燃油系统,汽油:输送
在某些配备 3800 V6(L36)发动机以及特定 Delphi 燃油压力调节器的乘用车上,这些调节器的漏油率远高于正常水平。漏出的燃油可能通过真空管进入进气歧管。如果发动机在曲轴转动时无法启动,漏出的燃油与错误时序的火花可能引发回火。
🔔 注册免费账户,接收 Buick LeSabre (所有代) 的邮件提醒
在某些配备 3800 V6(L36)发动机以及特定 Delphi 燃油压力调节器的乘用车上,这些调节器的漏油率远高于正常水平。漏出的燃油可能通过真空管进入进气歧管。如果发动机在曲轴转动时无法启动,漏出的燃油与错误时序的火花可能引发回火。
These vehicles may exhibit a backfire during engine starting that can cause breakage of the upper intake manifold. This can cause a no-start condition and possibly an engine compartment fire. Also, if a person was in the vicinity of the intake manifold when the hood was open, and this backfire condition occurred, it could result in personal injury. Correction: The pcm (powertrain control module) will be reflashed with new programming software.
在发动机起动过程中发生回火(进气回火)可能会导致上进气歧管破裂。
Fuel rollover valve assembly may not have been installed.
Rubber fuel hose could allow a slow fuel leak while the engine is running.
These vehicles do not comply with c.M.V.S.S. 1101 - emission device. Improper calibration of the powertrain control module (pcm) can result in uncontrolled spark knock, setting an mil (malfunction indicator lamp), misfire, rough idle, audible knock and/or possible engine damage. Correction: Vehicle pcm will be reflashed with new calibration softwear.
定速巡航伺服阀(支架)中的一个小型尼龙衬套可能会滑脱,导致发动机转速间歇性上升或柴油故障。这种情况还可能导致伺服杆组件磨损球体并卡住其他部件,可能导致油门卡住。这可能导致车辆控制丧失,甚至发生事故。更正:巡航控制伺服阀门上将安装套管套件。
巡航控制伺服管中的小尼龙衬套可能会滑脱,导致发动机转速间歇性且意外地增加,或柴油发动机启动时关闭点火。
这些车辆不符合 c.M.V.S.S. 1105-蒸发排放标准。车辆可能出现炭罐清洗热真空开关失效的情况。
The fuel rollover valve may not have been installed on the affected vehicles. In the event of an accident where the vehicle became inverted, a missing fuel rollover valve assembly could allow fuel spillage in excess of the amount prescribed by c.M.V.S.S. 301 - fuel system integrity. Correction: Fuel sender and pump assembly will be replaced.
These vehicles do not comply with c.M.V.S.S. 1103 - exhaust emissions. - mass airflow sensor failure - note : Vehicles with 3.0 litre and 3.8 litre engines.
These vehicles may not comply with cmvss 1101 - emission devices.
Accelerator pump lever retaining pin may loosen after repeated heavy accelerator pedal applications. This could cause the throttle to become stuck in the open position.
Under certain vehicle operating conditions, the governor weight retainer in the injection pump may fail. The throttle valve could stick, preventing return to idle and shut down of the engine by the driver.
The maintenance schedule specifies a 30,000 mile (48,000 km) interval between spark plug changes instead of the correct 22,500 mile (36,000km) interval. The incorrect interval if followed may affect air emission control performance. These vehicles do not comply with canada motor vehicle safety standard 1103 - exhaust emissions.
Vehicles equipped with 5.7 litre engines. Vehicles may have been assembled with improper functioning exhaust gas recirculation (egr) valve. These vehicles do not comply with canada motor vehicle safety standard 1103 - exhaust emissions. Gas recirculation (egr) valve. These vehicles do not comply with canada motor vehicle safety standard 1103 - exhaust emissions.
Certain vehicles do not comply with the requirements of CMVSS 1101 - Emission Device. Vehicles were built with incorrect emission control labels. The emission control (tune up) labels have an incorrect emission vacuum hose routing schematic. Correction: Dealers will install a new vehicle emission control label on the radiator support.
来源:NHTSA(美国,公有领域)、加拿大交通部(加拿大开放政府许可)、DVSA(英国,开放政府许可 v3.0)、RappelConso 与欧盟 Safety Gate(法国,开放许可 2.0)、日本国土交通省(公共数据许可1.0)、韩国国土交通部(car.go.kr)。