قراءة مجانية · حساب مجاني للمساهمةخليفة Anticars (2000)

BMW الفئة الثالثة E30

1982–1994 · 15 أعطال موثّقة · 4 أسواق
سنة الطراز
السوقالكلNAUK
استدعاءحرجالمحركNA

Fuel System

On certain 318I, 318IC, 318IS, 325IC, 325IS, 325IX, 525I, 535I, 735I and 735IL vehicles, the fuel feed hose could harden and "set" over time due to engine compartment temperatures. If this "setting" occurs, it is possible that seepage between the hose and fitting could result because the clamp cannot provide sufficient sealing force to compensate for the hardening of the hose. Fuel seepage, in the presence of an ignition source, could result in an engine compartment fire. Correction: fuel feed hoses and associated clamps will be replaced with ones of a new design.

وزارة النقل الكندية30 مايو 19941994096سنوات الطراز 1989معروض باللغة الأصلية (الإنجليزية) · الترجمة قيد الانتظارعرض التفاصيل →
استدعاءحرجالمحركNA

Fuel system, gasoline:Delivery:Hoses, lines/piping, and fittings

Feed fuel hoses can harden and "set" over time, allowing a seepage of fuel at the connection between the hose and the engine fitting. The clamp used to hold the hose to the fitting is unable to compensate for the hardening of the feed fuel hose.

NHTSA · الولايات المتحدة11 أبريل 199494V066000سنوات الطراز 1989معروض باللغة الأصلية (الإنجليزية) · الترجمة قيد الانتظارعرض التفاصيل →
استدعاءحرجالمحركNA

Visibility:Defroster/defogger/hvac system:Heater core

The malfunction or failure of a coolant system component results in significantly increased coolant temperature and a resulting increase in system pressure.

NHTSA · الولايات المتحدة1 فبراير 199393V015000سنوات الطراز 1984–1989معروض باللغة الأصلية (الإنجليزية) · الترجمة قيد الانتظارعرض التفاصيل →
استدعاءحرجالكهرباءNA

Heater And Defroster

On certain 318I vehicles, under certain conditions, the interior heater water control valve may bind while closing. This binding or slow-closing condition may cause the valve solenoid to draw excessive current, possibly resulting in overheating of the valve connector wiring and insulation. This condition could result in a passenger compartment fire.

وزارة النقل الكندية24 سبتمبر 19841984105سنوات الطراز 1984معروض باللغة الأصلية (الإنجليزية) · الترجمة قيد الانتظارعرض التفاصيل →
استدعاءمتوسطالمحركNA

Heater And Defroster

On certain 318I, 325I and M3 vehicles, elevated pressure in the cooling system due to overheating could result in cracking of the heater core end piece. Should this happen, coolant could be expelled onto the lower right leg of the driver, possibly resulting in personal injury and/or fogging of the interior surfaces of the windows causing reduced driver vision. Correction: A thermistatic bypass valve will be installed to control coolant temperature in the heater core. Also, a new design radiator cap will be installed to control pressure and provide greater overflow.

وزارة النقل الكندية19 يوليو 19931993100سنوات الطراز 1984–1989معروض باللغة الأصلية (الإنجليزية) · الترجمة قيد الانتظارعرض التفاصيل →
استدعاءمتوسطالمحركNA

Engine

On certain 325IX vehicles, the oil dipstick tube attaching bracket may have been bent during the manufacturing process or during scheduled maintenance. This could possibly cause the dipstick to interfere with the throttle bellcrank lever's range of motion and prevent the lever from returning to the idle position after release of the accelerator pedal. Correction: Throttle bellcrank lever will be modified to provide sufficient clearance. Note: Vehicles with manual transmission only.

وزارة النقل الكندية6 أبريل 19881988049سنوات الطراز 1988معروض باللغة الأصلية (الإنجليزية) · الترجمة قيد الانتظارعرض التفاصيل →
استدعاءمتوسطالمحركNA

Vehicle speed control:Cables

The oil dipstick tube attaching bracket may have been bent during production or scheduled maintenance, reducing the clearance between the dipstick ring and the throttle bellcrank lever.

NHTSA · الولايات المتحدة15 مارس 198888V031000سنوات الطراز 1988معروض باللغة الأصلية (الإنجليزية) · الترجمة قيد الانتظارعرض التفاصيل →
استدعاءمتوسطالكهرباءNA

Electrical → كهربائي

على بعض المركبات من طرازات 325E و325ES و528E و535I و635CSI و735I، قد تُضيف الإضاءة الفرامل المركزية المرتفعة المثبتة في الجزء العلوي حمولة كهربائية كافية لتسبب ارتفاع حرارة مفتاح ضوء الفرامل، مما قد يؤدي في النهاية إلى ذوبان الأجزاء البلاستيكية الداخلية للمفتاح. وقد يتسبب ذلك في علوق المكبس الداخلي للمفتاح في وضع التشغيل أو وضع الإيقاف. ويؤدي ذلك إلى بقاء ضوء الفرامل مضاءً بشكل دائم أو مُطفأً بشكل دائم، بغض النظر عن الضغط على دواسة الفرامل. التصحيح: سيتم تركيب مفتاح ضوء فرامل ذو سعة تحمل تيار أعلى على المركبات المتأثرة.

