免费阅读 · 免费账户即可贡献Anticars(2000)的继任者

BMW M8

2019–2025 · 1 各代车型 · 已记录0项缺陷 · 3个市场
各代车型

技术服务通报(TSB)是制造商就已知问题发给经销商的维修说明。它们不是安全召回,但常常能证实某个缺陷。

严重程度全部中等轻微
车型年份
通报中等发动机NA

通报

在某些驾驶情况下,冷却液会泄漏到气缸组(5-8)的喷油器上。

NHTSA · 制造商通报11002676车型年份 2019自动翻译 · 原文:英语查看详情 →
通报中等发动机NA

通报

Under certain driving situations, coolant leaks onto the fuel injectors on cylinder bank (5-8).

NHTSA · 制造商通报11000498车型年份 2019以原文(英语)显示 · 翻译待完成查看详情 →
通报中等发动机NA

通报

A vehicle arrives at your center to be diagnosed for a micro-leak in the fuel evaporative (EVAP) system(NVLD natural vacuum leak detection). For this condition, the following fault is stored in the DME: 190302 - fuel tank ventilation and scavenging air system, micro-leak: leakage more than 0.5mm For: Model vehicles other that the ones listed above, or for EVAP faults related to a large leak, after confirming that the fuel filler cap is fitted properly, then, proceed to follow the corresponding test plan

NHTSA · 制造商通报10249015车型年份 2020以原文(英语)显示 · 翻译待完成查看详情 →
通报中等发动机NA

通报

A vehicle arrives at your center to be diagnosed for a micro-leak in the fuel evaporative (EVAP) system (NVLD natural vacuum leak detection). For this condition, the following fault is stored in the DME: 190302 - fuel tank ventilation and scavenging air system, micro-leak: leakage more than 0.5 mm.

NHTSA · 制造商通报10239602车型年份 2019–2020以原文(英语)显示 · 翻译待完成查看详情 →
通报轻微发动机NA

通报

Engine Return

NHTSA · 制造商通报11020074车型年份 2020以原文(英语)显示 · 翻译待完成查看详情 →
通报轻微发动机NA

通报

One of the six engine oil pump mounting screws may not have been tightened with the correct torque.

NHTSA · 制造商通报11014421车型年份 2024以原文(英语)显示 · 翻译待完成查看详情 →
通报轻微发动机NA

通报

Delivery stop: Oil pump screw connection

NHTSA · 制造商通报11012079车型年份 2024以原文(英语)显示 · 翻译待完成查看详情 →
通报轻微发动机NA

通报

The NVLD limited emission related warranty for defects in materials or workmanship has been extended to 15 years/150,000 miles as determined from the original in-service date

NHTSA · 制造商通报11012066车型年份 2020以原文(英语)显示 · 翻译待完成查看详情 →
通报轻微发动机NA

通报

The quick disconnect coupling on the cylinder head coolant vent line could break at the cylinder head. This would lead to loss of coolant from the engine.

NHTSA · 制造商通报10214256车型年份 2018以原文(英语)显示 · 翻译待完成查看详情 →
通报轻微发动机NA

通报

Information updated about engine oil filter cap drain plug. When performing an engine oil service on vehicles equipped with a N63M, N63B or S63M engines; the ETK states to use "Set oil filter element" P/N 11 42 5 A33 C42 or P/N 11 42 5 A33 C43. The part numbers are not available at the moment.

NHTSA · 制造商通报10212785车型年份 2019–2020以原文(英语)显示 · 翻译待完成查看详情 →
通报轻微发动机NA

通报

When performing an engine oil service on vehicles equipped with a S63M engine the ETK states to use "Setoil filter element" P/N 11 42 5 A33 C43. P/N 11 42 5 A33 C43 is a new part number that was recently created without current parts availability. Until further notice ONLY use "Set oil filter element" P/N 11 42 7 848 321.

NHTSA · 制造商通报10203332车型年份 2020以原文(英语)显示 · 翻译待完成查看详情 →
通报轻微发动机NA

通报

On rare occasions during an engine oil service, the BMW Original (Genuine) engine oil filter insert is either difficult to remove or breaks apart in the oil filter housing.

NHTSA · 制造商通报10200228车型年份 2019–2020以原文(英语)显示 · 翻译待完成查看详情 →
通报轻微发动机NA

通报

B58 ENGINE: ENGINE OIL FILTER REMOVAL PROCEDURE AND TOOLS . A. For the B58 engines, a BMW Oil Catch special tool for use in conjunction with removing the engine oilfilter insert is now available.

