通报
Start Stop Charging Warning Lamp Illuminated On, Intelligent Battery Sensor (IBS) State of Charge (SOC) Inaccurate, Battery Charging Message, Presence of IBS related Diagnostic Trouble Codes (DTCs), or Battery Warning Lamp On
🔔 注册免费账户,接收 Ram ProMaster (所有代) 的邮件提醒
技术服务通报(TSB)是制造商就已知问题发给经销商的维修说明。它们不是安全召回,但常常能证实某个缺陷。
Start Stop Charging Warning Lamp Illuminated On, Intelligent Battery Sensor (IBS) State of Charge (SOC) Inaccurate, Battery Charging Message, Presence of IBS related Diagnostic Trouble Codes (DTCs), or Battery Warning Lamp On
无法启动,无法完成模块更换,Proxi 或模块 Proxi 配置
Updated Fuel Filler Cap This bulletin involves updating the fuel filler cap with improved version. Customers may experience a Malfunction Indicator Lamp (MIL) illumination. Upon further investigation the technician may find that one or more of the following Diagnostic Trouble Codes (DTCs) have been set: P0455 - EVAP System Large Leak. P0456 - EVAP System Small Leak. P04EC - EVAP System Large Leak Detected - Fuel Tank Side. P04EE - EVAP System Very Small Leak Detected - Fuel Tank Side.
Telematic box module 2 For customer concern of Uconnect box error popup on the screen every time the vehicle is turned on. A missing security certificate or after a new TBM installed, or any active DTC set by TBM will trigger this popup. Please refer to STAR Online S2108000015 for more information. If you continually see this popup message, also see an active B22A9-93 DTC, please use wiTECH tool to check TBM2 module and record the failure information as shown on STAR Online S228A000003. Before replacing the TBM module, please check connections behind the TBM, the antenna and harness for improper connection and damage. Please call FCA Redacted Content
Updated Fuel Filler Cap This bulletin involves updating the fuel filler cap with improved version. Customers may experience a Malfunction Indicator Lamp (MIL) illumination. Upon further investigation the technician may find that one or more of the following Diagnostic Trouble Codes (DTCs) have been set: P0455 - EVAP System Large Leak. P0456 - EVAP System Small Leak. P04EC - EVAP System Large Leak Detected - Fuel Tank Side. P04EE - EVAP System Very Small Leak Detected - Fuel Tank Side.
Updated Fuel Filler Cap This bulletin involves updating the fuel filler cap with improved version. Customers may experience a Malfunction Indicator Lamp (MIL) illumination. Upon further investigation the technician may find that one or more of the following Diagnostic Trouble Codes (DTCs) have been set: P0455 - EVAP System Large Leak. P0456 - EVAP System Small Leak. P04EC - EVAP System Large Leak Detected - Fuel Tank Side. P04EE - EVAP System Very Small Leak Detected - Fuel Tank Side.
Telematic box module 2 For customer concern of Uconnect box error popup on the screen every time the vehicle is turned on. A missing security certificate or after a new TBM installed, or any active DTC set by TBM will trigger this popup. Please refer to STAR Online S2108000015 for more information. If you continually see this popup message, also see an active B22A9-93 DTC, please use wiTECH tool to check TBM2 module and record the failure information as shown on STAR Online S228A000003. Before replacing the TBM module, please check connections behind the TBM, the antenna and harness for improper connection and damage. Please call FCA Redacted Content
No Start, Cannot Complete Module Replace, Proxi Or Module Proxi Configuration
Install Intake Air Temperature Sensor Jumper Harness.
Install Intake Air Temperature Sensor Jumper Harness.
MIL Lamp On, No Start
Intelligent Battery Sensor-IBS Installation, Battery Charging Message, Start Stop Charging Warning Lamp Illuminated On Stop Start Equipped Vehicles
Radio If this radio is installed in a vehicle equipped with the Radio Prep Package (sales code RA9), the vehicle harness connector will require relocation of the of A4, F20(BL/LG) and A7, A933 (RD/YL) circuits for radio operation. These two terminals must be swapped in the the connector. Failure to do so will result in the radio prompting the user to enter the security code every time the key is cycled.
Radio If this radio is installed in a vehicle equipped with the Radio Prep Package (sales code RA9), the vehicle harness connector will require relocation of the of A4, F20(BL/LG) and A7, A933 (RD/YL) circuits for radio operation. These two terminals must be swapped in the the connector. Failure to do so will result in the radio prompting the user to enter the security code every time the key is cycled.
