ECM REPLACEMENT PROCEDURE REQUIRED FOR RES EQUIPPED VEHICLES SERVICE INFORMATION If any of the APPLIED VEHICLES equipped with Remote Engine Start (RES) requires Engine Control Module (ECM) replacement, the Body Control Module (BCM) must be replaced also at the same time. If you are not familiar with the Re/programming, Configuration procedure, refer to the Electronic Service Manual (ESM) and the CONSULT Operation Manual to reprogram the Electronic Control Unit (ECU). Follow all precautions in both manuals to prevent possible personal injury or death and/or damage to the ECU. This procedure will go back and forth between the ECM and BCM steps as found in the ESM. Damage will occur requiring the ECM and the BCM to be replaced a second time if the following SERVICE PROCEDURE is not followed. Perform the following steps from the Electronic Service Manual (ESM) in this order: A. Perform Work Procedure (Before Replacing ECM) to save the ECM data. B. Remove the ECM. C. Remove the BCM. D. Install the new BCM and then perform Additional Service When Replacing BCM - Work Procedure up to and including Register of Vehicle Identification Number. E. Install the new ECM and then perform Additional Service When Replacing ECM - Work Procedure (After Replacing ECM) up to and including Writing MAC Key for ECM. F. Complete the Additional Service When Replacing BCM - Work Procedure. G. Complete the Additional Service When Replacing ECM - Work Procedure (After Replacing ECM).
NANHTSA · 制造商通报11015916
技术服务通报
以原文(英语)显示 · 翻译待完成
涉及: Nissan Kicks I (P15/D15) (车型年份 2025) · Nissan Murano IV (车型年份 2025) · Nissan Safari VII (车型年份 2025)
来源:NHTSA(美国,公有领域)、加拿大交通部(加拿大开放政府许可)、DVSA(英国,开放政府许可 v3.0)、RappelConso 与欧盟 Safety Gate(法国,开放许可 2.0)、日本国土交通省(公共数据许可1.0)、韩国国土交通部(car.go.kr)。