Leitura livre · conta gratuita para contribuirSucessor do Anticars (2000)
EntrarCriar conta
NANHTSA · boletim do fabricante10139704

Boletins técnicos

Exibido no inglês original · tradução pendente

UConnect Hands Free Module Fails To Respond Due To Module Lock Up This bulletin involves replacing the Hands Free Module (HFM) if required. The HFM fails to operate causing the UConnect Hands Free Communications system to not respond when system activation is attempted by the customer. Further diagnosis may reveal that when the wiTECH scan tool is used to read Diagnostic Trouble Codes (DTCs) the tool indicates that the module is not responding. Other modules on the bus may display loss of communication with the HFM. If the Hands Free Communication system is unresponsive then the HFM may require electronic reset.To perform a electronic reset, turn off the vehicle and pull the Ignition Off Drain (IOD) fuse. Wait a few minutes before reinstalling the IOD fuse and checking if the HFM is communicating. If the HFM still will not communicate, then normal No Response diagnostic should be performed. If the HFM is working properly, the module should be replaced to prevent this condition from happening again.

Abrange: Chrysler PT Cruiser (Anos-modelo 2006) · Dodge Ram III (Anos-modelo 2006) · Jeep Commander (Anos-modelo 2006)

Aviso oficial ↗

Fontes: NHTSA (Estados Unidos, domínio público), Transport Canada (Open Government Licence – Canada), DVSA (Reino Unido, Open Government Licence v3.0), RappelConso e Safety Gate da UE (França, Licence Ouverte 2.0), MLIT (Japão, Licença de Dados Públicos 1.0) e MOLIT (Coreia do Sul, car.go.kr).