Supersedes Technical Service Bulletin Group 87 number 14-56 dated September 12, 2014. The air conditioning does not cool, or the cooling performance is very weak. The air conditioning system cools, but the compressor is noisy. The noise is characterized as a grinding or groaning noise. Either symptom may be intermittent . No DTCs are stored. The condition may be caused by a faulty N280 valve. The internal components of the valve can be obstructed and incapable of full function. This loss of refrigerant regulation from N280 can cause noise from the A/C compressor and/or affect the HVAC cooling. The Denso A/C compressor is currently being installed in production. An improved N280 valve for the Sanden A/C compressor is in development, as the installation of Sanden compressors for production will resume in the future.
NHTSA · نشرة المصنع10119951سنوات الطراز 2015معروض باللغة الأصلية (الإنجليزية) · الترجمة قيد الانتظارعرض التفاصيل →
MIL on. DTCs for the cam actuators are stored in ECM memory. After the activation of the cam actuator to change to the other cam profile, the pin of the actuator is pushed back in by the cam. This is confirmed by a voltage impulse, which is registered by the engine control unit and confirms the operation. If this does not happen, or not at the right time, a DTC "implausible signal" is saved in ECM memory. Check the distance of the pin tip of the cam actuator for valve lift system to the camshaft when it is not operated with a gauge. The measurement of the tip to the basic camshaft circle outside of the groove must be taken. If this measurement is 0.9mm, the actuator 06E103697J must be installed. The actuator 06E103697J must only be used, if the measurement is 0.9mm or bigger.
NHTSA · نشرة المصنع10122800سنوات الطراز 2009معروض باللغة الأصلية (الإنجليزية) · الترجمة قيد الانتظارعرض التفاصيل →
Audi: Engine oil may be leaking from upper engine area. Due to the porosity of the cam carrier casting, oil can drain into the thread of the cam bolt and cause an external engine leak. All bolts are installed with loctite. *pe
NHTSA · نشرة المصنع10030609سنوات الطراز 2009معروض باللغة الأصلية (الإنجليزية) · الترجمة قيد الانتظارعرض التفاصيل →
Under extreme driving conditions (e.g. long idle periods or extended stop and go traffic), high temperatures build up in the rail system and can lead to steam bubbles in the fuel.
NHTSA · نشرة المصنع10228351سنوات الطراز 2013معروض باللغة الأصلية (الإنجليزية) · الترجمة قيد الانتظارعرض التفاصيل →
Under extreme driving conditions (e.g. long idle periods or extended stop and go traffic), high temperatures build up in the rail system and can lead to steam bubbles in the fuel.
NHTSA · نشرة المصنع10225030سنوات الطراز 2013معروض باللغة الأصلية (الإنجليزية) · الترجمة قيد الانتظارعرض التفاصيل →
Under extreme driving conditions (e.g. long idle periods or extended stop and go traffic), high temperatures build up in the rail system and can lead to steam bubbles in the fuel.
NHTSA · نشرة المصنع10222003سنوات الطراز 2013معروض باللغة الأصلية (الإنجليزية) · الترجمة قيد الانتظارعرض التفاصيل →
One or more fuel injectors may be stuck open, allowing fuel to enter the combustion chamber when the engine is hot. Drop in fuel pressure may cause delayed restart of the engine (?long crank?) and/or rough idle after startup.
NHTSA · نشرة المصنع10216624سنوات الطراز 2010معروض باللغة الأصلية (الإنجليزية) · الترجمة قيد الانتظارعرض التفاصيل →
Spark Plugs: replace at 55,000 miles (85,000 km) or 6 years, whichever occurs first. Thereafter, every 60,000 miles (90,000 km) or 6 years, whichever occurs first Added: 2.0L TFSI (Q3) For 35/75/115 Mile Spark Plug interval: Added Q3 to exclusion of Flex Fuel Engines.
NHTSA · نشرة المصنع10130214سنوات الطراز 2015معروض باللغة الأصلية (الإنجليزية) · الترجمة قيد الانتظارعرض التفاصيل →
Supersedes Technical Service Bulletin Group 87 number 15-65 dated July 2, 2015. The air conditioning does not cool, or the cooling performance is very weak. The air conditioning system cools, but the compressor is noisy. The noise is characterized as a grinding or groaning noise. Either symptom may be intermittent. No DTCs are stored. The condition may be caused by a faulty N280 valve (Figure 1). The internal components of the valve can be obstructed and incapable of full function. This loss of refrigerant regulation from N280 can cause noise from the A/C compressor and/or affect the HVAC cooling.
NHTSA · نشرة المصنع10128455سنوات الطراز 2015معروض باللغة الأصلية (الإنجليزية) · الترجمة قيد الانتظارعرض التفاصيل →
Supersedes Technical Service Bulletin Group 87 number 15-61 dated April 23, 2015. The air conditioning does not cool, or the cooling performance is very weak. The air conditioning system cools, but the compressor is noisy. The noise is characterized as a grinding or groaning noise. Either symptom may be intermittent. No DTCs are stored. The condition may be caused by a faulty N280 valve. The internal components of the valve can be obstructed and incapable of full function. This loss of refrigerant regulation from N280 can cause noise from the A/C compressor and/or affect the HVAC cooling.
