Leitura livre · conta gratuita para contribuirSucessor do Anticars (2000)

MercuryMercury Lynx

1980–2003 · 4 gerações · 14 defeitos documentados · 2 mercados
Gerações
Ano do modelo
MercadoTodosNA
Lynx I · 1980–1990
RecallCríticoMotorNA

Motor

Em modelos de 1984, podem surgir rachaduras externas nos cabeçotes do motor, o que pode resultar em vazamento de óleo sobre o coletor de escape. Em modelos de 1985, a junta da tampa de válvulas do motor pode rachar, o que pode permitir que o óleo vaze sobre o coletor de escape. Ambas as condições criam a possibilidade de o óleo entrar em ignição, causando um incêndio no compartimento do motor. Correção: Em modelos de 1984, os cabeçotes do cilindro serão inspecionados e substituídos caso sejam encontradas rachaduras externas. Em modelos de 1985, as juntas da tampa de válvulas serão inspecionadas e substituídas, a menos que sejam de um projeto mais recente.

Transport Canada13 de jul. de 19891989098Anos-modelo 1984–1985Traduzido automaticamente · original: inglêsVer detalhes →
Lynx I · 1980–1990
RecallCríticoMotorNA

Motor e sistema de arrefecimento do motor:Motor

Rachaduras externas acima do cilindro número 3 (modelos 1984) ou rachaduras na junta da tampa dos balancins (modelos 1985) podem permitir que óleo vaze para o coletor de escape.

NHTSA · Estados Unidos12 de jun. de 198989V095000Anos-modelo 1984–1985Traduzido automaticamente · original: inglêsVer detalhes →
Lynx I · 1980–1990
RecallCríticoMotorNA

Sistema de Combustível

On vehicles with EFI or CFI, the spring-lock fuel line coupling used to connect the fuel supply and return lines to the EFI fuel rails or to the CFI throttle bodies, as well as other fuel line connections near the dash panels on some vehicles, could disengage during vehicle use. Should this occur, loss of fuel will result, providing the potential for a vehicle fire. Correction: Coupling retainer clips will be installed on affected vehicles. Note: Escort vehicles are equipped with EFI and CFI. Lynx vehicles are equipped with CFI only. EFI - electronic fuel injection; CFI - central fuel injection

Transport Canada9 de set. de 19871987098Anos-modelo 1986–1988Traduzido automaticamente · original: inglêsVer detalhes →
Lynx I · 1980–1990
Lynx I · 1980–1990
RecallCríticoMotorNA

Fuel system, gasoline:Storage:Tank assembly:Filler pipe and cap

During a crash barrier test, the rubber hose connecting the fuel tank and the metal filler pipe vent tube was cut, resulting in fuel leakage. The involved vehicles fail to comply with federal motor vehicle safety standard no. 301, "fuel system integrity".

NHTSA · Estados Unidos16 de set. de 198282V088000Anos-modelo 1983Exibido no inglês original · tradução pendenteVer detalhes →
Lynx I · 1980–1990
RecallCríticoMotorNA

Recall

Metal fasteners used to secure the carpeting to the floor pan may have been milocated and may have penetrated the top of the fuel tank. This condition may allow fuel leakage.

Transport Canada4 de nov. de 19801980144Anos-modelo 1981Exibido no inglês original · tradução pendenteVer detalhes →
Lynx I · 1980–1990
RecallCríticoMotorNA

Fuel system, gasoline:Storage:Tank assembly

On certain vehicles, metal fasteners that were used to secure the carpeting to the floor pan may have accidentally penetrated the top of the fuel tank. This would result in a slight fuel leak.

NHTSA · Estados Unidos4 de nov. de 198080V142000Anos-modelo 1981Exibido no inglês original · tradução pendenteVer detalhes →
Lynx I · 1980–1990
RecallModeradoMotorNA

Emissões

Estes veículos podem não estar em conformidade com a C.M.V.S.S. 1103 - emissões de gases de escapamento. O injetor central de combustível (CFI) pode operar com mistura rica em determinadas condições de funcionamento. Correção: Serão instalados injetores de combustível CFI aprimorados e a rotação em marcha lenta será ajustada.

Transport Canada13 de jul. de 19891989099Anos-modelo 1987Traduzido automaticamente · original: inglêsVer detalhes →
Lynx I · 1980–1990
RecallModeradoMotorNA

Vehicle speed control

The throttle lever may not return to idle position due to misalignment of the air conditioner shut off switch to the throttle lever pin. Consequence of defect: A jammed throttle could result in a loss of accelerator control, without prior warning, and an accident.