Radio If this radio is installed in a vehicle equipped with the Radio Prep Package (sales code RA9), the vehicle harness connector will require relocation of the of A4, F20(BL/LG) and A7, A933 (RD/YL) circuits for radio operation. These two terminals must be swapped in the the connector. Failure to do so will result in the radio prompting the user to enter the security code every time the key is cycled.
Battery Prior to replacing the battery, please check the component to determine if there is any acid leaking from the unit. If the answer is yes, please contact Bruce Davis at Cell (248) 613-5637 for further instructions. If the answer is no, please proceed with the battery replacement.~
Install Intake Air Temperature Sensor Jumper Harness The wiring at the connector of the Intake Air Temperature (IAT) sensor may be compromised due to wire strain. This bulletin involves adding a jumper harness on the IAT sensor to reduce this strain. The customer may not experience any symptom or condition for this service action. Upon further inspection, the technician may find P0113 Intake Air Temperature Sensor 1 Circuit High. Installing the jumper harness will help prevent any IAT issues from occurring.
Intermittent Coolant Loss This bulletin involves inspecting and if necessary, replacing the radiator and thermostat. A small number of customers may experience a slight loss of coolant. There may not be any sign of a leak found under the vehicle.
Battery Prior to replacing the battery, please check the component to determine if there is any acid leaking from the unit. If the answer is yes, please contact Bruce Davis at Cell (248) 613-5637 for further instructions. If the answer is no, please proceed with the battery replacement.~
Radio If this radio is installed in a vehicle equipped with the Radio Prep Package (sales code RA9), the vehicle harness connector will require relocation of the of A4, F20(BL/LG) and A7, A933 (RD/YL) circuits for radio operation. These two terminals must be swapped in the the connector. Failure to do so will result in the radio prompting the user to enter the security code every time the key is cycled.
Install Intake Air Temperature Sensor Jumper Harness The wiring at the connector of the Intake Air Temperature (IAT) sensor may be compromised due to wire strain. This bulletin involves adding a jumper harness on the IAT sensor to reduce this strain. The customer may not experience any symptom or condition for this service action. Upon further inspection, the technician may find P0113 Intake Air Temperature Sensor 1 Circuit High. Installing the jumper harness will help prevent any IAT issues from occurring.
无线空中升级(FOTA)至 U43.17 R1H 软件版本 - 导航稳定性 - Android Auto 与 CarPlay 稳定性及连接性 - 启动动画前显示失真/故障 - 文字显示外观 - 小部件显示错误 - 转向灯盲区响应时间 - 音频中断 - 驾驶模式选择 - 泊车辅助引导线选择 客户可能会遇到以下一项或多项问题:
Flash: Electronic Vehicle Control Unit (EVCU) Updates Customers may experience a Malfunction Indicator Lamp (MIL) illumination and the vehicle may exhibit/set one or more of the following Diagnostic Trouble Codes (DTCs): P061B-00 - Internal Conttrol Module Torque Calculation Performance. P1444-00 - Power Inverter Module - Incorrect Control Mode. P1E18-00 - Internal Control Module Electronic Park Performance. Customers may experience the following: At start up, the vehicle will shut down. At start up, the vehicle will not start This bulletin involves reprogramming the EVCU with the latest available software.
Flash: Electronic Vehicle Control Unit (EVCU) Updates Customers may experience a Malfunction Indicator Lamp (MIL) illumination and the vehicle may exhibit/set one or more of the following Diagnostic Trouble Codes (DTCs): P061B-00 - Internal Control Module Torque Calculation Performance. P1444-00 - Power Inverter Module - Incorrect Control Mode. P1E18-00 - Internal Control Module Electronic Park Performance. Customers may experience the following: At start up, the vehicle will shut down. At start up, the vehicle will not start. This bulletin involves reprogramming the EVCU with the latest available software.
Flash: Electronic Vehicle Control Unit (EVCU) Updates Customers may experience a Malfunction Indicator Lamp (MIL) illumination and the vehicle may exhibit/set one or more of the following Diagnostic Trouble Codes (DTCs): P061B-00 - Internal Control Module Torque Calculation Performance. P1444-00 - Power Inverter Module - Incorrect Control Mode. P1E18-00 - Internal Control Module Electronic Park Performance. Customers may experience the following: At start up, the vehicle will shut down. At start up, the vehicle will not start. This bulletin involves reprogramming the EVCU with the latest available software.
来源:NHTSA(美国,公有领域)、加拿大交通部(加拿大开放政府许可)、DVSA(英国,开放政府许可 v3.0)、RappelConso 与欧盟 Safety Gate(法国,开放许可 2.0)、日本国土交通省(公共数据许可1.0)、韩国国土交通部(car.go.kr)。