Leitura livre · conta gratuita para contribuirSucessor do Anticars (2000)

Nissan Murano

2002– · 4 gerações · 30 defeitos documentados · 5 mercados
Gerações
Ano do modelo
Murano I · 2002–2007
RecallCríticoMotorNA

Fuel system, gasoline:Storage:Tank assembly

On certain sport utility vehicles, a fitting for vapor recirculation, which is welded on the fuel tank, may come off the fuel tank because incorrect material was used.

NHTSA · Estados Unidos21 de fev. de 200606V054000Anos-modelo 2005Exibido no inglês original · tradução pendenteVer detalhes →
Murano I · 2002–2007
RecallCríticoMotorNA

Fuel System

On certain vehicles, an inadequate vapour recirculation fitting, which is welded to the fuel tank, may separate from the tank. This will allow some fuel leakage and cause the malfunction indicator light (MIL) in the instrument panel to illuminate. A fuel leak, in the presence of an ignition source, could result in a fire. Correction: Dealers will replace the fuel tank.

Transport Canada15 de fev. de 20062006044Anos-modelo 2005Exibido no inglês original · tradução pendenteVer detalhes →
Murano I · 2002–2007
RecallCríticoMotorJP

燃料タンク

燃料タンクの取付位置が不適切なため、高速走行中に、路上の落下物が燃料タンク前面に衝突することがある。そのため、落下物に突起があった場合、タンクに刺さり、最悪の場合、燃料タンクが損傷し、燃料が漏れるおそれがある。なお、当該タンクは、燃料タンクの技術基準に適合している。

MLIT · Japão9 de fev. de 20062103120Anos-modelo 2004–2005Exibido no japonês original · tradução pendenteVer detalhes →
Murano I · 2002–2007
RecallCríticoMotorNA

Fuel system, gasoline:Storage:Tank assembly

On certain sport utility vehicles, due to the location of the forward edge of the fuel tank, in the event that a vehicle front tire runs over a small, sharp object in the road, catches it and propels it towards the rear of the vehicle, it may strike and puncture the fuel tank.

NHTSA · Estados Unidos10 de jan. de 200606V003000Anos-modelo 2003–2006Exibido no inglês original · tradução pendenteVer detalhes →
Murano I · 2002–2007
RecallCríticoMotorNA

Fuel System

On certain vehicles, the fuel tank may be punctured by road debris that has been picked up and thrown by the front tires. A fuel leak, in the presence of an ignition source, could result in a fire. Correction: Dealers will install a shield in front of the fuel tank.

Transport Canada6 de jan. de 20062006004Anos-modelo 2003–2006Exibido no inglês original · tradução pendenteVer detalhes →
Murano I · 2002–2007
RecallModeradoMotorJP

エンジン一般

原動機において、エンジン回転センサの耐熱性が不足しているため、高負荷条件下での熱負荷の繰り返しにより当該センサが断線することがある。断線した場合は、フェールセーフにより、エンストしないように制御するが、走行条件によっては、制御が間に合わずにエンストして、再始動に時間がかかることがある。

MLIT · Japão27 de jul. de 20121129750Anos-modelo 2002–2007Exibido no japonês original · tradução pendenteVer detalhes →
Murano I · 2002–2007
RecallModeradoMotorNA

Engine

On certain vehicles, the intake air ducts, which are connected to the intermediate resonator in the air intake system of the engine, may separate from the resonator with engine movement. This separation occurs due to the premature ageing of the material used in the intake air ducts which causes excessive shrinking. If the air duct pulls off the resonator, the airflow meter will not accurately measure the intake airflow rate, which could result in unstable idling, poor acceleration, or engine stalling. Engine stalling would result in lost propulsion which, in conjunction with traffic and road conditions, and the driver's reactions, could increase the risk of a crash. Correction: Dealers will replace the intake air duct with an updated version.

Transport Canada28 de mai. de 20092009153Anos-modelo 2003–2007Exibido no inglês original · tradução pendenteVer detalhes →
Murano I · 2002–2007
RecallModeradoMotorNA

Engine and engine cooling

Nissan is recalling 362,891 my 2003-2007 murano vehicles. The intake air ducts, which are connected to the intermediate resonator in the air intake system of the engine, may separate from the resonator with engine movement. This separation occurs due to the premature aging of the material used in the intake air ducts which causes excessive shrinking.

NHTSA · Estados Unidos19 de mai. de 200909V169000Anos-modelo 2003–2007Exibido no inglês original · tradução pendenteVer detalhes →
Murano I · 2002–2007Murano II · 2007–2014
RecallModeradoMotorJP

エンジン一般

原動機の吸気エアダクトの材質が不適切なため、当該ダクトがエンジンの熱により収縮し、レゾネータ(吸気騒音防止装置)接続部の締付けが緩むことがある。そのため、そのまま使用を続けると、走行振動等によりエアダクトが外れてアイドリング不安定や加速不良となり、最悪の場合、エンストして再始動できなくなるおそれがある。

MLIT · Japão14 de mai. de 20091123050Anos-modelo 2003–2008Exibido no japonês original · tradução pendenteVer detalhes →
Murano I · 2002–2007
RecallModeradoMotorUK

Possible damage to fuel tank

In the event of a front tyre travelling over a sharp object the object could be propelled towards the rear of the vehicle and possibly damage the front edge of the fuel tank.

DVSA · Reino Unido23 de mai. de 2006R/2006/028Anos-modelo 2002–2005Exibido no inglês original · tradução pendenteVer detalhes →
Murano I · 2002–2007
RecallModeradoMotorJP

エバポ抑止装置

燃料蒸発ガスがホース内を通過する時の脈動音を低減させるパージレゾネータの製造方 法が不適切なため、パージレゾネータの溶着部がはがれることがある。そのため、そのま ま使用を続けると、パージレゾネータから燃料蒸発ガスが漏れて、炭化水素の排出量が規 制値を超えるおそれがある。

MLIT · Japão16 de dez. de 20041113310Anos-modelo 2004Exibido no japonês original · tradução pendenteVer detalhes →
Murano I · 2002–2007
RecallModeradoMotorNA

Engine and engine cooling

On certain passenger vehicles, the circuit board for the crank position sensor or cam position sensor may have an improper solder joint due to solder deformation caused by heat stress accelerated by the existence of flux residue during the soldering process.

NHTSA · Estados Unidos17 de nov. de 200303V455000Anos-modelo 2003Exibido no inglês original · tradução pendenteVer detalhes →

Fontes: NHTSA (Estados Unidos, domínio público), Transport Canada (Open Government Licence – Canada), DVSA (Reino Unido, Open Government Licence v3.0), RappelConso e Safety Gate da UE (França, Licence Ouverte 2.0), MLIT (Japão, Licença de Dados Públicos 1.0) e MOLIT (Coreia do Sul, car.go.kr).