NHTSA · 制造商通报10199292车型年份 2019–2020以原文(英语)显示 · 翻译待完成查看详情 →
通报轻微发动机NA

通报

B58 ENGINE: ENGINE OIL FILTER REMOVAL PROCEDURE AND TOOLS . A. For the B58 engines, a BMW Oil Catch special tool for use in conjunction with removing the engine oilfilter insert is now available.

NHTSA · 制造商通报10198899车型年份 2019–2020以原文(英语)显示 · 翻译待完成查看详情 →
通报轻微发动机NA

通报

REPLACE ALL THE IGNITION COILS: The ignition coils may not have been produced to specifications which could lead to irregular running of the engine. A manufacturing defect affecting the ignition coil insulation.

NHTSA · 制造商通报10186214车型年份 2020以原文(英语)显示 · 翻译待完成查看详情 →
通报轻微发动机NA

通报

B58C AND B58M ENGINES ENGINE OIL FILTER INSERT IS DIFFICULT TO REMOVE - REMOVAL: On rare occasions during an engine oil service the BMW Original (Genuine) engine oil filter insert is either difficult to remove or breaks apart in the oil filter housing. The engine oil filter is broken. The paper is torn and the lower plastic section is stuck in the engine oil filter housing.

NHTSA · 制造商通报10176360车型年份 2019–2020以原文(英语)显示 · 翻译待完成查看详情 →
通报轻微发动机NA

通报

CONNECTEDDRIVE/BMW ASSIST SYSTEM DIAGNOSIS INFORMATION: This Service Information Bulletin (Revision 7) replaces SI B84 02 14 dated May 2019. ConnectedDrive/BMW Assist features are partially or completely inoperative. This Service Information Bulletin: Is being published because vehicles are down for an extended period of time when researching system failures with ConnectedDrive or BMW Assist. Will assist you both in identifying the issue and providing technical support. CAUSE Not enough information is available for BMW NA engineers to assist the technician in diagnosing the root cause.

NHTSA · 制造商通报10174320车型年份 2019–2020以原文(英语)显示 · 翻译待完成查看详情 →
通报轻微发动机NA

通报

ENGINE OIL FILTER INSERT IS DIFFICULT TO REMOVE - REMOVAL: This Service Information Bulletin (Revision 1) replaces SI B11 01 20 dated February 2020. On rare occasions during an engine oil service the BMW Original (Genuine) engine oil filter insert is either difficult to remove or breaks apart in the oil filter housing. The engine oil filter is broken. The paper is torn and the lower plastic section is stuck in the engine oil filter housing (1).

NHTSA · 制造商通报10172487车型年份 2019–2020以原文(英语)显示 · 翻译待完成查看详情 →
通报轻微发动机NA

通报

Delivery Stop on certain Model Year 2019 and 2020 BMW vehicles that were produced between July 20 2018 and November 2 2019. There is a possibility of contamination in the engine.

NHTSA · 制造商通报10169456车型年份 2019以原文(英语)显示 · 翻译待完成查看详情 →
通报轻微发动机NA

通报

HIGH ENGINE SPEED IMMEDIATELY AFTER STARTING. In rare circumstances after the engine is started with the Start-Stop button the engine speed may immediately increase to a high constant RPM (approximately 3000 rpm).

NHTSA · 制造商通报10163031车型年份 2019以原文(英语)显示 · 翻译待完成查看详情 →
通报轻微发动机NA

通报

SERVICE ACTION: CHECK COOLANT LEVEL. The filling procedure at the factory could have set the engine coolant level in the expansion tank to below the minimum level.

NHTSA · 制造商通报10160336车型年份 2019以原文(英语)显示 · 翻译待完成查看详情 →
通报轻微发动机NA

通报

SERVICE ACTION: CHECK COOLANT LEVEL. The filling procedure at the factory could have set the engine coolant level in the expansion tank to below the minimum level.

NHTSA · 制造商通报10160253车型年份 2019以原文(英语)显示 · 翻译待完成查看详情 →

来源:NHTSA(美国,公有领域)、加拿大交通部(加拿大开放政府许可)、DVSA(英国,开放政府许可 v3.0)、RappelConso 与欧盟 Safety Gate(法国,开放许可 2.0)、日本国土交通省(公共数据许可1.0)、韩国国土交通部(car.go.kr)。