Leitura livre · conta gratuita para contribuirSucessor do Anticars (2000)
EntrarCriar conta
NANHTSA · boletim do fabricante11031450

Boletins técnicos

Exibido no inglês original · tradução pendente

Flash: Powertrain Control Module (PCM) Updates Customers must experience a Malfunction Indicator Lamp (MIL) illumination and the vehicle must SYMPTOM: exhibit/set one or more of the following Diagnostic Trouble Codes (DTCs): **P0300 - Multiple Cylinder Misfire (Active or Stored status set during cold start catalyst heating). P0301 - Cylinder 1 Misfire (Active or Stored status set during cold start catalyst heating). P0302 - Cylinder 2 Misfire (Active or Stored status set during cold start catalyst heating). P0303 - Cylinder 3 Misfire (Active or Stored status set during cold start catalyst heating). P0304 - Cylinder 4 Misfire (Active or Stored status set during cold start catalyst heating). P0305-00 - Cylinder 5 Misfire (Active or Stored status set during cold start catalyst heating). P0306-00 - Cylinder 6 Misfire (Active or Stored status set during cold start catalyst heating).** P08A6 - Gear Lever Position Sensor System - Multiple Sensor Correlation. P152F - Engine Hood Switch 2 / Engine Hood Switch 1 Correlation. P1129 - Closed Loop Fueling Not Achieved - Bank 2 Upstream. P0152-02 - O2 Sensor 2/1 Circuit High. P0158-02 - O2 Sensor 2/2 Circuit High. P2504 - Charging System Output High. P0563 - Battery/System Voltage High. Customers may also comment on one or more of the following: **The vehicle has a rough idle. The engine has a miss. Noisy valvetrain. "Service Transmission" message in the Instrument Panel Cluster (IPC) due to clutch slip detection with the transfer case in neutral. NOTE: Some customers may experience wheel spin or traction loss. In these situations, the Powertrain Control Module (PCM) may interpret the event as excessive clutch slip. To prevent potential clutch damage, a message may be displayed in the Instrument Panel Cluster (IPC).** Clutch is overheating. Clutch is slipping on engagement. M18 FSAR-TSB-7161 -2- Inability to accelerate uphill. Vehicle does not start. Vehicle is stuck in limp-home mode

Abrange: Jeep Gladiator (Anos-modelo 2023)

Aviso oficial ↗

Fontes: NHTSA (Estados Unidos, domínio público), Transport Canada (Open Government Licence – Canada), DVSA (Reino Unido, Open Government Licence v3.0), RappelConso e Safety Gate da UE (França, Licence Ouverte 2.0), MLIT (Japão, Licença de Dados Públicos 1.0) e MOLIT (Coreia do Sul, car.go.kr).