Leitura livre · conta gratuita para contribuirSucessor do Anticars (2000)

Ford Contour

1994–2000 · 1 gerações · 13 defeitos documentados · 2 mercados
Gerações
Todas as geraçõesContour1994–20001335222
Ano do modelo
MercadoTodosNA
RecallCríticoInteriorNA

Seats And Restraints

The passenger side supplemental restraint system (air bag) may have a cracked inflator body. If the vehicle is involved in a deployment level crash, the passenger side air bag may not inflate properly which could result in reduced occupant protection. In addition, the igniter plug could separate from the inflator, which could result in the release of hot gases and could ignite flammable material or potentially cause personal injury. Correction: Vehicles will be inspected and a new passenger side air bag module will be installed if necessary.

Transport Canada21 de fev. de 19951995032Anos-modelo 1995Exibido no inglês original · tradução pendenteVer detalhes →
RecallModeradoInteriorNA

Cintos de segurança

Descrição do veículo: Veículos de passageiros, camiões ligeiros, veículos utilitários desportivos e mini-carrinhas equipadas com conjuntos de fivela de cinto de segurança TRW. A base da fivela destes conjuntos de cintos de segurança não foi devidamente tratada termicamente e, por isso, não cumpre o requisito de suporte da norma federal de segurança automóvel nº 209, "conjuntos de cinto de segurança".

NHTSA · Estados Unidos18 de ago. de 200000V228001Anos-modelo 2000Traduzido automaticamente · original: inglêsVer detalhes →
RecallModeradoInteriorNA

Air bags:Frontal:Sensor/control module-inactive

Vehicle description: Passenger vehicles. The air bag sensor wiring pigtail insulation can become brittle and crack over time due to accumulation of water in the pigtail protective convolute in combination with high underhood temperatures related to the routing of the wiring pigtail near the radiator. This can result in environmental stress cracking of the insulation.

NHTSA · Estados Unidos8 de set. de 199999V243000Anos-modelo 1998Exibido no inglês original · tradução pendenteVer detalhes →
RecallModeradoInteriorNA

Seats And Restraints

These vehicles may not comply with the requirements of c.M.V.S.S 210 - seat belt assembly anchorages. The hardware that attaches the outboard ends of the front safety belts to the front seat frames may be cracked or fractured. If so. The load that the safety belt could sustain would be below that specified by the standard. Correction: Reinforcement plates will be installed to the attachment hardware of both outboard front safety belts. If the attachment hardware is fractured, a new safety belt will be installed.

Transport Canada9 de jan. de 19961996003Anos-modelo 1995Exibido no inglês original · tradução pendenteVer detalhes →
RecallModeradoInteriorNA

Seat belts:Front:Anchorage

Cracks have been found in the front safety belt outboard anchor tabs due to a combination of hydrogen embrittlement of the tab and stress introduced during attachment of the anchor tab to the seat frame. This does not conform with the requirements of fmvss no. 210, "seat belt assembly anchorages."

NHTSA · Estados Unidos4 de dez. de 199595V228000Anos-modelo 1995Exibido no inglês original · tradução pendenteVer detalhes →

Fontes: NHTSA (Estados Unidos, domínio público), Transport Canada (Open Government Licence – Canada), DVSA (Reino Unido, Open Government Licence v3.0), RappelConso e Safety Gate da UE (França, Licence Ouverte 2.0), MLIT (Japão, Licença de Dados Públicos 1.0) e MOLIT (Coreia do Sul, car.go.kr).