The DC-DC converter may be faulty, which can cause the current from the 12V battery to continue to flow, generating heat and increasing the risk of a vehicle fire.
The plug-in hybrid system of the subject vehicles includes a DC-DC converter that reduces the voltage of the electricity from the Hybrid Vehicle (HV) battery in order to charge the vehicle�s 12V battery. Contained within the DC-DC converter is a current rectifying module that is installed on the circuit board. Some of these modules may have been damaged during production by the supplier and could fail so creating a short circuit. This allows current from the 12V battery to continue to flow through the module and the module will generate heat. Under certain conditions if excessive heat is generated components within and outside the DC-DC converter could sustain thermal damage increasing the risk of a vehicle fire.
DC-DC 컨버터(전압 변환장치)의 내부 회로 설계 오류로 내부 부품이 손상되고 이로 인해 단락이 발생할 수 있으며, 이런 경우 경고등이 점등되고 12V 배터리에서 전류가 계속 흐르게 되어 과도한 열이 발생되므로 최악의 경우에는 화재에 이를 우려가 있음이 확인됨에 따른 리콜
Issue: On certain plug-in hybrid vehicles, the DC-DC converter located under the rear seat could fail. If this happens, the DC-DC converter and nearby parts could overheat. Safety Risk: A DC-DC converter that overheats can create the risk of a fire. Corrective Actions: Toyota will notify owners by mail and advise you to take your vehicle to a dealership to replace the DC-DC converter. To reduce the safety risk, Toyota recommends not to charge your vehicle while the air temperature is below or expected to drop below 5° C until the recall repairs have been completed.
Toyota Motor Engineering & Manufacturing (Toyota) is recalling certain 2021-2022 RAV4 Prime and 2022 Lexus NX450h+ plug-in hybrid electric (PHEV) vehicles. The electric current rectifying module contained within the DC-DC converter may have been damaged during production, which can result in an electrical short-circuit.
ة 高级识别摄像头的软件编程可能导致点火开关关闭时存储器故障,从而使预碰撞系统在下次启动时无法激活,并可能触发警告灯、响起蜂鸣声并在仪表板上显示警报。忽视这些警告可能会增加发生事故和受伤的风险。
Correction of my own output above: the first character is a stray character and should not be there. The correct translation is:
高级识别摄像头的软件编程可能导致点火开关关闭时存储器故障,从而使预碰撞系统在下次启动时无法激活,并可能触发警告灯、响起蜂鸣声并在仪表板上显示警报。忽视这些警告可能会增加发生事故和受伤的风险。
Toyota Motor Engineering & Manufacturing (Toyota) is recalling certain 2022-2025 Lexus NX350, NX250, 2023-2026 RX350, and 2024-2026 TX350 vehicles. The rearview camera image may not display when the vehicle is placed in reverse. As such, these vehicles fail to comply with the requirements of Federal Motor Vehicle Safety Standard (FMVSS) number 111, "Rear Visibility."
Toyota Motor Engineering & Manufacturing(Toyota)正在召回部分配备全景环视监视器(PVM)系统的2022至2026年款Toyota、Lexus和Subaru Solterra车辆。完整车型清单请参阅召回报告。软件错误可能导致车辆倒车时后视摄像头画面卡住或显示黑屏。因此,这些车辆不符合联邦机动车安全标准(FMVSS)第111号“后方可见性”的要求。
A software issue leads the turn signal lamps not to activate automatically during remote operation (e.g., when parking), and manual activation is also not possible. This issue could increase the risk of collision and injuries if drivers do not properly assess their surroundings before exiting the vehicle.
Due to the programming of the forward recognition camera software there is a possibility that the memory inside the forward recognition camera could fail during processing when the ignition is turned OFF. If this occurs the PCS will not activate on the next ignition start causing warning lights to illuminate audible chimes to sound and messages to display on the instrument panel.
The programming of the forward recognition camera software can lead to memory failure when the ignition is turned OFF. This can prevent the pre-collision system from activating upon the next ignition start, triggering warning lights, sounding chimes, and displaying alerts on the dashboard. Ignoring these warning can increase the risk of accidents and injuries.
On affected vehicles there is a possibility that the DCM may not complete the shutdown process within a specific period of time when the ignition is turned off causing the DCM to not restart at the next ignition cycle and making the e-Call function unavailable. As a result the vehicles do not comply with relevant regulations.
Toyota Engineering & Manufacturing (Toyota) is recalling certain 2022 Lexus LX 600, Lexus NX 350h, Lexus NX 450h+, Toytoa RAV4 Hybrid, 2021-2022 Lexus LS 500h, Toyota Mirai, RAV4 PRIME, Sienna, Venza, and 2020-2022 Toyota Highlander Hybrid vehicles. The Skid Control ECU software may not turn on the Vehicle Stability Control (VSC) system when the vehicle is restarted after the driver has disabled the VSC system. As such, these vehicles fail to comply with the requirements of Federal Motor Vehicle Safety Standard number 126, "Electronic Stability Control Systems."
Un problème logiciel conduit les clignotants à ne pas s'activer automatiquement pendant le fonctionnement à distance (par exemple, lors du stationnement), et l'activation manuelle n'est pas non plus possible. ce problème pourrait augmenter le risque de collision et de blessures si les conducteurs n'évaluent pas correctement leur environnement avant de sortir du véhicule.
전방 인식 카메라의 소프트웨어 오류로 인해 전방 인식 카메라가 정상 작동되지 않을 수 있으며, 이런 경우 차량 시동 시 운전보조기능 관련 경고등이 표시되고, 경고음이 울리며 운전보조기능이 제대로 작동되지 않을 수 있는 가능성에 따른 리콜
<*대상차량별 생산일자> NX350h: 2021.04.22~2023.03.04 NX450h+: 2021.04.22~2023.03.01 CROWN Dual Boost HEV: 2023.03.02~2023.09.26 CROWN HEV: 2023.03.02~2023.10.02