وزارة النقل الكندية27 نوفمبر 19861986134سنوات الطراز 1986–1987ترجمة آلية · اللغة الأصلية: الإنجليزيةعرض التفاصيل →
استدعاءمتوسطالفراملNA

الإضاءة الخارجية:أضواء الفرامل:المفتاح

مفتاح ضوء الفرامل قد يسخن بشكل زائد، ما قد يؤدي في النهاية إلى ذوبان الأجزاء البلاستيكية الداخلية في منطقة نقاط التلامس الكهربائية.

NHTSA · الولايات المتحدة10 نوفمبر 198686V151000سنوات الطراز 1986–1987ترجمة آلية · اللغة الأصلية: الإنجليزيةعرض التفاصيل →
استدعاءمتوسطالتعليقNA

Steering

On certain 318I, 325, 325E and 325ES vehicles, when a significant force is applied directly to the steering gearbox as the result of certain frontal crash conditions or front end contact with an object on the road, the steering column disengagement element, which is designed to reduce the amount of steering wheel rearward travel, could disengage completely. This would result in loss of post impact steering maneuverability without prior warning. Correction: Two plates will be bolted to the disengagement element to ensure that the element will not completely disengage in the event of an impact to the steering gear.

وزارة النقل الكندية22 أكتوبر 19861986117سنوات الطراز 1984–1986معروض باللغة الأصلية (الإنجليزية) · الترجمة قيد الانتظارعرض التفاصيل →
استدعاءمتوسطالتعليقNA

Steering: Steering wheel/handle bar

The two parts of the steering column disengagement element could completely disconnect if the car contacts an object in the roadway or elsewhere of sufficient mass to apply a significant force directly to the steering gearbox. Consequence of defect: Steering control would be lost.

NHTSA · الولايات المتحدة20 أكتوبر 198686V138000سنوات الطراز 1985–1986معروض باللغة الأصلية (الإنجليزية) · الترجمة قيد الانتظارعرض التفاصيل →
استدعاءمتوسطالمحركNA

Fuel system, gasoline:Carburetor system

The idle control valve which controls idle speed by varying the amount of intake air that bypasses the throttle plate is subject to backfire into the intake manifold. Such backfire can damage the valve and cause the idle valve plate to remain open. Consequence of defect: This will result in abnormally high idle speed.

NHTSA · الولايات المتحدة6 مايو 198585V058000سنوات الطراز 1984معروض باللغة الأصلية (الإنجليزية) · الترجمة قيد الانتظارعرض التفاصيل →
استدعاءمتوسطالهيكلNA

Visibility:Defroster/defogger/hvac system:Windshield:Electrical heating element

Water control valve in the heating system may not close completely. Excessive current may begin to flow through the wiring to the control valve resulting in overheating of the wiring.

NHTSA · الولايات المتحدة11 سبتمبر 198484V107000سنوات الطراز 1984معروض باللغة الأصلية (الإنجليزية) · الترجمة قيد الانتظارعرض التفاصيل →
استدعاءمتوسطالمحركNA

Engine

On certain 320I vehicles, crack in the exhaust system between the exhaust pipe and the catalytic converter could result in exhaust emissions which do not comply with CMVSS 1103.

وزارة النقل الكندية22 ديسمبر 19831983121سنوات الطراز 1981–1982معروض باللغة الأصلية (الإنجليزية) · الترجمة قيد الانتظارعرض التفاصيل →
استدعاءطفيفالمحركNA

Engine

On certain 318I vehicles, improper starting procedure could cause a backfire into the intake manifold and damage internal components of the idle control valve. This could result in abnormally high idle speed and if warnings of increased engine noise level and tachometer reading are not heeded, a vehicle crash could occur.

وزارة النقل الكندية6 يونيو 19851985072سنوات الطراز 1984معروض باللغة الأصلية (الإنجليزية) · الترجمة قيد الانتظارعرض التفاصيل →

المصادر: NHTSA (الولايات المتحدة، ملك عام)، وزارة النقل الكندية (رخصة الحكومة المفتوحة – كندا)، DVSA (المملكة المتحدة، رخصة الحكومة المفتوحة 3.0)، RappelConso وSafety Gate الأوروبي (فرنسا، الرخصة المفتوحة 2.0)، ووزارة MLIT اليابانية (رخصة البيانات العامة 1.0)، ووزارة MOLIT الكورية (car.go.kr).