NHTSA · نشرة المصنع10128477سنوات الطراز 2015معروض باللغة الأصلية (الإنجليزية) · الترجمة قيد الانتظارعرض التفاصيل →
Supersedes Technical Service Bulletin Group 87 number 15-66 dated July 29, 2015. The air conditioning does not cool, or the cooling performance is very weak. The air conditioning system cools, but the compressor is noisy. The noise is characterized as a grinding or groaning noise. Either symptom may be intermittent. No DTCs are stored. The condition may be caused by a faulty N280 valve . The internal components of the valve can be obstructed and incapable of full function. This loss of refrigerant regulation from N280 can cause noise from the A/C compressor and/or affect the HVAC cooling.
NHTSA · نشرة المصنع10128409سنوات الطراز 2015معروض باللغة الأصلية (الإنجليزية) · الترجمة قيد الانتظارعرض التفاصيل →
Supersedes Technical Service Bulletin Group 87 number 15-60 dated March 20, 2015. The air conditioning does not cool, or the cooling performance is very weak and/or The air conditioning system cools, but the compressor is noisy. The noise is characterized as a grinding or groaning noise. Either symptom may be intermittent. No DTCs are stored. The condition may be caused by a faulty N280 valve. The internal components of the valve can be obstructed and incapable of full function. This loss of refrigerant regulation from N280 can cause noise from the A/C compressor and/or affect the HVAC cooling.
NHTSA · نشرة المصنع10120000سنوات الطراز 2015معروض باللغة الأصلية (الإنجليزية) · الترجمة قيد الانتظارعرض التفاصيل →
The Q3 Introduction/2015 New Technologies instructor led class for technicians (990242) will be available at all of the Audi Learning Centers starting on July 17. The course is designed to introduce technicians to the allnew Q3, the new 2.0L Third Generation TDI Engine and the 2015 A3 Cabriolet. For technicians not attending the instructor led class, we recommend they complete our comprehensive virtual launch WBT 990344 and complete the assessment on the Certification Resource Center (CRC).
NHTSA · نشرة المصنع10243996سنوات الطراز 2015معروض باللغة الأصلية (الإنجليزية) · الترجمة قيد الانتظارعرض التفاصيل →
Part quantity updated on SAGA sheet. The Owner?s Manual in certain 2013 model year Audi vehicles was printed with incorrect numerical callouts in the engine compartment overview artwork. This could cause confusion for anyone who relies on this information in order to identify key components within the engine compartment.
NHTSA · نشرة المصنع10124917سنوات الطراز 2013معروض باللغة الأصلية (الإنجليزية) · الترجمة قيد الانتظارعرض التفاصيل →
The Owner?s Manual in certain 2013 model year Audi vehicles was printed with incorrect numerical callouts in the engine compartment overview artwork. This could cause confusion for anyone who relies on this information in order to identify key components within the engine compartment.
NHTSA · نشرة المصنع10124916سنوات الطراز 2013معروض باللغة الأصلية (الإنجليزية) · الترجمة قيد الانتظارعرض التفاصيل →
Audi: See document search button for owner letter. Warranty extension for emissions control systems warranty for fuel injector replacement, has been issued, under specific conditions, 10 years or 120,000 miles, whichever first occurs. Model 2011. *pe
NHTSA · نشرة المصنع10056163سنوات الطراز 2011معروض باللغة الأصلية (الإنجليزية) · الترجمة قيد الانتظارعرض التفاصيل →
Audi: High temperatures can build up in rail system, under extreme driving conditions, and lead to fluctuations in fuel pressure and possible lose of power.. Model 2013 a4, a5, a6, allroad, q5. *pe
NHTSA · نشرة المصنع10051888سنوات الطراز 2013معروض باللغة الأصلية (الإنجليزية) · الترجمة قيد الانتظارعرض التفاصيل →
Audi: Customer may report mil on and loss of performance under extreme driving conditions (e.G. Long idle periods or extended stop and go traffic), high temperatures build up in the rail system and can lead to steam bubbles in the fuel. Also included models allroad and a5 cab. Model year 2013. *js updated 04/12/2013 *js
NHTSA · نشرة المصنع10051832سنوات الطراز 2013معروض باللغة الأصلية (الإنجليزية) · الترجمة قيد الانتظارعرض التفاصيل →
Audi: Excessive wear from linkage for waste gate actuation, leads to play at the waste gate flap causing boost escaping through loose flap of turbocharger. Models 2009-2010 a4, a5, a5 cab. *pe updated 04/15/2013 *js
NHTSA · نشرة المصنع10047679سنوات الطراز 2010معروض باللغة الأصلية (الإنجليزية) · الترجمة قيد الانتظارعرض التفاصيل →
المصادر: NHTSA (الولايات المتحدة، ملك عام)، وزارة النقل الكندية (رخصة الحكومة المفتوحة – كندا)، DVSA (المملكة المتحدة، رخصة الحكومة المفتوحة 3.0)، RappelConso وSafety Gate الأوروبي (فرنسا، الرخصة المفتوحة 2.0)، ووزارة MLIT اليابانية (رخصة البيانات العامة 1.0)، ووزارة MOLIT الكورية (car.go.kr).