Leitura livre · conta gratuita para contribuirSucessor do Anticars (2000)

Mazda CX-50

2022– · 1 gerações · 7 defeitos documentados · 1 mercados
Gerações
Todas as geraçõesCX-502022–77271

Os boletins técnicos (TSB) são instruções de reparação que os fabricantes enviam aos concessionários sobre problemas conhecidos. Não são recalls de segurança, mas muitas vezes confirmam um defeito.

Ano do modelo
MercadoTodosNA
BoletimModeradoMotorNA

Boletim

Some customers may experience a hybrid system failure message appearing on the meter and the engine does not start, along with other numerous DTCs.

NHTSA · boletim do fabricante11019993Anos-modelo 2025Exibido no inglês original · tradução pendenteVer detalhes →
BoletimModeradoMotorNA

Boletim

Some customers may experience the audio sound pausing when the engine restarts after i-stop operation under the following situations. The symptoms are caused by an improper part installation in the audio amplifier. A voltage drop error detection of the power source may be too sensitive.

NHTSA · boletim do fabricante11011135Anos-modelo 2023Exibido no inglês original · tradução pendenteVer detalhes →
BoletimModeradoMotorNA

Boletim

Some customer's might state that they notice fluid or oil leaking/dripping on the ground when the vehicle is parked. For this concern, inspect the vehicle for any trace of a fluid or oil leak and use the following examples as a guide to determine if it is severe enough to require a repair, or just to clean the area and monitor it at the next service.

NHTSA · boletim do fabricante11007010Anos-modelo 2025Exibido no inglês original · tradução pendenteVer detalhes →
BoletimModeradoMotorNA

Boletim

Customers may report excess wind noise from the vehicle and that noise may be coming from the crossbars. As noted in the crossbar instructions, the crossbars should be removed when not in use to reduce fuel consumption from the increased drag and to reduce wind noise. Let the customer know that the instructions show how to install, remove, and adjust the crossbars.

NHTSA · boletim do fabricante10213143Anos-modelo 2023Exibido no inglês original · tradução pendenteVer detalhes →
BoletimLeveMotorNA

Boletim

Some customers may complain about a rattle noise coming from the engine compartment when accelerating or idling. This may be caused by play at the turbocharger wastegate pivot arm creating a rattle-type noise. To eliminate this concern, a wave washer has been added.

NHTSA · boletim do fabricante11012338Anos-modelo 2024Exibido no inglês original · tradução pendenteVer detalhes →
BoletimLeveMotorNA

Boletim

A tapping/rattling noise may be noticed from the valve train area. This operating condition can occur on new vehicles which have been delivered to Mazda dealers (due to loading and unloading from transport trucks or customers moving their vehicles in and out of their garages to wash the vehicle, etc.). This condition may also occur if the engine is not allowed to warm up after multiple cold starts.

NHTSA · boletim do fabricante10235702Anos-modelo 2023Exibido no inglês original · tradução pendenteVer detalhes →
BoletimLeveMotorNA

Boletim

When servicing SKYACTIV engine vehicles requiring to replace the Oil Galley Plug and Crush Washer, order the required part numbers below. These parts are not listed in GEPC and were previously listed as "non-serviceable" in the cylinder block diagram.

NHTSA · boletim do fabricante10230865Anos-modelo 2023Exibido no inglês original · tradução pendenteVer detalhes →
BoletimLeveMotorNA

Boletim

Some customers may complain of signs of oil on the struts or shock absorbers. In most cases the oil that is present is normal, and a result of the oil that remains on the shaft during the normal sweeping process of the shaft seal. Follow the inspection guidelines below to determine if the condition is a result of the normal sweeping process or a failure of the shaft seal.

NHTSA · boletim do fabricante10226814Anos-modelo 2023Exibido no inglês original · tradução pendenteVer detalhes →
BoletimLeveMotorNA

Boletim

Some customers may complain of signs of oil on the struts or shock absorbers. In most cases the oil that is present is normal, and a result of the oil that remains on the shaft during the normal sweeping process of the shaft seal. Follow the inspection guidelines below to determine if the condition is a result of the normal sweeping process or a failure of the shaft seal.

NHTSA · boletim do fabricante10213185Anos-modelo 2023Exibido no inglês original · tradução pendenteVer detalhes →
BoletimLeveMotorNA

Boletim

A tapping/rattling noise may be noticed from the valve train area. This operating condition can occur on new vehicles which have been delivered to Mazda dealers (due to loading and unloading from transport trucks or customers moving their vehicles in and out of their garages to wash the vehicle, etc.). This condition may also occur if the engine is not allowed to warm up after multiple cold starts.

NHTSA · boletim do fabricante10210884Anos-modelo 2023Exibido no inglês original · tradução pendenteVer detalhes →

Fontes: NHTSA (Estados Unidos, domínio público), Transport Canada (Open Government Licence – Canada), DVSA (Reino Unido, Open Government Licence v3.0), RappelConso e Safety Gate da UE (França, Licence Ouverte 2.0), MLIT (Japão, Licença de Dados Públicos 1.0) e MOLIT (Coreia do Sul, car.go.kr).