, 퍼블릭 도메인), 캐나다 교통부(Open Government Licence – Canada), DVSA(영국, Open Government Licence v3.0), RappelConso 및 EU Safety Gate(프랑스, Licence Ouverte 2.0), 일본 국토교통성(공공데이터 이용약관 1.0), 한국 국토교통부(자동차리콜센터 car.go.kr).