On certain vehicles, due to a manufacturing defect the start/stop button could stick inside of its housing. If this occurs, vibration could cause the electrical components inside the button to contact repeatedly in quick succession and initiate the emergency engine shut off procedure while the vehicle is in motion. This could result in increased steering and braking effort, a loss of motive power and would disable the supplemental restraint systems (SRS), increasing the risk of a crash causing injury and/or damage to property. Correction: Dealers will inspect and repair defective start/stop switch as necessary.
null The fuel rail pressure sensor of some vehicles may be tightened insufficiently to the fuel rail of the engine and it may loosen gradually due to heat and vibration of the engine. If left undetected and the vehicle continues to be driven in this condition, in an extreme case, fuel leakage may occur between the fuel rail pressure sensor and the fuel rail.
If an electrical short occurs in the supply to the rear oxygen sensor the senor will fail but the driver will not see an immediate warning. A MIL warning may display after continued driving depending on driving/vehicle characteristics.
null The sensor of the rear oxygen sensor might fail and does not set a Diagnostic Trouble Code (DTC) in case of inappropriate content of the exhaust gases. In such cases, the user is not warned through the Malfunction Indicator Light (MIL) on the dashboard.
null An incorrect calibration setting in the Engine Control Module (ECM) software may cause miscalculation of sulfur oxide (SOx) levels captured within the Lean NOx Trap (LNT) component of the exhaust’s Diesel Particulate Filter (DPF). This miscalculation could, with extended operation under certain driving conditions, affect the purge process applied to remove SOx particles from the DPF-LNT. In this condition, the capacity of the DPF-LNT may become saturated and, as a result, the nitrogen oxide (NOx) emissions from the vehicle could exceed the permitted level.
Nissan North America, Inc. (Nissan) is recalling certain model year 2014 Versa Sedan vehicles manufactured July 16, 2013, to January 29, 2014, 2013-2014 Cube vehicles manufactured July 3, 2013, to October 21, 2013, and 2013-2014 Juke vehicles manufactured July 3, 2013, to October 22, 2013. When exposed to hot temperatures, the affected vehicles have an engine start/stop button that may stick inside the button housing.