NHTSA · Estados Unidos1 de mai. de 198585V054000Anos-modelo 1985Exibido no inglês original · tradução pendenteVer detalhes →
Lynx I · 1980–1990
RecallModeradoMotorNA

Recall

Vehicles with 1.9l engine and air conditioning. A pin located on the throttle lever which actuates the air-conditioner shut-off switch may be subject to misalignment such that the switch could jam behind the actuating arm of the switch. If this were to occur, the throttle lever would be prevented from returning to the idle position and vehicle control could be adversely affected.

Transport Canada29 de abr. de 19851985050Anos-modelo 1985Exibido no inglês original · tradução pendenteVer detalhes →
Lynx I · 1980–1990
RecallModeradoMotorNA

Recall

This vehicle may not comply with cmvss 1103 - exhaust emissions. Note: This vehicle is located in the province of nova scotia.

Transport Canada29 de mar. de 19841984048Anos-modelo 1984Exibido no inglês original · tradução pendenteVer detalhes →
Lynx I · 1980–1990
RecallModeradoMotorNA

Recall

SOME OF THE VEHICLES (EQUIPPED WITH 1.6 LITRE ENGINES, CALIBRATION 3-03B-R10) MAY HAVE BEEN BUILT AND SHIPPED WITH EXHAUST AIR SUPPLY AIR CONTROL VALVE HOSES REVERSED. EMISSION LEVELS ARE EXPECTED TO INCREASE, POSSIBLY EXCEEDING THE STANDARDS. bRIVEABILITY SHOULD NOT BE AFFECTED.

Transport Canada18 de out. de 19831983087Anos-modelo 1983Exibido no inglês original · tradução pendenteVer detalhes →
Lynx I · 1980–1990
RecallModeradoMotorNA

Recall

These vehicles may not comply with cmvss 1103 - exhaust emissions.

Transport Canada10 de ago. de 19831983068Anos-modelo 1983Exibido no inglês original · tradução pendenteVer detalhes →
Lynx I · 1980–1990
RecallModeradoMotorNA

Equipment:Appliance:Air conditioner

On the involved vehicles, a thermal limiter in the blower motor resistor circuit of the air conditioner/heater assembly may not function as intended. If the blower motor becomes jammed when the system is operating in the medium-low blower speed, the resistor coils can overheat causing melting and possible ignition.

NHTSA · Estados Unidos11 de mai. de 198282V045000Anos-modelo 1982Exibido no inglês original · tradução pendenteVer detalhes →
Lynx I · 1980–1990
RecallModeradoMotorNA

Recall

Vehicles with optional air conditioning. The air conditioner blower motor thermal limiter may not operate as intended when there is a motor blockage or malfunction. Thus, if the blower motor becomes jammed when the system is operating in the medium-low blower speed mode, the resistor coils may overheat causing melting and possible ignition of the polyproplene evaporator housing with associated vehicle damage.

Transport Canada10 de mai. de 19821982045Anos-modelo 1982Exibido no inglês original · tradução pendenteVer detalhes →
Lynx I · 1980–1990
RecallModeradoMotorNA

Fuel system, gasoline:Storage:Tank assembly:Filler pipe and cap

Some of the involved vehicles have an electrically ungrounded fuel inlet. These vehicles are subject to static charge accumulation at the fuel filler pipe opening, which can occur if these vehicles are refueled from an electrically ungrounded dispensing nozzle.

NHTSA · Estados Unidos22 de jul. de 198181V092000Anos-modelo 1981Exibido no inglês original · tradução pendenteVer detalhes →
Lynx I · 1980–1990
RecallModeradoMotorNA

Recall

Vehicles with automatic speed control. Fuel may migrate through the speed control vacuum lines into the speed control servo assembly this could cause the vacuum o-ring to shrink allowing a vacuum leak. This leak may result in unintended activation of the speed control and could cause gradual acceleration of the vehicle.

Transport Canada10 de abr. de 19811981048Anos-modelo 1981Exibido no inglês original · tradução pendenteVer detalhes →
Lynx I · 1980–1990
RecallModeradoMotorNA

Vehicle speed control

Fuel may possibly travel through the speed control vacuum lines and into the speed control actuation device (serv0). The fuel can damage seals in the actuator servo and allow vacuum leaks. Such a leak could activate the speed control without any action on the part of the driver. This would cause the vehicle to gradually accelerate.

NHTSA · Estados Unidos6 de abr. de 198181V045000Anos-modelo 1981Exibido no inglês original · tradução pendenteVer detalhes →

Fontes: NHTSA (Estados Unidos, domínio público), Transport Canada (Open Government Licence – Canada), DVSA (Reino Unido, Open Government Licence v3.0), RappelConso e Safety Gate da UE (França, Licence Ouverte 2.0), MLIT (Japão, Licença de Dados Públicos 1.0) e MOLIT (Coreia do Sul, car.go.kr).