General Motors LLC (GM) is recalling certain 2020 Cadillac Escalade, Escalade ESV, Chevrolet Camaro, Silverado 1500, Suburban, Tahoe, GMC Sierra 1500, Yukon, and Yukon XL vehicles. The fuel pump may be missing a pressure regulator, allowing for over-pressurization of the fuel system.
On certain trucks equipped with an 8.1l v8 (rpo l8-vin g) engine have a condition in which the engine fuel rail pulse damper retainer clip may fracture resulting in inadequate retention of the damper.
Certain trucks and sport utility vehicles were built with fuel module reservoir assemblies that contain fuel pump wires connectors may overheat under certain operating conditions.
On certain sport utility vehicles and pickup trucks equipped with 5.3l (rpo l59) v8 engines, the engine fuel rail crossover tube retainer screws were not manufactured to specifications and may break.
On certain pickup trucks and sport utility vehicles, vehicles, during a 30 degree left angle frontal impact of sufficient severity, a tear could develop in the mid-frame cross member at its attachment to the left frame rail. If the mid-frame cross member tears during frontal impact and produces a sharp edge, contact of the sharp edge with the fuel tank could result in a puncture of the fuel tank and possible fuel leakage.
On certain vehicles, the service-part fuel tanks may have one or more pairs of the six projection welds which attach the sender-unit ring to the tank that do not meet specification. These out of specification welds may fracture during sender unit installation resulting in fuel leakage and a possible vehicle fire. Note: recall covers 1975-1986 chevrolet/gmc c/k pickup and chassis cab trucks and 1987-1991 chevrolet/gmc r/v pickup and chassis cab trucks. Correction: vehicles with fractured sender ring weld pairs will have a new fuel tank installed.
General Motors LLC (GM) is recalling certain 2021-2024 Cadillac Escalade and Escalade ESV, Chevrolet Silverado 1500, Suburban, and Tahoe, GMC Sierra 1500, Yukon, and Yukon XL vehicles equipped with a 6.2L V8 gas engine. The connecting rod and/or crankshaft engine components may have manufacturing defects that can lead to engine damage and engine failure.
Gm is recalling 27,188 my 2009 cadillac escalade, escalade hybrid, escalade esv, and escalade ext; chevrolet avalanche, suburban, tahoe, tahoe hybrid, and colorado; and gmc yukon, yukon hybrid, yukon xl, and canyon vehicles. The fuel system control modules may have a condition in which an adhesive separation of the room temperature vulcanizing (rtv) seal between the seal and the housing may allow water to seep into the module.
Certain vehicles may not comply with CMVSS 124 - Accelerator Control Systems. Vehicles may have been assembled with the throttle cable contacting the dash mat. The dash mat may bind the throttle cable such that the throttle return time may not meet the requirements of the standard. Correction: Dealers will inspect for adequate throttle cable to dash mat clearance, and if there is insufficient clearance, a portion of the dash mat will be cut out to provide clearance.
These vehicles were assembled with the throttle cable contacting the dash mat which could bind the throttle. This does not meet with the maximum return times required by federal motor vehicle safety standard no. 124, "accelerator control systems."
Issue: On certain vehicles, the connecting rods and/or crankshaft components may not have been manufactured properly. As a result, the engine could make abnormal noises and a warning light may turn on. If you continue to drive the vehicle with these symptoms, the engine could fail. Note: This recall only affects certain vehicles equipped with a 6.2 L V8 gas engine. Safety Risk: An engine failure could cause a sudden loss of power to the wheels and increase the risk of a crash. Corrective Actions: General Motors will notify owners by mail and advise you to take your vehicle to inspect and, if necessary, repair or replace the engine. For vehicles that pass the engine inspection, the dealer will replace the oil with a higher viscosity oil, install a new oil fill cap, replace the oil filter, and add an insert to the owner's manual.