Engine and engine cooling:Cooling system:Radiator assembly
On certain vehicles equipped with 2.4 liter engines, the engine coolant may be drawn into the left radiator cooling fan motor connector.
🔔 Crie uma conta gratuita para receber alertas por e-mail sobre Chrysler Sebring (todas as gerações)
On certain vehicles equipped with 2.4 liter engines, the engine coolant may be drawn into the left radiator cooling fan motor connector.
On certain 2-door passenger vehicles, the fuel return line hose fitting on the electric fuel pump may be improperly molded.
On certain passenger vehicles, the fuel return line hose fitting on the electric fuel pump may be restricted, causing excessive fuel pressure to build up in the fuel injection system. Excessive fuel pressure may result in a leak in the fuel return hose.
Chrysler is recalling 91 my 2009 sebring and dodge avenger equipped with 2.4l engine passenger vehicles. A compatibility issue between the instrument cluster software and fuel pump module can result in the fuel gauge overstating the actual fuel tank level. As a result, the vehicle may run out of fuel when the gauge indicates that there is still fuel remaining in the tank.
It has been identified that an unused tyre pressure monitoring system electrical connector may become corroded and short circuit. This can lead to a variety of conditions including dead battery inoperative cruise control and engine non- start or stall
On certain passenger vehicles equipped with 2.5l v6 engines, the throttle control cable can fray causing the throttle to bind or stick.
On certain vehicles, the harness for the crankshaft position sensor could come in contact with a new protective shield causing a grounded circuit. Prolonged wiring harness contact with the heat shield will cause the wiring insulation to wear and eventually to ground out. This could cause the engine to die out, increasing the risk of a crash. Correction: Crank position sensor wiring harness will be rerouted.
Vehicle description: Passenger vehicles. The outer layer only of this 3-layer fuel return hose does not contain the desired ozone protection due to a processing error.
Vehicle description: Passenger vehicles. The harness for the crankshaft position sensor could come in contact with a new protective shield causing a grounded circuit.
Estes veículos podem não estar em conformidade com a norma C.M.V.S.S. 1103 - emissões de gases de escapamento. O sistema aspirador pode falhar, resultando em níveis aumentados de emissões de óxido nitroso. Correção: O sistema aspirador será removido, o regulador de pressão de combustível será substituído, se necessário, por um de projeto mais recente, e o módulo de controle do motor (PCM) será reprogramado.
Vehicle description: Passenger vehicles. The dash panel pad can shift interferring with the throttle cable control.
Certain vehicles do not comply with CMVSS 1103 - exhaust emissions. The calibration of the Powertrain Control Module (PCM) may fail to adequately control CO emissions. Correction: PCM will be reflashed with a new calibration.
The dash panel may sag and interfere with the accelerator pedal which could prevent the throttle from closing or result in a throttle sticking condition. Correction: The dash panel pad will be trimmed above the accelerator pedal.
Certain sebring convertible vehicles do not comply with CMVSS. 1101 - emission device. The vehicle emission control information (veci) label has an error in the hose routing schematic. Correction: Correct labels and installation instructions will be mailed to owners.
Fontes: NHTSA (Estados Unidos, domínio público), Transport Canada (Open Government Licence – Canada), DVSA (Reino Unido, Open Government Licence v3.0), RappelConso e Safety Gate da UE (França, Licence Ouverte 2.0), MLIT (Japão, Licença de Dados Públicos 1.0) e MOLIT (Coreia do Sul, car.go.kr).